Skip to main content
Log in

Study on Drilling Ground Collapse Induced by Groundwater Flow and Prevention Based on a Coupled CFD-DEM Method

  • Geotechnical Engineering
  • Published:
KSCE Journal of Civil Engineering Aims and scope

Abstract

Given the hazards caused by drilling ground collapse (DGC) due to groundwater flow in the processes of geotechnical engineering investigation, a coupled computational fluid dynamics and discrete element method (CFD-DEM) method is adopted to numerically simulate the development of hazards. An improved coupling program is employed to realize the two-way coupling between open-source CFD code OpenFOAM and commercial DEM software PFC3D. The coupling program allows complex meshes generated by ANSYS ICEM to be imported into PFC3D. The feasibility and accuracy of the CFD-DEM method are first verified by simulating a single spherical particle settling in hydrostatic water and the formation of the repose angle of sandpiles. Then, this method is adopted to investigate the patterns of stratum deformation and foundation loss, typical particle flow processes, and characteristics of drilling rig toppling. Finally, measures for prevention of DGC induced by groundwater flow are discussed in detail. Two typical strata, including a water-rich sand stratum and a water-rich sand-clay compound stratum, are considered. The research results show that for the water-rich sand stratum, DGC induces a “bowl”-shaped settlement trough, and the maximum value of ground surface settlement is proportional to the foundation loss rate. For the water-rich sand-clay compound stratum, a “jar”-shaped settlement trough is created. Four typical particle flow processes are involved in DGC. The drilling rig topples toward the center of the settlement trough. The maximum displacement appears at the top of the tower and has an approximate linear correlation with the groundwater flow velocity. The measures and methods of DGC prevention are also summarized in detail. The results of this research provide a reference for hazard prevention and delicacy control of DGC induced by groundwater flow.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

Abbreviations

CFD:

Computational fluid dynamics

DEM:

Discrete element method

DGC:

Drilling ground collapse

DNS:

Direct numerical simulation

E-E:

Eulerian-Eulerian

E-L:

Eulerian-Lagrangian

FVM:

Finite volume method

LBM:

Lattice Boltzmann method

N-S:

Navier-Stokes

PNM:

Pore network model

TCP:

Transmission control protocol

TFM:

Two-fluid model

References

Download references

Acknowledgments

This research was supported by the Science and Technology Project of Ministry of Housing and Urban-Rural Development (No. 2016-K4-056) and Groundwater Safety Control Technology for Urban Rail Transit Project Construction (No. 3-4-2018-008). The authors gratefully acknowledge the support by Furtney J and Netkidxp CN. Additionally, the authors would like to acknowledge the anonymous reviewers for their valuable comments and suggestions, which helped to significantly improve the quality of this paper.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Chang-qing Liu.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Zhou, Ht., Liu, Cq., Wang, Gh. et al. Study on Drilling Ground Collapse Induced by Groundwater Flow and Prevention Based on a Coupled CFD-DEM Method. KSCE J Civ Eng 26, 2112–2125 (2022). https://doi.org/10.1007/s12205-022-1061-x

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s12205-022-1061-x

Keywords

Navigation