Skip to main content
Log in

3D printer as a potential source of indoor air pollution

  • Original Paper
  • Published:
International Journal of Environmental Science and Technology Aims and scope Submit manuscript


3D printing has been gaining popularity in the past few years for both personal and professional uses. However, recent results showed that desktop 3D printers emit particles and compounds, which have negative health effects. In this study, the emission from commercially available 3D printing polymers was evaluated. Volatile organic compounds (VOC) emission was studied by using commercial printer placed in gas tight chamber, but also in a very universal test, which simulates the condition in fused filament fabrication 3D printers and in the same time allows for comparison of various filaments without the impact of the 3D printer itself (ex vivo approach). VOC emission can be associated with thermal degradation of polymers as well as degradation of additives such as plasticizers, dyes or flame retardants, as confirmed by detailed FTIR analysis of filaments. The obtained results highlight the problem of emissions of harmful compounds, and the proposed testing methods can be a clue for plastic filament producers on how to test their products and make them safer.

Graphic abstract

This is a preview of subscription content, log in via an institution to check access.

Access this article

Subscribe and save

Springer+ Basic
EUR 32.99 /Month
  • Get 10 units per month
  • Download Article/Chapter or Ebook
  • 1 Unit = 1 Article or 1 Chapter
  • Cancel anytime
Subscribe now

Buy Now

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10

Similar content being viewed by others


Download references


The research was co-financed by the European Union from the Regional Operational Program of the Lesser Poland Voivodeship for the years 2014–2020, Priority axis 1 Knowledge economy, Activity 1.2. Research innovations in enterprises, Sub-activity 1.2.1. Research and development projects of enterprises: “Photocatalytic air filtration system for limiting the emission of pollutants generated during 3D printing.” (Grant No. RPMP.01.02.01-12-0509/16-00).

Author information

Authors and Affiliations


Corresponding author

Correspondence to T. Baran.

Ethics declarations

Conflict of interest

The authors declare that there is no conflict of interest regarding the publication of this article.

Additional information

Editorial responsibility: M. Abbaspour.

Electronic supplementary material

Below is the link to the electronic supplementary material.

Supplementary material 1 (DOCX 438 kb)

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Wojtyła, S., Klama, P., Śpiewak, K. et al. 3D printer as a potential source of indoor air pollution. Int. J. Environ. Sci. Technol. 17, 207–218 (2020).

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: