Abstract
The composites of chlorinated polyethylene rubber (CM) filled with boron nitride (BN) were prepared and examined systematically. Scanning electron microscopy (SEM) was used to observe microscopic morphology of composites. Mechanical properties of composites were analyzed by a rubber process analyzer (RPA) and dynamic mechanical thermal analyzer (DMTA). Thermal conductivity as well as thermo stability of composites was improved by adding BN particles into the CM rubber. It was found that BN particles can reinforce the rubber matrix while they also break down the network of polymer chains and ruin the physical properties of the rubber matrix. During the dynamic compressing process, BN particles can transfer heat from the matrix and alleviate the heat build-up phenomenon. The BN/CM composites (volume content C BN=18%) with thermal conductivity 1.179 W/(m·K) and good flexibility (Elongation at break=320%) were prepared, which may be used as thermal interface materials in a dynamic compressing process.
Similar content being viewed by others
References
H. Pang, L. Xu, D. X. Yan, Z. M. Li, and Z. M. Li, Prog. Polym. Sci., 39, 1908 (2014).
J. F. Zheng, Q. Y. He, and C. L. Liu, J. Membr. Sci., 476, 571 (2015).
M. Wang, Z. Wang, N. Li, and L. S. Zhao, J. Membr. Sci., 495, 252 (2015).
C. Y. Zhi, Y. Bando, C. C. Tang, and D. Golberg, Adv. Mater., 21, 2889 (2009).
W. Y. Zhou, S. H. Qi, and Q. L. An, Mater. Res. Bull., 42, 1863 (2007).
J. W. Gu, Q. Y. Zhang, J. Dang, P. Zhang, and S. J. Chen, Polym. Eng. Sci., 49, 1030 (2009).
H. He, R. L. Fu, Y. Shen, Y. Han, and X. Song, Compos. Sci. Technol., 67, 2493 (2007).
R. H. Baek, C. K. Baek, and H. S. Choi, IEEE Trans. Nanotechnol., 10, 417 (2011).
W. Y. Zhou, C. F. Wang, T. Ai, K. Wu, J. Zhao, and H. Z. Gu, Compos. A, 40, 830 (2009).
L. M. McGrath, R. S. Parnas, S. H. King, and S. H. King, Polymer, 49, 999 (2008).
W. Y. Zhou, D. M. Yu, and C. Min, J. Appl. Polym. Sci., 112, 1695 (2009).
T. Zhou, X. Wang, M. Y. Gu, and X. H. Liu, Polymer, 49, 4666 (2008).
G. Gedler, M. Antunes, T. B. Tasciuc, J. I. Velasco, and R. Ozisik, Eur. Polym. J., 75, 190 (2016).
Q. Liao, Z. Liu, and W. Liu, Sci. Rep., 5, (2015).
B. L. Zhu, J. Ma, J. Wu, K. C. Yung, and C. S. Xie, J. Appl. Polym. Sci., 118, 2754 (2010).
Z. H. Tang, H. L. Kang, Z. L. Shen, B. H. Guo, and L. Q. Zhang, Macromolecules, 45, 3444 (2012).
X. Y. Hao, M. B. Lai, and G. S. Gai, Mater. Res. Innov., 18, 368 (2014).
W. Y. Zhou, S. H. Qi, H. Z. Zhao, and N. L. Liu, Polym. Compos., 28, 23 (2007).
Z. Q. Kuang, Y. L. Chen, Y. L. Lu, L. Liu, and L. Q. Zhang, Small, 11, 1655 (2015).
Z. X. Zhang, C. H. Chen, X. W. Gao, K. K. Jin, and Z. X. Xin, J. Appl. Polym. Sci., 120, 1180 (2011).
S. Kar, P. K. Maji, and A. K. Bhowmick, J. Mater. Sci., 45, 64 (2010).
W. Y. Zhou, Thermochim. Acta, 512, 183 (2011).
K. Wattranakul, H. Manuspiya, and N. Yanumet, J. Compos. Mater., 45, 1967 (2011).
M. S. Nurul and M. Mariatti, J. Thermoplast. Compos., 26, 627 (2013).
K. W. Stockelhuber, A. S. Svistkov, A. G. Pelevin, and G. Heinrich, Macromolecules, 44, 4366 (2011).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Shu, J., Xia, R., Qian, J. et al. Preparation and study on thermal conductive composites of chlorinated polyethylene rubber reinforced by boron nitride particles. Macromol. Res. 24, 640–644 (2016). https://doi.org/10.1007/s13233-016-4088-3
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13233-016-4088-3