Skip to main content
SpringerLink
Log in

Effect of Force Frequency Increase on Depth of Cut

  • Research Article
  • Published:
Journal of The Institution of Engineers (India): Series C Aims and scope Submit manuscript

Abstract

In this paper, the study is perform to check the dynamic behavior of metal cutting by using two expressions, given by two different researchers. Kronenberg performed various experiments and established a relation to find the frequency of vibration during metal cutting. Afterwards Singh performed his work on elastic deformation during metal cutting and analytically derived an expression for determining frequency of vibration during metal cutting. In the present study, turning operation is performed on mild steel at various cutting speeds, feeds and depth of cuts. Chips are collected and analyzed and hence frequency of vibration during cutting is calculated by the expressions given by Kronenberg and Singh. Experimental results and analytical results were compared and both were having good correlation.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7

Similar content being viewed by others

References

  1. M.K. Das, S.A. Tobias, The relation between the static and the dynamic cutting of metals. Int. J. Mach. Tool Des. Res. 7, 63–89 (1967)

    Article  Google Scholar 

  2. M. Wiercigroch, E. Budak, Sources of non linearities, chatter generation and suppression in metal cutting. Philos. Trans. R. Soc. Lond. 359, 663–693 (2001)

    Article  MATH  Google Scholar 

  3. V.P. Astakhov, S. Shvets, The assessment of plastic deformation in metal cutting. J. Mater. Process. Technol. 146(2), 193–202 (2004)

    Article  Google Scholar 

  4. M.M. Nigm, M.M. Sadek, S.A. Tobias, determination of dynamic cutting coefficients from steady state cutting data. Int. J Mach. Tool Des. Res. 17, 19–37 (1977)

    Article  Google Scholar 

  5. M.C. Shaw, Metal cutting principles, (1992)

  6. Huber, Mises, Hencky, equivalent stress: a surface failure indicator, vol. 1 (World Tribology Congress III, 2005), pp. 115–116

  7. M. Kronenberg, Machining science and application (1966)

  8. J. Singh, An investigation on lathe chatter Ph. D Thesis, Mechanical department IT-BHU Varanasi,(1973)

Download references

Author information

Authors and Affiliations

  1. Department of Mechanical Engineering, IT BHU, Varanasi, 221005, India

    S. P. Tewari (Fellow) & Nitin Rathod (Non-member)

Authors
  1. S. P. Tewari
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Nitin Rathod
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to S. P. Tewari.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Tewari, S.P., Rathod, N. Effect of Force Frequency Increase on Depth of Cut. J. Inst. Eng. India Ser. C 93, 47–53 (2012). https://doi.org/10.1007/s40032-011-0009-6

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s40032-011-0009-6

Keywords

Search

Navigation