Abstract
Static segregation of coal gangue-fly ash backfill (CGFB) material presents a significant impact on its mechanical performance for underground support. To resolve, a novel formulation was addressed using sodium silicate (SS) and CO2 as co-activator. Its setting behaviors and mechanical properties were investigated with respect to the coal gangue content, CO2 influx and the concentration of sodium silicate solution. The microstructure was characterized by SEM, EDX, XRD, and FTIR. The present method lowered the initial and final setting times to approximately 90% and 74% comparing to which of conventional activator. The compressive strength increased from 2.06 to 10.23 MPa with coal gangue ratio of 3.2 after 56 days curing. This mainly results from the mitigation of the effect of segregation through the generation of silica gel, which precipitated on the grain surface. The silica gel promoted the interparticle binding and rapid consistency, thus preventing gangue from settlement. Incorporating the microscale crystalline phase characterization, the carbonate products work as the filling particle and the coal gangue presents as the reinforcement after hardening, leading to the significant increase in material strength. This method not only ensures safe disposal of coal gangue and fly ash from segregation, but also mitigates overburden deformation and promotes CO2 utilization. Therefore, the coordinated development of coal resource development, environmental protection, and carbon footprint reduction is realized.
Similar content being viewed by others
Data Availability
Data available on request from the authors.
References
Asachi M et al (2018) Experimental evaluation of the effect of particle properties on the segregation of ternary powder mixtures. Powder Technol 336:240–254
Chen S et al (2020a) Effects of red mud additions on gangue-cemented paste backfill properties. Powder Technol 367:833–840
Chen B et al (2020b) Comparative kinetics study on carbonation of ettringite and meta-ettringite based materials. Cem Concr Res 137:106209
Cheng H-Y et al (2020) Effect of particle gradation characteristics on yield stress of cemented paste backfill. Int J Miner Metall Mater 27(1):10–17
Chindaprasirt P, Cao T (2015) 5—Setting, segregation and bleeding of alkali-activated cement, mortar and concrete binders. In: Pacheco-Torgal F et al (eds) Handbook of alkali-activated cements, mortars and concretes. Woodhead Publishing, Oxford, pp 113–131
Dai X et al (2020) Effects of activator properties and GGBFS/FA ratio on the structural build-up and rheology of AAC. Cem Concr Res 138:106253
de Matos PR et al (2022) Strategies for XRD quantitative phase analysis of ordinary and blended Portland cements. Cem Concr Compos 131:104571
Ekolu S, Solomon F, Rakgosi G (2022) Chloride-induced delayed ettringite formation in Portland cement mortars. Constr Build Mater 340:127654
Feng G et al (2022) Effect of velocity on flow properties and electrical resistivity of cemented coal gangue-fly ash backfill (CGFB) slurry in the pipeline. Powder Technol 396:191–209
Garcia-Lodeiro I et al (2011) Compatibility studies between N–A–S–H and C–A–S–-H gels. Study in the ternary diagram Na2O–CaO–Al2O3–SiO2–H2O. Cem Concr Res 41(9):923–931
GB/T 17671-2021 (2021) Test method of cement mortar strength (ISO method). https://www.antpedia.com/standard/1149097354.html. Accessed 5 Aug 2022
Gnanaraj SC et al (2021) Durability properties of self-compacting concrete developed with fly ash and ultra fine natural steatite powder. J Market Res 13:431–439
Gökçe HS, Andiç-Çakır Ö (2019) Bleeding characteristics of high consistency heavyweight concrete mixtures. Constr Build Mater 194:153–160
Guo W et al (2021) Mechanical performance and microstructure improvement of soda residue–carbide slag–ground granulated blast furnace slag binder by optimizing its preparation process and curing method. Constr Build Mater 302:124403
Guo Y et al (2022a) Deformation and instability properties of cemented gangue backfill column under step-by-step load in constructional backfill mining. Environ Sci Pollut Res 29(2):2325–2341
Guo L et al (2022b) Preparation of coal gangue-slag-fly ash geopolymer grouting materials. Constr Build Mater 328:126997
Jiang C et al (2020) Occurrence and environmental impact of coal mine goaf water in karst areas in China. J Clean Prod 275:123813
Jin J et al (2022) Rheology control of self-consolidating cement-tailings grout for the feasible use in coal gangue-filled backfill. Constr Build Mater 316:125836
Kapeluszna E et al (2017) Incorporation of Al in C–A–S–H gels with various Ca/Si and Al/Si ratio: microstructural and structural characteristics with DTA/TG, XRD, FTIR and TEM analysis. Constr Build Mater 155:643–653
Kazmi SMS et al (2019) Influence of different treatment methods on the mechanical behavior of recycled aggregate concrete: a comparative study. Cement Concr Compos 104:103398
Keulen A et al (2018) Effect of admixture on the pore structure refinement and enhanced performance of alkali-activated fly ash-slag concrete. Constr Build Mater 162:27–36
Koohestani B et al (2021) Geopolymerization mechanism of binder-free mine tailings by sodium silicate. Constr Build Mater 268:121217
Li PP, Yu QL, Brouwers HJH (2018) Effect of coarse basalt aggregates on the properties of ultra-high performance concrete (UHPC). Constr Build Mater 170:649–659
Li M et al (2020a) Reutilisation of coal gangue and fly ash as underground backfill materials for surface subsidence control. J Clean Prod 254:120113
Li J et al (2020b) Feasibility of using fly ash–slag-based binder for mine backfilling and its associated leaching risks. J Hazard Mater 400:123191
Liu W et al (2021) Mechanical properties and damage evolution of cemented coal gangue-fly ash backfill under uniaxial compression: effects of different curing temperatures. Constr Build Mater 305:124820
Ma L et al (2019) Water conservation when mining multiple, thick, closely-spaced coal seams: a case study of mining under Weishan lake. Mine Water Environ 38(3):643–657
Ma L et al (2022) Prediction of water-blocking capability of water-seepage-resistance strata based on AHP-fuzzy comprehensive evaluation method—a case study. Water 14(16):2517
Ngo I et al (2022) Experimental investigation of CO2-induced silica gel as the water blocking grout effect of aquifer ions. ACS Omega 7(31):27090–27101
Ngo I et al (2023) Enhancing fly ash utilization in backfill materials treated with CO2 carbonation under ambient conditions. Int J Min Sci Technol 33(3):325–339
Ozer I, Soyer-Uzun S (2015) Relations between the structural characteristics and compressive strength in metakaolin based geopolymers with different molar Si/Al ratios. Ceram Int 41(8):10192–10198
Partyka J, Leśniak M (2016) Raman and infrared spectroscopy study on structure and microstructure of glass–ceramic materials from SiO2–Al2O3–Na2O–K2O–CaO system modified by variable molar ratio of SiO2/Al2O3. Spectrochim Acta Part A Mol Biomol Spectrosc 152:82–91
Prud’homme E et al (2011) In situ inorganic foams prepared from various clays at low temperature. Appl Clay Sci 51(1):15–22
Puligilla S, Chen X, Mondal P (2018) Understanding the role of silicate concentration on the early-age reaction kinetics of a calcium containing geopolymeric binder. Constr Build Mater 191:206–215
Qi C, Fourie A (2019) Cemented paste backfill for mineral tailings management: review and future perspectives. Miner Eng 144:106025
Qi T et al (2022) Effect of biomass power plant ash on fresh properties of cemented coal gangue backfill. Constr Build Mater 340:127853
Qian J et al (2015) Laboratory characterization of controlled low-strength materials. Mater Des (1980–2015) 65:806–813
Qiu J et al (2021a) Effect and mechanism of coal gangue concrete modification by fly ash. Constr Build Mater 294:123563
Qiu J et al (2021b) The influence of fly ash content on ITZ microstructure of coal gangue concrete. Constr Build Mater 298:123562
Ran H et al (2022) Failure properties and stability monitoring of strip and column cemented gangue backfill bodies under uniaxial compression in constructional backfill mining. Environ Sci Pollut Res 29(34):51411–51426
Romagnoli M et al (2014) Rheological characterization of fly ash-based suspensions. Constr Build Mater 65:526–534
Saeli M et al (2019) Novel biomass fly ash-based geopolymeric mortars using lime slaker grits as aggregate for applications in construction: influence of granulometry and binder/aggregate ratio. Constr Build Mater 227:116643
Sun X et al (2022) Alkali activation of blast furnace slag using a carbonate-calcium carbide residue alkaline mixture to prepare cemented paste backfill. Constr Build Mater 320:126234
Uğurlu Aİ, Karakoç MB, Özcan A (2021) Effect of binder content and recycled concrete aggregate on freeze-thaw and sulfate resistance of GGBFS based geopolymer concretes. Constr Build Mater 301:124246
Wang J et al (2016) A concrete material with waste coal gangue and fly ash used for farmland drainage in high groundwater level areas. J Clean Prod 112:631–638
Wang Y-S, Alrefaei Y, Dai J-G (2020a) Influence of coal fly ash on the early performance enhancement and formation mechanisms of silico-aluminophosphate geopolymer. Cem Concr Res 127:105932
Wang S et al (2020b) Influence of coarse tailings on flocculation settlement. Int J Miner Metall Mater 27(8):1065–1074
Wang Z et al (2021) Electrical resistivity method to appraise static segregation of gangue-cemented paste backfill in the pipeline. Int J Press Vessels Pip 192:104385
Wang Q et al (2022) Preparation and characterization of an alkali-activated cementitious material with blast-furnace slag, soda sludge, and industrial gypsum. Constr Build Mater 340:127735
Xu Y et al (2022a) Prediction of the height of water-conductive fractured zone under continuous extraction and partial backfill mining method—a case study. Sustainability 14(11):6582
Xu Y et al (2022b) Continuous extraction and continuous backfill mining method using carbon dioxide mineralized filling body to preserve shallow water in Northwest China. Energies 15(10):3614
Yang X et al (2020) Determining the pressure drop of cemented Gobi sand and tailings paste backfill in a pipe flow. Constr Build Mater 255:119371
Yin S et al (2022) Effect of fly-ash as fine aggregate on the workability and mechanical properties of cemented paste backfill. Case Stud Constr Mater 16:e01039
Yu L et al (2022) Study on the mechanical behavior and micro-mechanism of concrete with coal gangue fine and coarse aggregate. Constr Build Mater 338:127626
Zhang G et al (2020) Properties of pervious concrete with steel slag as aggregates and different mineral admixtures as binders. Constr Build Mater 257:119543
Zhang D et al (2021) Carbonation curing for precast engineered cementitious composites. Constr Build Mater 313:125502
Zhang Y, Chen H, Wang Q (2022) Accelerated carbonation of regenerated cementitious materials from waste concrete for CO2 sequestration. J Build Eng 55:104701
Zhao X, Fourie A, Qi C-C (2020) Mechanics and safety issues in tailing-based backfill: a review. Int J Miner Metall Mater 27(9):1165–1178
Zhou N et al (2020a) Feasibility study and performance optimization of sand-based cemented paste backfill materials. J Clean Prod 259:120798
Zhou Q et al (2020b) Early-age strength property improvement and stability analysis of unclassified tailing paste backfill materials. Int J Miner Metall Mater 27(9):1191–1202
Zuo Y, Nedeljković M, Ye G (2019) Pore solution composition of alkali-activated slag/fly ash pastes. Cem Concr Res 115:230–250
Acknowledgements
The authors would like to thank the National Natural Science Foundation of China (51874280 and 52250410338) and the Fundamental Research Funds of the Central Universities (2021ZDPY0211) for financial support.
Funding
Funding was supported by National Natural Science Foundation of China (51874280 and 52250410338), Fundamental Research Funds of the Central Universities (2021ZDPY0211).
Author information
Authors and Affiliations
Contributions
Ichhuy Ngo: Conceptualization, Methodology, Formal analysis, Investigation, Writing – original draft, Writing – review & editing, Visualization. Liqiang Ma: Conceptualization, Methodology, Funding acquisition. Jiangtao Zhai: Data curation, Writing - review & editing. Yangyang Wang: Data curation, Writing – review & editing. Yujun Xu: Resources, Writing – review & editing. Tianxiang Wei: Data curation, Writing – review & editing. Kunpeng Yu: Writing – review & editing.
Corresponding author
Ethics declarations
Competing interests
The authors declare no competing interests.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Ngo, I., Ma, L., Zhai, J. et al. Effect of the co-activation of sodium silicate and CO2 on setting and mechanical properties of coal gangue-fly ash backfill (CGFB). Environ Earth Sci 82, 190 (2023). https://doi.org/10.1007/s12665-023-10863-w
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s12665-023-10863-w