Skip to main content

Advertisement

SpringerLink
Log in

On the hot tensile deformation behavior of an AISI 316LN stainless steel

  • Published:
Transactions of the Indian Institute of Metals Aims and scope Submit manuscript

Abstract

The hot deformation characteristics of AISI 316LN stainless steel were studied in the temperature range of 1123–1323 K and strain rate range of 10−4–10−1s−1 by carrying out tensile tests. The flow stress, ultimate tensile stress and percentage elongation were found to be strongly dependent on the temperature and strain rate. The critical strain required for the initiation of dynamic recrystallisation and peak strain were determined at each condition and their variation with temperature and strain rate studied. The deformation behavior was analyzed using a generic model for high temperature deformation and deformation parameters were computed. The variation of the true activation energy with strain for rate controlled high temperature tensile deformation was obtained. Microstructural studies were carried out on tested samples and the results of all the above studies are presented.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Subscribe and save

Springer+ Basic
$34.99 /Month
  • Get 10 units per month
  • Download Article/Chapter or eBook
  • 1 Unit = 1 Article or 1 Chapter
  • Cancel anytime
Subscribe now

Buy Now

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. Simmons J W, Mater. Sci. Eng., A, 207 (1996) 159.

    Article  Google Scholar 

  2. Shankar P, Shaikh H, Sivakumar S, Venugopal S, Sundararaman D and Khatak H S, J. Nucl. Mater., 264 (1999) 29.

    Article  ADS  CAS  Google Scholar 

  3. Byun T S, Hashimoto N and Farrel K, Acta Mater., 52 (2004) 3889.

    Article  CAS  Google Scholar 

  4. Samuel K G, Mannan S L and Radhakrishnan V M, J. Mater. Process. Technol., 38 (1993) 517.

    Article  Google Scholar 

  5. Isaac Samuel E, Choudhary B K and Bhanu Sankara Rao, Scr. Mater., 46 (2002) 507.

    Article  Google Scholar 

  6. Mannan S L, Samuel K G and Rodriguez P, Mater. Sci. Eng., 68 (1984–1985) 143.

    Google Scholar 

  7. Lee E H, Byun T S, Hunn J D, Yoo M H, Farrell K and Mansur L K, Acta mater., 49 (2001) 3269.

    Article  CAS  Google Scholar 

  8. Venugopal S, Mannan S L and Prasad Y V R K, Mater. Sci. Eng., A, 177 (1994) 143.

    Article  CAS  Google Scholar 

  9. Wahabi W EI, Cabrera J M and Prado J M, Mater. Sci. Eng. A, 343 (2003) 116.

    Article  Google Scholar 

  10. Sivaprasad P V, Mannan S L, Prasad Y V R K and Chaturvedi R C, Mater. Sci. Technol., 17 (2001) 545.

    CAS  Google Scholar 

  11. Venugopal S, Mannan S L and Prasad Y V R K, Mater. Sci. Technol., 9 (1993) 899.

    CAS  Google Scholar 

  12. ASM hand book, Metallography and microstructures, ASM International, 9 (2004) 1600 and 1623.

  13. Venugopal S, Mannan S L and Prasad Y V R K, Metall. Trans. A, 23 (1992) 3093.

    Article  Google Scholar 

  14. Prasad Y V R K and Ravichandran N, Bull. Mat. Sci., 14 (1991) 1241.

    Article  CAS  Google Scholar 

  15. Ryan N D and McQueen H J, High Temp. Technol., 8 (1990) 185.

    CAS  Google Scholar 

  16. Kim S I and Yoo Y C, Mater. Sci. Technol., 18 (2002) 160.

    Article  CAS  Google Scholar 

  17. McQueen H J, Mater. Sci. Eng., A, 101 (1988) 149.

    Article  CAS  Google Scholar 

  18. Kim Sung-II and Yoo Yeon-Chul, Mater. Sci. Eng. A, 311 (2001) 108.

    Article  Google Scholar 

  19. Venugopal S, Mannan S L and Prasad Y V R K, Metall. Trans., A, 23 (1992) 3093.

    Article  Google Scholar 

  20. Ryan N D and McQueen H J, J. Mater. Process. Technol., 21 (1990) 177.

    Article  Google Scholar 

  21. McQueen HJ and Ryan N D, Mater. Sci. Eng. A, 322 (2002) 43.

    Article  Google Scholar 

  22. Bhattacharya S S, Satishnarayana G V and Padmanabhan K A, J. Mater. Sci., 30 (1995) 5850.

    Article  ADS  CAS  Google Scholar 

  23. Bhattacharya S S and Padmanabhan K A, Proceedings of the International Conference on Superplasticity of Advanced Materials, June 4–6, 1991, Osaka, Japan; Eds. Hori S, Tokizane M and Furushiro N, Japan Society for Research on Superplasticity, (1991) p 33.

  24. Bhattacharya S S and Padmanbhan K A, Key Eng. Mater., 97 (1995) 141.

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

  1. Materials Testing Facility, Department of Metallurgical and Materials Engineering, Indian Institute of Technology Madras, Chennai, 600 036, India

    P. Mallikarjuna Rao & S. S. Bhattacharya

Authors
  1. P. Mallikarjuna Rao
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. S. S. Bhattacharya
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to S. S. Bhattacharya.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Mallikarjuna Rao, P., Bhattacharya, S.S. On the hot tensile deformation behavior of an AISI 316LN stainless steel. Trans Indian Inst Met 62, 41–48 (2009). https://doi.org/10.1007/s12666-009-0006-0

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s12666-009-0006-0

Keywords

Search

Navigation