Abstract
The aim of this study was to compare the rheological behavior of branched polypropylene and linear PP by reactive extrusion process. Samples were modified in the presence of a peroxide initiator, i.e., 2,5-dimethyl-2,5(tert-butyl peroxy) hexane which was dispersed at 45 wt% in \({\text{CaCo}}_{3}\) (DHBP45), multi-functional monomer trimethylol propane triacrylate (TMPTA) as a graft monomer, and co-agent tetraethyl thiuram disulfide (TETDS) as a co-reactant, in an internal mixer. Rheological measurements and thermal analysis were used to characterize the structure of the modified PP samples. Using PP powder instead of PP granule, it was concluded that the elastic response of branched PP at low frequency was enhanced in comparison with linear PP. Rheological properties, such as increasing the G′ at low frequency, plateau in tanδ–ω plot, deviating from linear PP in Han plot and upturning at high viscosity in Cole–Cole plot, promoted the branching in PP backbone. Moreover, the results showed that by decreasing the amount of initiator, the chain scission can be controlled. TETDS could efficiently control side reactions, decrease the concentration of active free radicals simultaneously in system and improve the branching. When the quantity of TETDS decreased from moderate quantity, the functionality remained unchanged and failed to improve the branching.
Similar content being viewed by others
References
Zhang Z, Wan D, Xing H, Zhang Z, Wang L, Zheng J, An Y, Tang T (2012) A new grafting monomer for synthesizing long chain branched polypropylene through melt radical reaction. Polymer 53:121–129
Lagendijk RP, Hogt AH, Gotsis AD (2001) Peroxydicarbonate modification of polypropylene and extensional flow properties. Polymer 42:10035–10043
Borsig E, Van Duin M, Gotsis AD, Picchioni F (2008) Long chain branching on linear polypropylene by solid state reaction. Eur Polym J 44:200–212
Mousavi SA, Frounchi M, Dadbin S, Augier S, Passaglia E, Ciardelli F (2007) Modification of isotactic polypropylene by free-radical grafting of 1,1,1-trimethylol propane trimetacrylate. J Appl Polym Sci 104:950–958
Auhl D, Stange J, Munstedt H (2004) Long-chain branched polypropylene by electron beam irradiation and their rheological properties. Macromolecules 37:9465–9472
Cheng S, Phillips ED, Parks L (2010) Processability improvement of polyolefins through radiation-induced branching. Radiat Phys Chem 79:329–334
Weng W, Hu W, Dekmezian A, Ruff CJ (2002) Long chain branched isotactic polypropylene. Macromolecules 35:3838–3843
Xing H, Jiang Z, Zhang Z, Qiua J, Wanga Y, Maa L, Tanga T (2012) Effect of leaving group in dithiocarbamates on mediating melt radical reaction during preparing long chain branched polypropylene. Polym J 53:947–955
Langston J, Colby R, Chung TC (2007) Synthesis and characterization of long chain branched isotactic polypropylene via metallocene catalyst and t-reagent. Macromolecules 40:2712–2720
Scott Parent J, Bodsworth A, Sengupta S, Kontopoulou M, Chaudhary B, Poche D, Cousteaux S (2009) Structure-rheology relationships of long-chain branched polypropylene: comparative analysis of acrylic and allylic coagent chemistry. Polymer 50:85–94
Lu B, Chung TC (1999) Synthesis of long chain branched polypropylene with relatively well-defined molecular structure. Macromoleculase 32:8678–8680
Pivokonsky R, Zatloukal M, Filip P, Tzoganakis C (2009) Rheological characterization and modeling of linear and branched metallocene polypropylene prepared by reactive processing. J Non-Newtonian Fluid Mech 156:1–6
Zhang Z, Wan D, An Y, Liu F, Xing H, Wang L, Jiang Z (2011) Controlling the evolution of polypropylene microstructure during melt free radical modification using zinc dithiocarbamate with different N-substituted. Polym Degrad Stabil 96:653–659
Serena C, Augier S, Pinzino C, Passaglia E (2010) Control of degradation of polypropylene during its radical functionalisation with furan and thiophene derivatives. Polym Degrad Stabil 95:298–305
Mousavi SA, Dadbin S, Frounchi M, Venerus DC, Medina TG (2010) Comparison of rheological behavior of branched polypropylene prepared by chemical modification and electron beam irradiation under air and N2. Radiat Phys Chem 79:1088–1094
Mabrouk EL, Scott K, Parent J, Chaudhary BI (2009) Chemical modification of pp architecture: strategies for introducing long-chain branching. Polymer 50:5390–5397
Graebling D (2002) Synthesis of branched polypropylene by a reactive extrusion process. Macromolecules 35:4602–4610
Zhang Z, Xing H, Qiu J, Jiang Z, Yu H, Du X, Wang Y, Ma L, Tang T (2010) Controlling melt reactions during preparing long chain branched polypropylene using copper N,N-dimethyldithiocarbamate. Polymer 51:1593–1598
Tian J, Yu W, Zhou C (2006) The preparation and rheology characterization of long chain branching polypropylene. Polymer 47:7962–7969
Lugao AB, Artel BWH, Yoshiga A, Lima LFCP, Parra DF, Bueno JR, Liberman S, Farrah M, Tercariol WR, Otaguro H (2007) Production of high melt strength polypropylene by gamma irradiation. Radiat Phys Chem 76:1691–1695
Li S, Xiao M, Wei D, Xiao H, Hu F, Zheng A (2009) The melt grafting preparation and rheological characterization of long chain branching polypropylene. Polymer 50:6121–6128
Breuer G, Schausberger A (2011) Recovery of shear modification of polypropylene melts. Rheol Acta 50:461–468
Zhao W, Wu G, Yang Q (2012) Controlling the transition of long-and short-chain branching polypropylene. Polym Plast Technol Eng 51:716–723
Tian J, Yu W, Zhou C (2006) Crystallization kinetics of linear and long-chain branched polypropylene. J Macromol Sci Phys 45:969–985
Zhao W, Huang Y, Liao X, Yang Q (2013) The molecular structure characteristics of long chain branched polypropylene and its effects on non-isothermal crystallization and mechanical properties. Polymer 54:1455–1462
Razavi Nouri M (2006) Effect of annealing and pressure on structure and melting of a polypropylene random copolymer. Iran Polym J 15:121–126
Jahani Y, Barikani M (2005) Effect of side chain branched PP, EPDM and HDPE as a third component on melt extensional behaviour of ternary blends. Iran Polym J 14:693–704
Azizi H, Ghasemi I (2005) Investigation on influence of peroxide degradation process on rheological properties of polypropylene. Iran Polym J 14:465–471
Acknowledgments
The kind assistance of Tarbiat Modares University is greatly acknowledged.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Mohebbi, K., Ebrahimi, N.G. Preparation and rheology characterization of branched polypropylene during reactive extrusion process. Iran Polym J 24, 309–316 (2015). https://doi.org/10.1007/s13726-015-0323-6
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13726-015-0323-6