Abstract
Analyses on the gas dispersion from a vent mast have been conducted using fire dynamics simulator (FDS) for a 50000 dead weight tonnage (DWT) gas-fueled bulk carrier, under the assumption that methane and propane gases are discharged through a pressure relief valve in the vent system of the fuel storage tank. To assess the transient flammable extents for representative vent scenarios, the initial conditions of venting gases were selected as propane at–30 °C and methane at–150 °C, when wind velocity was set to 2 m/s in the ship exterior. The same ship layout was applied in each of these scenarios with different configurations of the inner components of the vent mast outlet. As a result, the cases with a plate head in the current vent mast outlet did not satisfy international code requirements for the safety distance of the vent mast location in ships powered by low-flashpoint fuels. However, the flammable extents of the venting gases could be significantly reduced by a novel vent system in which a swirl head and nitrogen diluent at 20 °C were adopted. Therefore, a safety design procedure considering gas dispersion characteristics was required to determine the location of the vent mast outlet in the gas-fueled vessel to satisfy the minimum requirements of the international code.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
International Maritime Organization, http://www.imo.org/en/OurWork/Environment/PollutionPrevention/AirPollution/Pages/Default.aspx.
International Maritime Organization, 2014 guidelines on the method of calculation of the attained energy efficiency design index (EEDI) for new ships, Resolution MEPC, 245(66) (2014).
B. C. Choi and Y. M. Kim, Thermodynamic analysis of a dual loop heat recovery system with trilateral cycle applied to exhaust gases of internal combustion engine for propulsion of the 6800 TEU container ship, Energy, 58 (2013) 404–416.
B. C. Choi, Thermodynamic analysis of a transcritical CO2 heat recovery system with 2-stage reheat applied to cooling water of internal combustion engine for propulsion of the 6800 TEU container ship, Energy, 107 (2016) 532–541.
International Maritime Organization, 2013 interim guidelines for determining minimum propulsion power to maintain the manoeuvrability of ships in adverse conditions, Resolution MEPC, 232(65) (2013).
International Maritime Organization, International code of safety for ships using gases or other low-flashpoint fuels (IGF Code), Resolution MSC, 391(95) (2015).
BSI Standards Publication, Explosive atmospheres Part 10–1: Classification of areas — Explosive gas atmospheres, BS EN 60079-10-1 (2015).
J. H. Kim, D. H. Doh and B. C. Choi, Evaluation of the ventilation safety requirements for the fuel gas supply system room of a gas-fueled vessel: Simulated leaks of methane and propane, J. of Mechanical Science and Technology, 32(11) (2018) 5521–5532.
Thunderhead Engineering, Pyrosim User Manual (2016).
K. McGrattan, S. Hostikka, R. McDermott, J. Floyd, C. Weinschenk and K. Overholt, Fire dynamic simulator user’s guide, NIST Special Publication 1019, 6th edition (2017).
B. C. Choi, K. H. Park and D. H. Doh, Impacts of cold gas temperature and cylindrical obstacles on the dispersing flammable limits of accidental methane releases in an LNG bunkering terminal, J Hazard Mater., 355 (2018) 104–110.
K. McGrattan, S. Hostikka, R. McDermott, J. Floyd, C. Weinschenk and K. Overholt, Fire dynamic simulator technical reference guide volume 1: Mathematical model, NIST special publication 1018-1, 6th edition (2017).
The MathWorks, Inc., MATLAB R2015a (2015).
Acknowledgments
This research was supported by Basic Science Research Program through the National Research Foundation of Korea (NRF), (No.2017R1A2B2010603) and (2018R1A2B6009387). Further, this has been also supported by the program of WC300 R&D Program (S2415805) of MOTIE and Regional Economy Cooperation Program (R0006261) and the Business Cooperative R&D Program (R0006323) of SMBA.
Author information
Authors and Affiliations
Corresponding author
Additional information
Recommended by Associate Editor Simon Song
Deog-Hee Doh earned his B.S. and M.S. degrees in the Dept. of Marine Eng. at Korea Maritime & Ocean Univ. (KMOU) in 1985 and 1988, respectively. He received his Ph.D. degree in the Dept. of Mech. Eng. at the Univ. of Tokyo, Japan, in 1995. He is currently a Professor in the Div. of Mech. Eng. at KMOU. His research interests are flow visualizations, marine and offshore machinery, digital twining technology.
Byung Chul Choi earned B.S. and M.S. degrees in mechanical engineering from Korea Maritime University, in 2002 and 2004, respectively. In 2010, he earned Ph.D. degree in mechanical engineering from Seoul National University. He works as a Senior Researcher for Korean Register of Shipping. His research interest includes the areas of fundamentals of combustion, internal combustion engine, thermal energy conversion & storage, and fire & explosion safety.
Rights and permissions
About this article
Cite this article
Doh, DH., Chun, K.W., Ninomiya, N. et al. A swirl static mixer with diluent for reducing the flammable extent of venting gases in a low-flashpoint fueled vessel. J Mech Sci Technol 33, 3311–3321 (2019). https://doi.org/10.1007/s12206-019-0626-1
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-019-0626-1