Seismic and mechanical properties of Opalinus Clay: comparison between sandy and shaly facies from Mont Terri (Switzerland)

Abstract

For the safe disposal of high-level radioactive waste, different host rocks are currently being considered. The favorable properties of clay are low permeability, some retention capacity concerning radionuclides, and the ability to self-seal cracks and fissures, e.g. by swelling or time-dependent compaction creep. In Switzerland, the Jurassic Opalinus Clay is envisaged as a potential host rock which—at Mont Terri—is subdivided into the sandy, shaly, and carbonate-rich facies, the latter being less abundant. For long-term safety assessments, the understanding of the relations of properties (e.g. mineralogical composition and microstructure) and performance (e.g. mechanical behavior) of clays and claystones is essential. In the case of the sandy Opalinus Clay, the mechanical strength increases with increasing carbonate content, because carbonates form the matrix. The mineralogical investigation of a set of sandy facies samples proved a significantly larger carbonate content (20–40 mass %) when compared to the shaly facies (10–20 mass %). The carbonates of the shaly Opalinus Clay, on the other hand, are mostly localized fossils aligned parallel to the bedding, acting as predetermined breaking points. Image analysis of SEM images of polished sections proved the determined microstructural differences. In addition, carbonate particles of the sandy facies are mostly isometric, whereas carbonate particles of the shaly facies cover a greater range of shapes. The mechanical tests were accompanied by investigations of the p- and s-wave velocities, which revealed that the anisotropy of the sandy facies is less pronounced than sedimentological analyses would suggest. The mechanical strength, which, for the first time, presents results of real triaxial tests of the sandy facies. The samples of the sandy facies exhibit a failure strength of σ _eff,B, approximately twice as high as was found for the shaly facies considering the deformation axis parallel to the bedding. Similar values were obtained when measuring perpendicularly to the bedding.