Skip to main content

Advertisement

Log in

Study on Basic Properties of Alkali‒Surfactant‒Polymer Flooding Water and Influence of Oil-Displacing Agent on Oil–Water Settlement

  • Research Article-Chemistry
  • Published:
Arabian Journal for Science and Engineering Aims and scope Submit manuscript

Abstract

The basic properties of alkali–surfactant–polymer (ASP) flooding produced water and effect of oil displacing agent on the stability of flooding produced water were obtained by measuring and analyzing the water quality of Zhong-106, etc., flooding water from Daqing Oilfield and the relationship between oil content-settling time and oil displacing agent-oil drop size. The addition of ternary oil displacement agent to ASP flooding water greatly increases the difficulty of oil–water separation, higher concentration, and worse separation effect after standing. Surfactant alkali and polymer have effect of promoting the reduction of oil droplet size distribution and are all affected by the initial oil content and pH. When pH is between 10.5 and 11.75, the average particle size of oil drop in ASP produced water changes the most significantly, and as the alkali content increases, the pH of the produced water rises faster. Alkali reacts with the active substances contained in the crude oil in the produced water, such as organic acids, thereby increasing the pH of the produced water. The pH of the produced water changes smoothly when alkali content is 5000 mg/L, but all are less than alkaline flooding water, which shows that alkali can promote the partial hydrolysis of polymer in the produced water and the process can reach equilibrium. The ASP flooding produced water after 48 h of settling formed a trace amount of nano-oil droplets, also accompanied by the accumulation and separation of a part of the oil droplets.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9

Similar content being viewed by others

References

  1. Huang, B.; Hu, X.: Experimental evaluation of ASP flooding to improve oil recovery in heterogeneous reservoirs by layered injection approach. Energy Sci. Eng. 8, 3148–3164 (2020). https://doi.org/10.1002/ese3.735

    Article  Google Scholar 

  2. Moreno, L.; Babadagli, T.: Multilayer organic deposition on the rock surface with different wettabilities during solvent injection for heavy-oil recovery. Can. J. Chem. Eng. 93, 664–677 (2015). https://doi.org/10.1002/cjce.22165

    Article  Google Scholar 

  3. Hosseini-Nasab, S.M.; Padalkar, C.; Battistutta, E.; Zitha, P.L.Z.: Mechanistic modeling of the alkaline/surfactant/polymer flooding process under sub-optimum salinity conditions for enhanced oil recovery. Ind. Eng. Chem. Res. 55, 6875–6888 (2016). https://doi.org/10.1021/acs.iecr.6b01094

    Article  Google Scholar 

  4. Wang, Z.H.; Yu, T.Y.; Lin, X.Y.; Wang, X.W.; Su, L.S.: Chemicals loss and the effect on formation damage in reservoirs with ASP flooding enhanced oil recovery. J. Nat. Gas Sci. Eng. 33, 1381–1389 (2016). https://doi.org/10.1016/j.jngse.2016.06.048

    Article  Google Scholar 

  5. Zhapbasbayev, U.K.; Kudaibergenov, S.E.; Mankhanova, A.E.; Sadykov, R.M.: Experimental study of alkaline-surfactant-polymer compositions for ASP-flooding of cores from highly viscous oil reservoirs. Thermophys. Aeromech. 25, 909–916 (2018). https://doi.org/10.1134/S0869864318060112

    Article  Google Scholar 

  6. Samamta, A.; Bera, A.; Ojha, K.; Mandal, A.: Comparative studies on enhanced oil recovery by alkali–surfactant and polymer flooding. J. Petrol. Explor. Prod. Technol. 2, 67–74 (2012). https://doi.org/10.1007/s13202-012-0021-2

    Article  Google Scholar 

  7. Azamifard, A.; Bashiri, G.; Gerami, S.; Hemmati-Sarapardeh, A.: On the evaluation of alkaline–surfactant–polymer flooding in a field scale: screening, modelling, and optimization. Can. J. Chem. Eng. 95, 1615–1625 (2017). https://doi.org/10.1002/cjce.22834

    Article  Google Scholar 

  8. Wang, Z.H.; Xu, Y.F.; Liu, Y.; Liu, X.Y.; Rui, Z.H.: Molecular dynamics-based simulation on chemical flooding produced emulsion formation and stabilization: a critical review. Arab. J. Sci. Eng. 45, 7161–7173 (2020). https://doi.org/10.1007/s13369-020-04840-9

    Article  Google Scholar 

  9. Khan, J.A.; Al-Kayiem, H.H.; Aleem, W.; Saad, A.B.: Influence of alkali–surfactant–polymer flooding on the coalescence and sedimentation of oil/water emulsion in gravity separation. J. Petrol. Sci. Eng. 173, 640–649 (2019). https://doi.org/10.1016/j.petrol.2018.10.055

    Article  Google Scholar 

  10. Liu, Z.Y.; Li, Y.Q.; Luan, H.X.; Gao, W.B.; Guo, Y.; Chen, Y.H.: Pore scale and macroscopic visual displacement of oil-in-water emulsions for enhanced oil recovery. Chem. Eng. Sci. 197, 404–414 (2019). https://doi.org/10.1016/j.ces.2019.01.001

    Article  Google Scholar 

  11. Li, J.R.; Liu, W.D.; Sun, L.H.; Cong, S.A.; Jia, R.X.; Zhang, J.J.; Yang, Y.: Effect of emulsification on surfactant partitioning in surfactant–polymer flooding. J. Surfactants Deterg. 22, 1387–1394 (2019). https://doi.org/10.1002/jsde.12353

    Article  Google Scholar 

  12. Zhou, Y.Z.; Yin, D.Y.; Cao, R.; Zhang, C.L.: The mechanism for pore-throat scale emulsion displacing residual oil after water flooding. J. Petrol. Sci. Eng. 163, 519–525 (2018). https://doi.org/10.1016/j.petrol.2018.01.027

    Article  Google Scholar 

  13. Bera, A.; Mandal, A.; Kumar, T.: Physicochemical characterization of anionic and cationic microemulsions: water solubilization, particle size distribution, surface tension, and structural parameters. J. Chem. Eng. Data 59, 2490–2498 (2014). https://doi.org/10.1021/je500274r

    Article  Google Scholar 

  14. Bera, A.; Ojha, K.; Kumar, T.; Mandal, A.: Water solubilization capacity, interfacial compositions and thermodynamic parameters of anionic and cationic microemulsions. Colloids Surf. A Physicochem. Eng. Aspects, 404, 70‒77 (2012). https://doi.org/10.1016/j.colsurfa.2012.04.013

  15. Bera, A.; Kumar, S.; Mandal, A.: Temperature-dependent phase behavior, particle size, and conductivity of middle-phase microemulsions stabilized by ethoxylated nonionic surfactants. J. Chem. Eng. Data 57, 3617–3623 (2012). https://doi.org/10.1021/je300845q

    Article  Google Scholar 

  16. Supee, A.; Idris, A.K.: Effects of surfactant–polymer formulation and salinities variation towards oil recovery. Arab. J. Sci. Eng. 39, 4251–4260 (2014). https://doi.org/10.1007/s13369-014-1025-7

    Article  Google Scholar 

  17. Zhai, M.J.; Wu, M.; Wang, C.Y.; Li, X.B.: A novel silica-supported polyether polysiloxane quaternary ammonium demulsifier for highly efficient fine-sized oil droplet removal of oil-in-water emulsions. RSC Adv. 10, 18918‒18926 (2020). https://doi.org/10.1039/D0RA01679A

  18. Dong, W.J.; Sun, D.J.; Li, Y.J.; Wu, T.: Rapid removal and recovery of emulsified oil from ASP produced water using in situ formed magnesium hydroxide. Environ. Sci. Water Res. 4, 539‒548 (2018). https://doi.org/10.1039/C7EW00568G

  19. Zhang, F.S.; Yang, J.O.; He, Y.W.; Wang, D.W.; Feng, X.F.: Study of the stability of the emulsion produced by alkaline surfactant polymer (ASP) flooding. Chem. Tech. Fuels Oil. 47, 434‒439 (2012). https://doi.org/10.1007/s10553-012-0320-9

  20. Wang, B.; Wu, T.; Li, Y. J.; Sun, D. J.; Li, X.: The effects of oil displacement agents on the stability of water produced from ASP (alkaline/surfactant/polymer) flooding. Colloids Surf. A 379, 121‒126 (2011). https://doi.org/10.1016/j.colsurfa.2010.11.064

  21. Xu, Z.S.; Zhang, J.H.; Feng, Z.H.; Fang, W.; Wang, F.L.: Characteristics of remaining oil viscosity in water- and polymer-flooding reservoirs in Daqing Oilfield. Sci. China Ser. 53, 72–83 (2010). https://doi.org/10.1007/s11430-009-0184-y

    Article  Google Scholar 

  22. Antón, R. E.; Andérez, J. M.; Bracho, C.; Vejar, F.; Salager, J. L.: Practical surfactant mixing rules based on the attainment of microemulsion‒oil‒water three-phase behavior systems. Adv. Polym. Sci. 218, 83–113 (2008). https://doi.org/10.1007/12_2008_163

  23. Zhao, M.; Wu, D.; Wang, J.; Zhang, H.P.; Liu, W.J.; Zhang, R.: Evolution of aqueous micellar solutions in the injection fluids of alkaline–surfactant–polymer and alkaline–surfactant floodings from injection to production. Asia-Pac. J. Chem. Eng. 12, 651–659 (2017). https://doi.org/10.1002/apj.2107

    Article  Google Scholar 

  24. Li, F.; He, W.W.; Sun, D.J.; Wu, T.; Li, Y.J.: Effect of sodium-montmorillonite particles on the stability of oil droplets in produced water from alkali/ surfactant/polymer flooding. J. Clean. Prod. 104, 468‒474 (2015). https://doi.org/10.1016/j.jclepro.2014.05.092

Download references

Acknowledgements

Financial support from the ‘Science and Technology Research Project of Jilin Institute of Chemical Technology (2018035)’ and ‘Jilin Institute of Chemical Technology Ph.D. Starts Fund Project (2018007)’ is gratefully acknowledged.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Dawei Zhang.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Ren, L., Zhang, D., Chen, Z. et al. Study on Basic Properties of Alkali‒Surfactant‒Polymer Flooding Water and Influence of Oil-Displacing Agent on Oil–Water Settlement. Arab J Sci Eng 47, 6941–6949 (2022). https://doi.org/10.1007/s13369-021-06065-w

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s13369-021-06065-w

Keywords

Navigation