Improving smoothing efficiency of rigid conformal polishing tool using time-dependent smoothing evaluation model
- 228 Downloads
A rigid conformal (RC) lap can smooth mid-spatial-frequency (MSF) errors, which are naturally smaller than the tool size, while still removing large-scale errors in a short time. However, the RC-lap smoothing efficiency performance is poorer than expected, and existing smoothing models cannot explicitly specify the methods to improve this efficiency. We presented an explicit time-dependent smoothing evaluation model that contained specific smoothing parameters directly derived from the parametric smoothing model and the Preston equation. Based on the time-dependent model, we proposed a strategy to improve the RC-lap smoothing efficiency, which incorporated the theoretical model, tool optimization, and efficiency limit determination. Two sets of smoothing experiments were performed to demonstrate the smoothing efficiency achieved using the time-dependent smoothing model. A high, theory-like tool influence function and a limiting tool speed of 300 RPM were o
KeywordsOptics design and fabrication optics fabrication polishing
This research is financially supported by the National Natural Science of China (NSFC) (61210015) and Youth Foundation of National Natural Science Foundation (61605202).
- J. Nelson and G. H. Sanders, “The status of the thirty meter telescope project,” SPIE, 2008, 7012: 70121A-1-70121A-18.Google Scholar
- M. Johns, P. Mccarthy, K. Raybould, A. Bouchez, A. Farahani, J. Filgueira, et al., “Giant magellan telescope: overview,” SPIE, 2012, 8444: 84441H-1-84441H-16.Google Scholar
- T. Hull, M. J. Riso, J. M. Barentine, and A. Magruder, “Mid-spatial frequency matters: examples of the control of the power spectral density and what that means to the performance of imaging systems,” SPIE, 2012, 8353: 835329-1-835329-17.Google Scholar
- J. H. Burge, B. Anderson, S. Benjamin, M. K. Cho, K. Z. Smith, and M. J. Valente, “Development of optimal grinding and polishing tools for aspheric surfaces,” SPIE, 1990, 4451: 153–164.Google Scholar
- N. J. Brown, P. C. Baker, and R. E. Parks, “Polishing-to-figuring transition in turned optics,” Contemporary Methods of Optical Fabrication, 1981, 306(6): 58–65.Google Scholar
- J. H. Burge, D. W. Kim, and H. M. Martin, “Process optimization for polishing large aspheric mirrors,” SPIE, 2014, 9151: 91512R-1-91512R-13.Google Scholar
Open Access This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.