ABSTRACT
Usually, in order to determine the mechanical characteristic of metallic material is used the tensile test. But, for orthotropic sheet metal testing the tensile test become not representative and is proposed the utilization of planar sharing, planar stretching and compression tests. Those testing methods are ease to implement on conventional testing machines and the obtained results may be used in the sheet metal forming analysis and in the understanding of mechanical behaviour of orthotropic materials.
This is a preview of subscription content, log in via an institution to check access.
REFERENCES
Datsko,J.; W.J. Michell, W. J.. Changes in Mechanical Properties in Metal-Forming Processes. Journal of Materials Engineering and Performance. Volume 2(2) April 1993 265–170
Ungureanu,V., Judele, A.. The Enhanced Specimen and Testing Device for Planar Share Strain Test of Sheet Metal MOCM-9. Romanian Technical Academy, 2005.
Ungureanu,V.. The Novel Technique for Uniaxial Compression Test of Sheet Metal Specimens and Some Experimental Results. MOCM-6. Romanian Academy, Branch Office of Iassy. 2000. pp. 253–257.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ungureanu, V., Stan, G. & Axinte, C. Some characteristics of orthotropic materials revealed by special mechanical testing and their FLD’s. Int J Mater Form 1 (Suppl 1), 289–292 (2008). https://doi.org/10.1007/s12289-008-0345-0
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12289-008-0345-0