Abstract
When leg and level of an inverter are increased, the number of switching states increases cumulatively. When the switching table-based DTC with higher phase (leg) and level is implemented for multiphase induction motor, the switching table becomes more accurate for different types of loading. Here, a 5-phase induction motor is simulated in MATLAB/Simulink from its dynamic mathematical equations. The switching table based direct torque control (ST-DTC) has been implemented to the simulated model through a 5-leg 3-level inverter. A performance study for ST-DTC has been carried out among 5-phase induction motor using 2-level (FPIM 2-L) inverter, 5-phase induction motor using 3-level (FPIM 3-L) inverter and 3-phase induction motor with 3-level (TPIM 3-L) inverter, and results are compared. In FPIM 3-L inverter, out of 243 switching states 20 active switching vectors are chosen for preparation of switching table, whereas in TPIM 3-L inverter, out of 27 switching states 12 switching vectors are chosen. In FPIM 2-L inverter, ten are chosen out of 32 switching states for DTC application. As the active states are increased, the numbers of sectors are also increased for FPIM 3-L inverter. With FPIM 3-L inverter, there is an improvement in settling time during step fall. The torque ripple in case of FPIM 3-L inverter is reduced by 4.18% with respect to FPIM 2-L and 2.7% with respect to TPIM 3-L inverter. However, the torque response during start is slightly sluggish in case of FPIM 3-L inverter as compared to TPIM 3-L inverter.
Similar content being viewed by others
References
J. Rodriguez, J.-S. Lai, F.Z. Peng, Multilevel inverters: a survey of topologies, controls and applications. IEEE Trans. Ind. Electron. 49(4), 724–738 (2002)
S. Kouro, M. Malinowski, K. Gopakumar, J. Pou, L.G. Franquelo, B. Wu et al., Recent advances and industrial applications of multilevel converters. IEEE Trans. Ind. Electron. 57(8), 2553–2580 (2010)
S. Padmanaban, G. Grandi, Multiphase-Multilevel Inverter for Open-Winding Loads (LAP LAMBERT Academic Publishing, Riga, 2012)
E. Levi, R. Bojoi, F. Profumo, H.A. Toliyat, S. Williamson, Multiphase induction motor drives—a technology status review. IET Electr. Power Appl. 1(4), 489–516 (2007)
L. Zheng, J.E. Fletcher, B.W. Williams, X. He, Dual-plane vector control of a five-phase induction machine for an improved flux pattern. IEEE Trans. Ind. Electron. 55(5), 1996–2005 (2008)
L. Zheng, J.E. Fletcher, B.W. Williams, X. He, A novel direct torque control scheme for a sensorless five phase induction motor drive. IEEE Trans. Ind. Electron. 58(2), 503–513 (2011)
U. Mahanta, D. Patnaik, B.P. Panigrahi, A.K. Panda, Dynamic modeling and simulation of switching table based DTC of five phase induction motor, in IEEE International Conference on EESCO, 2015
C. Martin, X. Roboam, T. Meynard, Switching frequency imposition and ripple reduction in DTC drives by using a multilevel converter. IEEE Trans. Power Electron. 17(2), 286–297 (2002)
K.-B. Lee, J.-H. Song, I. Choy, J.-Y. Yoo, Torque ripple reduction in DTC of induction motor driven by three-level inverter with low switching frequency. IEEE Trans. Power Electron. 17(2), 255–264 (2002)
Y. Zhang, J. Zhu, Z. Zhao, W. Xu, D.G. Dorrell, An improved direct torque control for three-level inverter-fed induction motor sensorless drive. IEEE Trans. Power Electron. 27(3), 1502–1513 (2012)
E. Levi, M. Jones, S.N. Vukosavic, H.A. Toliyat, A five-phase two-machine vector controlled induction motor drive supplied from a single inverter. EPE J. 14(3), 38–48 (2004)
L. Aarniovuori, L.I.E. Laurila, M. Niemela, J.J. Pyrhonen, Measurements and simulations of DTC voltage source converter and induction motor losses. IEEE Trans. Ind. Electron. 59(5), 2277–2287 (2012)
B. Kirankumar, Y.V. Siva Reddy, M. Vijayakumar, Multilevel inverter with space vector modulation: intelligence direct torque control of induction motor. IET Power Electron. 10(10), 1129–1137 (2017)
U. Mahanta, D. Patnaik, B.P. Panigrahi, A.K. Panda, Dynamic modeling and simulation of SVM-DTC of five phase induction motor, in IEEE International Conference on ICEPE, 2015
G. Brando, A. Dannier, A.D. Pizzo, R. Rizzo, I. Spina, Generalised look-up table concept for direct torque control in induction drives with multilevel inverters. IET Power Electron. 9(8), 556–567 (2015)
J.K. Pandit, Mohan V. Aware, R.V. Nemade, E. Levi, Direct torque control scheme for a six-phase induction motor with reduced torque ripple. IEEE Trans. Power Electron. 32(9), 7118–7129 (2017)
E. Levi, Multiphase electric machines for variable speed applications. IEEE Trans. Ind. Electron. 55(5), 1893–1909 (2008)
B.P. Panigrahi, D. Prasad, S. Sengupta, A simple hardware realisation of switching table based direct torque control of induction motor. Electr. Power Syst. Res. 77, 181–190 (2007)
D. Prasad, B.P. Panigrahi, S. Sengupta, Digital simulation and hardware implementation of a simple scheme for direct torque control of an induction motor. Energy Convers. Manag. 49(4), 687–697 (2008)
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Mahanta, U., Panigrahi, B.P. & Panda, A.K. Performance Analysis of Switching Table Based DTC for 5-Phase Induction Motor with 3-Level Inverter. J. Inst. Eng. India Ser. B 100, 599–607 (2019). https://doi.org/10.1007/s40031-019-00415-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40031-019-00415-x