Output power characteristic of WEC for a buoy

Abstract

Floating devices, such as a cavity resonance device, take advantage of both the water motion and the wave induced motions of the floating body itself. In the design of a wave energy converter (WEC), the most significant factor is that an optimum length of the internal water column should exists, that is, a length in which maximum power is converted near the heaving resonance. A theoretical analysis of this power generated by a pneumatic-type WEC is performed, and the results obtained from the analysis are used for a real WEC for a buoy. The length of the internal water column corresponds to that of the water mass in the water column. If designed properly, a WEC can take advantage not only of the cavity resonance but also of the heaving motion of the buoy. This paper presents the test results of the generation characteristic of a WEC and the harmful effect of fouling in the internal water column. The results are then applied to the design of a WEC for a buoy.

This is a preview of subscription content, access via your institution.

References

  1. [1]

    M. E. McCormick, Analysis of a wave energy conversion buoy, Journal of. Hydronautics 8(3) (1974) 77–82.

    Article  Google Scholar 

  2. [2]

    A. Thakker, Z. Usmani and T. S. Dhanasekaran, Effects of turbine damping on performance of an impulse turbine for wave energy conversion under different sea conditions using numerical simulation techniques, Journal of Renewable Energy 29(14) (2004) 2133–2151.

    Article  Google Scholar 

  3. [3]

    M. E. McCormick, B. H. Carson and D. H. Rau, An experimental study of a wave energy conversion buoy, Journal of Marine Technology Society 9(3) (1975) 40–42.

    Google Scholar 

  4. [4]

    M. E. McCormick, A modified linear analysis of a wave energy conversion buoy, Journal of Ocean Engineering 3(4) (1976) 133–144.

    Article  Google Scholar 

  5. [5]

    M. E. McCorimick, Ocean wave energy conversion, Wiley-Interscience, New York, USA, (1981) 45–75.

    Google Scholar 

  6. [6]

    A. F. de O. Falcao and R. J. A. Rodrigues, Stochastic modeling of OWC wave power plant performance, Journal of Applied Ocean Research 24(2) (2002) 59–71.

    Article  Google Scholar 

  7. [7]

    Y. Huang, M. Lwata, M. Usami and K Ueda, A study on the antifouling technique through seawater electrolysis on structural surface, Proceedings of 9th International Offshore and Polar Engineering Conference (1999) 146–150.

  8. [8]

    X. Xiaokai, M. Chongfang and C. Yongchang, Investigation on the electric anti-fouling technology for scale prevention, Journal of Chemical Engineering and Technology 28(12) (2005) 1540–1545.

    Article  Google Scholar 

  9. [9]

    J. C Cowan and D. J. Weingritt, Water-formed scale deposits, Gulf Publishing Company, Huston, USA, (1976)

    Google Scholar 

Download references

Author information

Affiliations

Authors

Corresponding author

Correspondence to Jin-Seok Oh.

Additional information

This paper was recommended for publication in revised form by Associate Editor Jae Young Lee

Jin-Seok Oh was born in Kyung-Nam, Korea. He received the B. E. degree in Marine Engineering from Korea Maritime University in 1983. Since 1983, he has been with the Zodiac (England Company) including early 4 years of System Engineer. He received the M.E. and Ph. D. degrees from Korea Maritime University, Busan, Korea in 1989 and 1996, respectively. He had been with the Agency for Defense Development (ADD) as a researcher from 1989 to 1992. In 1996, he joined the Division of Mechatronics Engineering at Korea Maritime University. His research interests include electrical drive systems, robot control and PC-based Control applications.

Rights and permissions

Reprints and Permissions

About this article

Cite this article

Oh, JS., Kwak, JH., Bae, SY. et al. Output power characteristic of WEC for a buoy. J Mech Sci Technol 23, 1571–1575 (2009). https://doi.org/10.1007/s12206-009-0412-6

Download citation

Keywords

  • WEC
  • Resonance
  • Fouling