Skip to main content
Log in

Removal of colour and lignin from paper mill wastewater using activated carbon from plastic mix waste

  • Original Paper
  • Published:
International Journal of Environmental Science and Technology Aims and scope Submit manuscript

Abstract

The study aimed at the use of char produced during pyrolysis of mix plastic waste. It further focused on producing activated carbon from char and also found its efficacy as efficient adsorbent for treatment of pulp and paper mill wastewater. The activated carbon was characterized in comparison with raw char for their physical, surface and adsorptive properties. Batch type adsorption experiments were carried out using 100 ml wastewater to observe the individual effectiveness using five different variables such as adsorbent dose (0.25–2.0 g), pH (6–10), time (5–24 h), agitation speed (100–200 rpm) and temperature (30–50 °C) by keeping other variables constant which helped to find out the effective range of all the variables. The competency was evaluated on the basis of colour and lignin content of pulp and paper industry wastewater. Once the effective range of different variables was identified, the statistical analysis was conducted to monitor the mutual impact on the reduction in colour and lignin contents in wastewater. From the statistical design applied, the best result was obtained at activated carbon dose (1.25 g), pH (8.0), contact time (7 h), agitation speed (184 rpm) and temperature (40 °C). The study resulted in reduction of 96.48% in colour and 94.25% in lignin at optimized condition in comparison with 87.37 and 80.44%, respectively, at unoptimized conditions. A potential increase in reduction of 9.0% in colour and 14.0% in lignin content was achieved after optimization through statistical design that confirmed its usefulness.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig.1
Fig. 2
Fig. 3
Fig.4
Fig. 5
Fig. 6

Similar content being viewed by others

References

Download references

Acknowledgement

The authors are grateful to Ex-Director, Avantha Centre for Industrial Research and Development, Yamuna Nagar, Haryana, India, for granting all the fundamental facilities to complete this entire work and consistent support and assistance during work.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to N. K. Bhardwaj.

Ethics declarations

Conflict of interest

No potential conflict of interest was reported by the authors.

Additional information

Editorial Responsibiility: Samareh Mirkia.

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Gupta, V., Bhardwaj, N.K. & Rawal, R.K. Removal of colour and lignin from paper mill wastewater using activated carbon from plastic mix waste. Int. J. Environ. Sci. Technol. 19, 2641–2658 (2022). https://doi.org/10.1007/s13762-021-03263-9

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s13762-021-03263-9

Keywords

Navigation