Abstract
This study focused on analyzing and calculating the correction factor between direct and indirect methods for the ultrasonic testing of stone monuments using a customized transducer and couplant. To achieve this goal, the P-wave velocity in 11 rock specimens, including two artificially weathered samples, was measured in a laboratory by applying both direct and indirect methods using an ultrasonic tester. Statistical interpretation of the results revealed that the indirect P-wave velocities were always lower than the direct velocities, with the correction factors between them differing by rock type. The average correction factors produced by the indirect method were 1.50 in the medium- to coarse-grained granite sample, 1.37 in fine-grained granite, 1.58 in fine-grained diorite, 1.38 in medium-grained diorite, 1.59 in sandstone, and 1.71 in marble. In addition, the regression equation and coefficient of determination, R 2 were acceptably high, suggesting a sufficient relationship between the two variables for use in engineering. This study will significantly contribute to improving the reliability of ultrasonic testing for weathering evaluation of a stone monument.









Similar content being viewed by others
References
Birch F (1961) The velocity of compressional waves in rocks to 10 kilobars, Part II. J Geophys Res 66(7):2199–2224
Capizzi P, Cosentino PL, Schiavone S (2013) Some tests of 3D ultrasonic traveltime tomography on the Eleonora d’Aragona statue (F. Laurana, 1468). J Appl Geophys 91:14–20
Chakia S, Takarlia M, Agbodjana WP (2008) Influence of thermal damage on physical properties of a granite rock: porosity, permeability and ultrasonic wave evolutions. Constr Build Mater 22:1456–1461
Chen Y, Nishiyama T, Kusuda H, Kita H, Sato T (1999) Correlation between microcrack distribution patterns and granitic rock splitting planes. Int J Rock Mech Min Sci 36:535–541
Choi JB, Jwa YJ, Kim K, Hwang GC (2006) Analyses of mineral composition of Geochang granitic rocks for stone specification. J Mineral Soc Korea 19:363–381
Darot M, Reuschlé T (2000) Acoustic wave velocity and permeability evolution during pressure cycles on a thermally cracked granite. Int J Rock Mech Min Sci 37:1019–1026
Fort R, Alvarez de Buergo M, Perez-Monserrat E (2013) Non-destructive testing for the assessment of granite decay in heritage structures compared to quarry stone. Int J Rock Mech Min Sci 61:296–305
Heinrichs K, Fitzner B (2011) Assessment of weathering damage on the Petroglyphs of Cheonjeon-ri, Ulsan, Republic of Korea. Environ Earth Sci 63:1741–1761
Jo YH, Lee CH (2014) Establishment of ultrasonic measurement method for stone cultural heritage considering water content and anisotropy. J Conserv Sci 30:467–480
Jo YH, Lee CH (2015) A study on selection of ultrasonic transducer and contact material for surface irregularities of stone cultural heritage. J Conserv Sci 31:267–278
Jo YH, Lee CH, Chun YG (2012) Material characteristics and deterioration evaluation for the 13th century Korean stone pagoda of Magoksa temple. Environ Earth Sci 66:915–922
Kahraman S (2002) Estimating the direct P-wave velocity value of intact rock from indirect laboratory measurements. Int J Rock Mech Min Sci 39:101–104
Kahraman S (2007) The correlations between the saturated and dry P-wave velocity of rocks. Ultrasonics 46:341–348
Kim JH, Lee MS, Lee MH, Lee JM, Park SM (2011) A study on effects of temperature for physical properties change of rocks. J Petrol Soc Korea 20:141–149
Lee CH, Jo YH (2016) Stone heritage of the Republic of Korea. In: Kato S, Reedman A, Shimazaki Y, Uchida T, Ngoc NTM, Surinkum A (eds) Stone heritage of east and southeast Asia. CCOP, pp 79–103
Lee CH, Jo YH, Chun YG (2009) Establishment of ultrasonic measurement and correlations of direct-indirect method for weathering evaluation of stone cultural heritage. J Conserv Sci 25:233–244
Lee CH, Jo YH, Kim J (2011) Damage evaluation and conservation treatment of the tenth century Korean rock-carved Buddha statues. Environ Earth Sci 64:1–14
Lion M, Skoczylas F, Ledésert B (2005) Effects of heating on the hydraulic and poroelastic properties of bourgogne limestone. Int J Rock Mech Min Sci 42:508–520
Mohamed Sutan N, Meganathan M (2003) A comparison between direct and indirect method of ultrasonic pulse velocity in detecting concrete defects. Russ J Nondestr Test 8:1–9
Moropoulou A, Labropoulos KC, Delegou ET, Karoglou M, Bakolas A (2013) Non-destructive techniques as a tool for the protection of built cultural heritage. Constr Build Mater 48:1222–1239
Popovics S (2001) Analysis of the concrete strength versus ultrasonic pulse velocity relationship. Mater Eval 59:123–129
Qixian L, Bungey JH (1996) Using compression wave ultrasonic transducers to measure the velocity of surface waves and hence determine dynamic modulus of elasticity for concrete. Constr Build Mater 10:237–242
Sharma PK, Singh TN (2008) A correlation between P-wave velocity, impact strength index, slake durability index and uniaxial compressive strength. Bull Eng Geol Environ 67:17–22
Simmons G, Cooper HW (1978) Thermal cycling cracks in three igneous rocks. Int J Rock Mech Min Sci Geomech Abstr 15:145–148
Tharmaratnam K, Tan BS (1990) Attenuation of ultrasonic pulse in cement mortar. Cem Concr Res 20:335–345
Turgut P, Kucuk OF (2006) Comparative relationships of direct, indirect, and semi-direct ultrasonic pulse velocity measurements in concrete. J Nondestruct Test 42:745–751
Vasanelli E, Colangiuli D, Calia A, Sileo M, Aiello MA (2015) Ultrasonic pulse velocity for the evaluation of physical and mechanical properties of a highly porous building limestone. Ultrasonics 60:33–40
Yagiz S (2010) Geochemical properties of construction stones quarried in South-western Turkey. Sci Res Essays 5:750–757
Yaman IO, Inci G, Yesiller N, Aktan HM (2001) Ultrasonic pulse velocity in concrete using direct and indirect transmission. ACI Mater J 98:450–457
Yasar E, Erdogan Y (2004) Correlating sound velocity with the density, compressive strength and Young’s modulus of carbonate rocks. Int J Rock Mech Min Sci 41:871–875
Acknowledgements
This work was supported by the research Grant of the Kongju National University in 2013, Republic of Korea.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Lee, C.H., Jo, Y.H. Correlation and correction factor between direct and indirect methods for the ultrasonic measurement of stone samples. Environ Earth Sci 76, 477 (2017). https://doi.org/10.1007/s12665-017-6810-7
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s12665-017-6810-7

