Abstract
Ammonia/urea selective catalytic reduction (SCR) is an efficient technology to control NOx emission from diesel engines. One of the critical challenges of SCR systems is its lack of catalytic activities in low temperature conditions such as cold start or warm-up periods. In this study, the effect of pipe insulation on the reduction of exhaust temperature drop was experimentally investigated based on dynamometer tests with a heavy-duty non-road diesel engine. The temperature drop of exhaust gas was measured with and without applying pipe insulation. Measurement results revealed that the effect of insulation on the mitigation of temperature loss becomes significant as engine brake power decreases. Thus, it is expected that the need for pipe insulation would be increased to keep SCR deNOx efficiency high, especially at low temperature conditions. Also, this study carried out numerical simulations to quantify the impact of pipe insulation on NOx conversion efficiency of a commercial SCR catalyst over a scheduled non-road transient cycle (NRTC) mode. Under the current heavy-duty non-road engine and SCR conditions, the application of pipe insulation would reduce 19.5 % of total cumulative tail-out NOx emission over NRTC hot mode. These results led to the cycle-averaged SCR efficiency of 98.2 % for ‘with insulation’, while it was predicted to be lowered to 97.6 % for ‘without insulation’.
Similar content being viewed by others
References
https://www.dieselnet.com/tech/diesel_engines.php.
T. Johnson and A. Joshi, Review of vehicle engine efficiency and emissions, SAE Technical Paper 2018–01–0329 (2018).
T. Johnson and A. Joshi, Review of vehicle engine efficiency and emissions, SAE Technical Paper 2017–01–0907 (2017).
https://www.dieselnet.com/standards/us/nonroad.php.
https://www.dieselnet.com/standards/eu/nonroad.php.
M. Barreau, M.L. Tarot, D. Duprez, X. Courtois and F. Can, Remarkable enhancement of the selective catalytic reduction of NO at low temperature by collaborative effect of ethanol and NH3 over silver supported catalyst, Appl. Catal. B: Environ., 220 (2018) 19–30.
J. Wang, H. Zhao, G. Haller and Y. Li, Recent advances in the selective catalytic reduction of NOx with NH3 on Cu–Chabazite catalysts, Appl. Catal. B: Environ., 202 (2017) 346–354.
H. J. Dan and J. S. Lee, Modeling and measurement of boiling point elevation during water vaporization from aqueous urea for SCR applications, J. Mech. Sci. Tech., 30 (3) (2016) 1443–1448.
S. D. Yim, S. J. Kim, J. H. Baik, I. S. Nam, Y. S. Mok, J. H. Lee, B. K. Cho and S. H. Oh, Decomposition of urea into NH3 for the SCR process, Ind. Eng. Chem. Res., 43 (16) (2004) 4856–4863.
M. Koebel, M. Elsener and M. Kleemann, Urea–SCR: a promising technique to reduce NOx emissions from automotive diesel engines, Catal. Today, 59 (3–4) (2000) 335–345.
G. Busca, L. Lietti, G. Ramis and F. Berti, Chemical and mechanistic aspects of the selective catalytic reduction of NOx by ammonia over oxide catalysts: A review, Appl. Catal. B: Environ., 18 (1–2) (1998) 1–36.
https://www.dieselnet.com/tech/cat_scr.html.
W. Kim, D. J. Lee and S. W. Park, Experimental study on optimization of over–fire air in modified combustion condition with selective catalytic reduction, J. Mech. Sci. Tech., 25 (4) (2011) 901–909.
http://www.dieselnet.com/standards/cycles/nrtc.php.
T. J. Wang, S. W. Baek, H. J. Kwon, Y. J. Kim, I. S. Nam, M. S. Cha and G. K. Yeo, Kinetic parameter estimation of a commercial Fe–zeolite SCR, Ind. Eng. Chem. Res., 50 (5) (2011) 2850–2864.
T. J. Wang, D. S. Kim and T. S. Ahn, Simulation study on improving the selective catalytic reduction efficiency by using the temperature rise in a non–road transient cycle, Proc. Inst. Mech. Eng., Part D: J. Auto. Eng., 231 (6) (2017) 810–827.
T. J. Wang, S. W. Baek, M. G. Jung and G. K. Yeo, A study of NH3 adsorption/desorption characteristics in the monolithic NH3–SCR reactor, Trans. Korean Soc. Auto. Eng., 14 (3) (2006) 125–132.
L. Lietti, I. Nova, S. Camurri, E. Tronconi and P. Forzatti, Dynamics of the SCR–DeNOx reaction by the transientresponse method, AIChE J., 43 (10) (1997) 2559–2570.
Author information
Authors and Affiliations
Corresponding author
Additional information
Recommended by Associate Editor Hanho Song
Tae Joong Wang obtained his M.S. (2003) and Ph.D. degrees (2008) in Mechanical, Aerospace and System engineering in Korea Advanced Institute of Science and Technology (KAIST). Currently, he is a Chief Researcher in Aftertreatment System Development part of Doosan Infracore (Co., Ltd.), Incheon, South Korea.
Rights and permissions
About this article
Cite this article
Wang, T.J. Effects of insulation on exhaust temperature and subsequent SCR efficiency of a heavy-duty diesel engine. J Mech Sci Technol 33, 923–929 (2019). https://doi.org/10.1007/s12206-019-0149-9
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-019-0149-9