Abstract
Spent activated carbon is a common by-product of pollution treatment with granular activated carbon (GAC) adsorption and therefore spent activated carbon treatment for reuse is critical to maximize cost-effectiveness and sustainability. Superheated steam regeneration is a novel treatment technology that uses water vapor and is more energy- and cost-efficient than other thermal regeneration methods. This work has value in that two modes of operation are compared in a small-scale process, whose experiment is well designed to reflect its large-scale process. Our study evaluated the effects of superheated steam regeneration on phenol-saturated activated carbon using a rapid small-scale column test (RSSCT) and evaluated this approach with the conventional chemical regeneration method. Our findings indicated that superheated steam regeneration achieved optimal performance at 500°C for 60 min, whereas chemical regeneration performance was optimal using 4% NaOH coupled with a low flow rate. Based on these observations, cyclic adsorption/regeneration tests were conducted six times. Additionally, differences on the carbon surface after regeneration were explored via scanning electron microscopy (SEM). The results indicated that superheated steam was more efficient and rendered cleaner carbon surfaces.
Similar content being viewed by others
References
Aktaş O, Çeçen F (2006) Effect of activation type on bioregeneration of various activated carbons loaded with phenol. Journal of Chemical Technology and Biotechnology 81:1081–1092, DOI: https://doi.org/10.1002/jctb.1472
Álvarez PM, Beltrán FJ, Gómez-Serrano V, Jaramillo J, Rodríguez EM (2004) Comparison between thermal and ozone regenerations of spent activated carbon exhausted with phenol. Water Research 38(8):2155–2165, DOI: https://doi.org/10.1016/j.watres.2004.01.030
Ania CO, Menéndez JA, Parra JB, Pis JJ (2004) Microwave-induced regeneration of activated carbons polluted with phenol. A comparison with conventional thermal regeneration. Carbon 42(7):1383–1387, DOI: https://doi.org/10.1016/j.carbon.2004.01.010
Bandosz TJ (2006) Activated carbon surfaces in environmental remediation. Academic Press, Cambridge, MA, USA, 275–277
Bartholomew CH, Farrauto RJ (2008) Fundamentals of industrial catalytic processes, 2nd edition. John Wiley & Sons Inc., Hoboken, NJ, USA, 314–317
Berenguer R, Marco-Lozar JP, Quijada C, Cazorla-Amorós D, Morallón E (2010) Electrochemical regeneration and porosity recovery of phenol-saturated granular activated carbon in an alkaline medium. Carbon 48(10):2734–2745, DOI: https://doi.org/10.1016/j.carbon.2010.03.071
Cooney DO, Nagerl A, Hines AL (1983) Solvent regeneration of activated carbon. Water Research 17(4):403–410, DOI: https://doi.org/10.1016/0043-1354(83)90136-7
Duan X, Srinivasakannan C, Liang J (2014) Process optimization of thermal regeneration of spent coal based activated carbon using steam and application to methylene blue dye adsorption. Journal of the Taiwan Institute of Chemical Engineers 45(4):1618–1627, DOI: https://doi.org/10.1016/j.jtice.2013.10.019
Dutta T, Kim TJ, Vellingiri K, Tsang DCW, Shon JR Kim KH, Kumar S (2019) Recycling and regeneration of carbonaceous and porous materials through thermal or solvent treatment. Chemical Engineering Journal 364:514–529, DOI: https://doi.org/10.1016/j.cej.2019.01.049
Fan J (2018) Numerical study of particle transport and deposition in porous media. PhD Thesis, INSA de Rennes, Rennes, France
Garcia-Rodriguez O, Villot A, Olvera-Vargas H, Gerente C, Andres Y, Lefebvre O (2020) Impact of the saturation level on the electrochemical regeneration of activated carbon in a single sequential reactor. Carbon 163:265–275, DOI: https://doi.org/10.1016/j.carbon.2020.02.041
Guymont F (1980) The effect of capital and operating costs on GAC adsorption system design. In: Activated carbon adsorption of organics from the aqueous phase. Ann Arbor Science, Saline, MI, USA, 531–538
Hamdaoui O, Naffrechoux E, Suptil J, Fachinger C (2015) Ultrasonic desorption of p-chlorophenol from granular activated carbon. Chemical Engineering Journal 106(2):153–161, DOI: https://doi.org/10.1016/j.cej.2004.10.010
He W, Lü G, Cui J, Wu L, Liao L (2012) Regeneration of spent activated carbon by yeast and chemical method. Chinese Journal of Chemical Engineering 20(4):659–664, DOI: https://doi.org/10.1016/S1004-9541(11)60232-2
Henke JL, MSE, Speitel GE (1998) Performance evaluation of granular activated carbon system at pantex: Rapid small-scale column tests to simulate removal of high explosives from contaminated groundwater. ANRCP-1998-10, University of Texas at Austin, Austin, TX, USA
Himmelstein KJ, Fox RD, Winter TH (1973) In-place regeneration of activated carbon. Chemical Engineering Progress 69(11):65–69
Ioannidou O, Zabaniotou A (2007) Agricultural residues as precursors for activated carbon production — A review. Renewable & Sustainable Energy Reviews 11(9):1966–2005, DOI: https://doi.org/10.1016/j.rser.2006.03.013
Lee SH, Kwon DY (2015) Development of activated carbon autoregeneration system for water treatment filtration. Desalination and Water Treatment 57(17):8026–8032, DOI: https://doi.org/10.1080/19443994.2015.1080630
Li W, Yue Q, Tu P, Ma Z, Gao B, Li J, Xu X (2011) Adsorption characteristics of dyes in columns of activated carbon prepared from paper mill sewage sludge. Chemical Engineering Journal 178:197–203, DOI: https://doi.org/10.1016/j.cej.2011.10.049
Lu P, Lin H, Yu W, Chern J (2011) Chemical regeneration of activated carbon used for dye adsorption. Journal of the Taiwan Institute of Chemical Engineers 42(2):305–311, DOI: https://doi.org/10.1016/j.jtice.2010.06.001
Marques SCR, Marcuzzo JM, Baldan MR, Mestre AS, Carvalho AP (2017) Pharmaceuticals removal by activated carbons: Role of morphology on cyclic thermal regeneration. Chemical Engineering Journal 321:233–244, DOI: https://doi.org/10.1016/j.cej.2017.03.101
Martin RJ, Ng WJ (1984) Chemical regeneration of exhausted activated carbon — I. Water Research 18(1):59–73, DOI: https://doi.org/10.1016/0043-1354(84)90048-4
Mui ELK, Ko DCK, McKay G (2004) Production of active carbons from waste types — A review. Carbon 42(14):2789–2805, DOI: https://doi.org/10.1016/j.carbon.2004.06.023
Poddar M, Nair ANB, Mahindrakar AB (2013) A review on the use of rapid small scale column test (RSSCT) on predicting adsorption of various contaminants. IOSR Journal of Environmental Science, Toxicology And Food Technology 3(1):77–85, DOI: https://doi.org/10.9790/2402-0317785
Quan X, Liu X, Bo L, Chen S, Zhao Y, Cui X (2004) Regeneration of acid orange 7-exhausted granular activated carbons with microwave irradiation. Water Research 38(20):4484–4490, DOI: https://doi.org/10.1016/j.watres.2004.08.031
Rinkus K, Reed BE, Lin W (1997) NaOH regeneration of Pb and phenolladen activated carbon. I. Batch study results. Separation Science and Technology 32:2367–2384, DOI: https://doi.org/10.1080/01496399708000774
Sabio E, González E, González JF, González-García CM, Ramiro A, Gañan J (2004) Thermal regeneration of activated carbon saturated with p-nitrophenol. Carbon 42(11):2285–2293, DOI: https://doi.org/10.1016/j.carbon.2004.05.007
Salvador F, Martin-Sanchez N, Sanchez-Hernandez R, Sanchez-Montero MJ, Izquierdo C (2015) Regeneration of carbonaceous adsorbents. Part II: Chemical, microbiological and vacuum regeneration. Microporous and Mesoporous Materials 202:277–296, DOI: https://doi.org/10.1016/j.micromeso.2014.08.019
Shen L, Wang W, Li T, Cui Y, Wang B, Yu G, Wang X, Dong W, Xiao J, Deng S (2019) Powdered activated coke for COD removal in the advanced treatment of mixed chemical wastewaters and regeneration by Fenton oxidation. Chemical Engineering Journal 371:631–638, DOI: https://doi.org/10.1016/j.cej.2019.04.086
Suksabye P, Thiravetyan P, Nakbanpote W (2008) Column study of chromium (VI) adsorption from electroplating industry by coconut coir pith. Journal of Hazardous Materials 160(1):56–62, DOI: https://doi.org/10.1016/j.jhazmat.2008.02.083
Sun K, Jiang J, Xu J (2009) Decoloration and chemical regeneration of granular activated carbon used in citric acid refining. Bulletin of the Chemical Society of Ethiopia 23(1):29–36, DOI: https://doi.org/10.4314/bcse.v23i1.21295
Sun Y, Zhang B, Zheng T, Wang P (2017) Regeneration of activated carbon saturated with chloramphenicol by microwave and ultraviolet irradiation. Chemical Engineering Journal 320:264–270, DOI: https://doi.org/10.1016/j.cej.2017.03.007
Sutlkno T, Himmelstein KJ (1983) Desorption of phenol from activated carbon by solvent regeneration. Industrial & Engineering Chemistry Fundamentals 22(4):420–425, DOI: https://doi.org/10.1021/i100012a011
Tammuski WZ, Mirera J, Borowski P, Klepacka A (1996) Energy analysis on use of air and superheated steam as drying media. Drying Technology 14(78):1733–1749, DOI: https://doi.org/10.1080/07373939608917170
Willmott CJ (1981) On the validation of models. Physical Geography 2(2):184–194, DOI: https://doi.org/10.1080/02723646.1981.10642213
Willmott CJ, Ackleson SG, Davis RE, Feddema JJ, Klink KM, Legates DR, O’Donnell J, Rowe CM (1985) Statistics for the evaluation and comparison of models. Journal of Geophysical Research 90(C5): 8995–9005, DOI: https://doi.org/10.1029/JC090iC05p08995
Acknowledgments
The authors thank Wintec Glovis. Co., Ltd for kindly providing valuable technical support during our steam regeneration experiments.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Ying, X., Kim, G., Han, I. et al. High Efficiency Regeneration Performance of Exhausted Activated Carbon by Superheated Steam and Comparison with Conventional Chemical Regeneration Method. KSCE J Civ Eng 26, 2058–2067 (2022). https://doi.org/10.1007/s12205-022-1454-x
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12205-022-1454-x