Skip to main content
SpringerLink
Log in

Optimization of Reverse Cationic Flotation of Low-Grade Iron Oxide from Fluorspar Tails Using Taguchi Method

  • Research Article - Chemical Engineering
  • Published:
Arabian Journal for Science and Engineering Aims and scope Submit manuscript

Abstract

Due to gradual depletion of high-grade iron ores, there is a need to investigate the treatment of low-grade iron ores. Current procedures are time and cost intensive. Batch laboratory scale reverse cationic flotation was employed to concentrate low-grade Fe ore, found in fluorspar tails in the form of hematite. This study used two types of depressants (soluble starch and dextrin) and two types of amines (primary mono-amine and tertiary mono-amine). Optimisation of the process investigated parameters such as pH, collector type and dosage, depressant type and dosage, conditioning time, solids content, agitation speed and air flow rate. Owing to the high number of experiments when all possible combinations are investigated, Taguchi design of experiment method was utilised to streamline the number of experiments and optimize parameters using orthogonal array and signal–noise ratio (SN). The SN was used to determine the optimum conditions and analyse the relative significance of parameters studied. The results showed that both depressants were efficient for hematite depression; however, soluble starch produced better results when compared to Betachem 30D. Both Betacol 373 and Dodecylamine collectors were efficient as quartz collectors; however, Dodecylamine produced better results when compared to Betacol 373. Ranking of parameter using SN ratio showed that pH was the most critical parameter in obtaining higher Fe grade concentrate and the optimum pH is 10. De-slimming leads to low recoveries during reverse flotation of iron ores. The main conclusion is that Taguchi method can be used to optimise a reverse cationic flotation process of a low-grade iron ore.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. Filippov, L.; Severov, V.; Filippova, I.: An overview of the beneficiation of iron ores via reverse cationic flotation. Int. J. Miner. Process. 127, 62–69 (2014)

    Article  Google Scholar 

  2. Ma, X.; Bruckard, W.J.; Holmes, R.: Effect of collector, pH and ionic strength on the cationic flotation of kaolinite. Int. J. Miner. Process. 93(1), 54–58 (2009)

    Article  Google Scholar 

  3. Quast, K.: Flotation of hematite using C6–C18 saturated fatty acids. Miner. Eng. 19(6), 582–597 (2006)

    Article  Google Scholar 

  4. Araujo, A.C.; Viana, P.R.M.; Peres, A.E.C.: Reagents in iron ores flotation. Miner. Eng. 18(2), 219–224 (2005)

    Article  Google Scholar 

  5. Nguyen, A.: Froth Flotation. The University of Queensland, St Lucia (2013)

    Book  Google Scholar 

  6. Mowla, D.; Karimi, G.; Ostadnezhad, K.: Removal of hematite from silica sand ore by reverse flotation technique. Sep. Purif. Technol. 58(3), 419–423 (2008)

    Article  Google Scholar 

  7. Bendell, A.; Disney, J.; Pridmore, W.: Taguchi Methods: Application in World Industry. IFS Publications, New York (1989)

    Google Scholar 

  8. Statics, S.A.: Statics South Africa—Iron ore. http://www.statssa.gov.za. (2016). Accessed 10 Sept 2016

  9. Singh, G.P.; Choudhary, R.P.; Vardhan, H.; Aruna, M.; Akolkar, A.B.: Iron ore pelletization technology and its environmental impact assessment in eastern region of India—a case study. Procedia Earth Planet. Sci. 11, 582–597 (2015)

    Article  Google Scholar 

  10. Wills, B.; Finch, J.: Mineral Processing Technology: An Introduction to the Practical Aspects of Ore Treatment and Mineral Recovery, 8th edn. Elsevier, New York (2016)

    Google Scholar 

  11. Das, B.; Prakash, S.; Das, S.; Reddy, P.: Effective beneficiation of low grade iron ore through Jigging operation. J. Miner. Mater. Charact. Eng. 7(1), 27–37 (2007)

    Google Scholar 

  12. Rao, D.S.; Kumar, T.V.; Rao, S.S.; Prabhakar, S.; Raju, G.B.: Mineralogy and geochemistry of a low grade iron ore sample from bellary-hospet sector, India and their implications on beneficiation. J. Miner. Mater. Charact. Eng. 8(02), 115–132 (2009)

    Google Scholar 

  13. Umadevi, T.; et al.: Recovery of iron bearing minerals from beneficiation plant 2 thickner underflow of JSW steel limited. J. Miner. Mater. Charact. Eng. 1, 55–60 (2013)

    Google Scholar 

  14. Peres, A.P.: Innovative flotation routes in an iron ore concentrator. In: Proceedings of the XXIV International Mineral Processing Congress, Beijing (2008)

  15. Athreya, S.; Venkatesh, Y.: Application of Taguchi Method for optimization of process parameters in improving the surface roughness of Lathe facing operation. Int. Refereed J. Eng. Sci. 1(3), 13–19 (2012)

    Google Scholar 

  16. Altan, M.: Reducing shrinkage in injection moldings via the Taguchi, ANOVA and neural network methods. Mater. Des. 31, 599–604 (2010)

    Article  Google Scholar 

  17. Kumar, S.G.; Dastidar, C.M.: Optimization studies on coal-oil agglomeration using Taguchi (L16) experimental design. Fuel 141, 9–16 (2015)

    Article  Google Scholar 

  18. du Plessis, B.J.; de Villiers, G.: The application of the Taguchi method in the evaluation of mechanical flotation in waste activated sludge thickening. Resour. Conserv. Recycl. 50, 202–210 (2007)

    Article  Google Scholar 

  19. Kamaruddin, S.; Khan, Z.A.; Wan, K.: The use of the Taguchi method in determining the optimum plastic injection moulding parameters for the production of a consumer product. Jurnal Mekanikal 18, 98–110 (2004)

    Google Scholar 

  20. Lubisi, T.P.; Nheta, W.; Ntuli, F.: Physical, Chemical and Mineralogical Characterization of Fluorspar. Elsevier, New York (2016)

    Google Scholar 

  21. Sapakal, S.; Telsang, M.: Parametric optimization of MIG welding using Taguchi design method. Int. J. Adv. Eng. Res. Stud. 1(4), 28–30 (2012)

    Google Scholar 

  22. Tofighy, M.A.; Mohammadi, T.: Application of Taguchi experimental design in optimization of desalination using purified carbon nanotubes as adsorbent. Mater. Res. Bull. 47, 2389–2395 (2012)

    Article  Google Scholar 

  23. Kar, B.; Sahoo, H.; Rath, S.S.; Das, B.: Investigations on different starches as depressants for iron ore flotation. Miner. Eng. 49, 1–6 (2013)

    Article  Google Scholar 

  24. Nheta, W.; Lubisi, T.P.; Masemola, S.; Makhatha, M.E.: Beneficiation of Haematite from Fluorspar Tailings by Reverse Flotation. In: Proceedings of the World Congress on Mechanical, Chemical, and Material Engineering, p. 346-1 (2015)

  25. Lima, N.P.; Valadão, G.E.; Peres, A.E.: Effect of amine and starch dosages on the reverse cationic flotation of an iron ore. Miner. Eng. 45, 180–184 (2013)

    Article  Google Scholar 

  26. Pavlovic, S.; Brandão, P.R.G.: Adsorption of starch, amylose, amylopectin and glucose monomer and their effect on the flotation of hematite and quartz. Miner. Eng. 16(11), 1117–1122 (2003)

    Article  Google Scholar 

  27. Ma, X.; Marques, M.; Gontijo, C.: Comparative studies of reverse cationic/anionic flotation of Vale iron ore. Int. J. Miner. Process. 100, 179–183 (2011)

    Article  Google Scholar 

  28. Huang, Z.; Zhong, H.; Wang, S.; Xia, L.; Zou, W.; Liu, G.: Investigations on reverse cationic flotation of iron ore by using a Gemini surfactant: ethane-1, 2-bis (dimethyl-dodecyl-ammonium bromide). Chem. Eng. J. 257, 218–228 (2014)

    Article  Google Scholar 

  29. Masiya, T.T.; Nheta, W.: Flotation of nickel-copper sulphide ore: optimisation of process parameters using Taguchi method, Prague. In: Proceedings of the International Conference on Mining, Material and Metallurgical Engineering (2014)

  30. Fuerstenau, D.; Pradip, T.: Zeta potentials in the flotation of oxide and silicate minerals. Adv. Colloid Interface Sci. 114–115, 9–26 (2005)

    Article  Google Scholar 

  31. Pallant, J.; SPSS survival manual : a step by step guide to data analysis using SPSS. 4th ed. Open University Press, Maidenhead (2010)

Download references

Author information

Authors and Affiliations

  1. School of Mining, Metallurgy and Chemical Engineering, Faculty of Engineering and the Built Environment, University of Johannesburg, P.O. BOX 17011, Doornfontein, 2028, South Africa

    Thembelihle Portia Lubisi, Willie Nheta & Freeman Ntuli

Authors
  1. Thembelihle Portia Lubisi
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Willie Nheta
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Freeman Ntuli
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Willie Nheta.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Lubisi, T.P., Nheta, W. & Ntuli, F. Optimization of Reverse Cationic Flotation of Low-Grade Iron Oxide from Fluorspar Tails Using Taguchi Method. Arab J Sci Eng 43, 2403–2412 (2018). https://doi.org/10.1007/s13369-017-2703-z

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s13369-017-2703-z

Keywords

Search

Navigation