Abstract
In order to reduce economic and life losses due to terrorism or accidental explosion threats, reinforced concrete (RC) slabs of buildings need to be designed or retrofitted to resist blast loading. In this paper the dynamic behavior of RC slabs under blast loading and its influencing factors are studied. The numerical model of an RC slab subjected to blast loading is established using the explicit dynamic analysis software. Both the strain rate effect and the damage accumulation are taken into account in the material model. The dynamic responses of the RC slab subjected to blast loading are analyzed, and the influence of concrete strength, thickness and reinforcement ratio on the behavior of the RC slab under blast loading is numerically investigated. Based on the numerical results, some principles for blast-resistant design and retrofitting are proposed to improve the behavior of the RC slab subjected to blast loading.
Similar content being viewed by others
References
Li Zhongxian, Du Hao, Bao Chunxiao. A review of curren researches on blast load effects on building structures in China[J]. Transactions of Tianjin University, 2006, 12(Suppl): 35–41.
Low Hsin Yu, Hao Hong. Reliability analysis of direc shear and flexural failure modes of RC slabs under explosive loading[J]. Engineering Structures, 2002, 24(2): 189–198.
Zhou Xiaoqing, Hao Hong, Kuznetsov Valerian A et al. Numerical calculation of concrete slab response to blast loading[J]. Transactions of Tianjin University, 2006, 12(Suppl): 94–99.
Holmquist T J, Johnson G R, Cook W H. A computationa constitutive model for concrete subjected to large strains, high strain rates and high pressures[C]. In: Proceedings of the 14th International Symposium on Ballistics. Canadian Defence Preparedness Association, Quebec, 1993. 591–600.
Zhang Fengguo, Li Enzheng. A computational model fo concrete subjected to large strains, high strain rates, and high pressures[J]. Explosion and Shock Waves, 2002, 22(3): 198–202(in Chinese).
Livermore Software Technology Corporation. LS-DYNA Keyword User’s Manual [M]. Livermore Software Technolog Corporation, California, 2003.
Henrych Josef. The Dynamics of Explosion and Its Use [M]. Elsevier Scientific Pub Co, New York, 1979.
Mays G C, Smith P D. Blast Effects on Buildings: Design of Buildings to Optimize Resistance to Blast Loading [M] Thomas Telford Publications, London, 2003.
Yan Shi, Zhang Liang, Wang Dan. Failure mode analysi for RC slab under explosive loads[J]. Journal of Shenyang Jianzhu University (Natural Science), 2005, 21(3): 177–180(in Chinese).
Yuen S Chung Kim, Nurick G N. Experimental and numerica studies on the response of quadrangular stiffened plates(Part I): Subjected to uniform blast load[J]. International Journal of Impact Engineering, 2005, 31(1): 55–83.
Gupta N K, Nagesh. Deformation and tearing of circula plates with varying support conditions under uniform impulsive loads[J]. International Journal of Impact Engineering, 2007, 34(1): 42–59.
Randers-Pehrson G, Bannister K A. Airblast loading mode for DYNA2D and DYNA3D[R]. Report ARL-TR-1310, 1997.
Author information
Authors and Affiliations
Corresponding author
Additional information
Supported by National Natural Science Foundation of China (No. 50638030) and National Key Technologies R&D Program of China (No. 2006BAJ13B02).
DU Hao, born in 1976, male, doctorate student.
Rights and permissions
About this article
Cite this article
Du, H., Li, Z. Numerical analysis of dynamic behavior of RC slabs under blast loading. Trans. Tianjin Univ. 15, 61–64 (2009). https://doi.org/10.1007/s12209-009-0012-7
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12209-009-0012-7