Abstract
A reversed trapezoidal fin with variable fin base thickness is optimized based on the fixed fin volume by using a two-dimensional analytic method. The variation of temperature along the normalized Y position at the fin tip is presented. For fixed fin volumes, the maximum heat loss, the corresponding optimum fin effectiveness, fin base height and fin tip length as a function of the fin base thickness, fin shape factor and the fin volume are presented. One of the results shows that both the optimum heat loss and the optimum fin length increase with the increase of the value of fin shape factor.
Similar content being viewed by others
References
A. K. Sen and S. Trinh, An exact solution for the rate of heat transfer from a rectangular fin governed by a power law-type temperature dependence, ASME J. of Heat Transfer 108 (1986) 457–459.
S. Abrate and P. Newnham, Finite element analysis of triangular fins attached to a thick wall, Computers and Structures 57(6) (1995) 945–957.
S. Sikka and M. Iqbal, Temperature distribution and effectiveness of a two-dimensional radiating and convecting circular fin, AIAA Journal 8(1) (1970) 101–106.
R. H. Yeh, An analytical study of the optimum dimensions of rectangular fins and cylindrical pin fins, Int. J. of Heat and Mass Transfer 40(15) (1997) 3607–3615.
L. T. Yu and C. K. Chen, Optimization of circular fins with variable thermal parameters, Journal of The Franklin Institute 336(B) (1999) 77–95.
H. S. Kang and D. C. Look Jr., Optimization of a thermally asymmetric convective and radiating annular fin, Heat Transfer Engineering 28(4) (2007) 310–320.
A. Bejan and M. Almogbel, Constructal T-shaped fins, Int. J. of Heat and Mass Transfer 43 (2000) 2101–2115.
B, Kundu and P. K. Das, Performance analysis and optimization of elliptical fins circumscribing a circular tube, Int. J. of Heat and Mass Transfer 50 (2007) 173–180.
D. C. Look, Separation of variables on a triangular geometry, Q. J. appl. Math. 1 (1992) 141–148.
H. S. Kang and D. C. Look Jr., A comparison of four solution methods for the analysis of a trapezoidal fin, KSME International Journal 13(6) (1999) 487–495.
C. H. Cho., Y. M. Han and H. S. Kang, Comparison between analytic method and experimentation on the trapezoidal fin, Journal of Industrial Technology 25(A) (2005) 75–80.
H. S. Kang, Optimization of a reversed trapezoidal fin, Journal of KSME(B) 30(10) (2006) 987–995.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kang, H.S. Optimization of a reversed trapezoidal fin using a 2-D analytic method. J Mech Sci Technol 22, 556–564 (2008). https://doi.org/10.1007/s12206-007-1038-1
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-007-1038-1