Abstract
Although Concrete-filled Steel Tubular (CFST) arch support technology for transportation tunnels and mining roadways is developing rapidly, research regarding the determination of the bearing capacity of the CFST arch support is still limited. Based on a literature analysis, the definition and expression form of the bearing capacity of CFST supporting arch Q u was clarified, and determination approaches via laboratory testing and theoretical calculation methods were recommended. Full-size mechanical tests of CFST arches were performed by adhering to the suggested loading pattern that uses a number of hydraulic cylinders along the arch profile to simulate the surrounding rock pressure. The failure mode of the arches was determined as elastic-plastic instability with an extreme point. The critical criterion of global instability for the tested arch was proposed as the critical CFST section reaching the compression-bending limit. Based on the above criterion, a specific process for determining the Q u by theoretical calculation was proposed. Calculation examples show that the calculation results deviations were less than 4% compared with the tests results, and the reliability and accuracy of the new theoretical approach were thus verified. Finally, the limitations of the calculation method were noted.
Similar content being viewed by others
References
AISIS100-2007 (2007). Specification for the design of coldformed steel structural members, Washington DC:American Iron and Steel Institute.
AS/NZS4600:2005 (2005). Cold-formed steel structures, Sydney: Standards Australia /Standards New Zealand.
Chang, X., Luo, X. L., Zhu, C. X., and Tang, C. (2014). “Analysis of circular Concrete-filled Steel Tube (CFT) support in high ground stress conditions.” Tunnelling and Underground Space Technology, Vol. 43, No. 7, pp. 41–48, DOI: 10.1016/j.tust.2014.04.002.
Chen, B. C., Wang, L. Y., Ou, Z. J., and Han, L. H. (2003). “Experimental study of stress-stain relation of eccentrically-loaded concrete-filled steel tubular columns.” Engineering Mechanics, Vol. 20, No. 6, pp. 154–159.
Chen, Q. J., Yang, S. K., and Zhou, W. D. (2014). “Research on experiment about applying new type of concrete-filled steel tube stand into soft rock tunnel reinforcement.” Journal of Henan Polytechnic University (Natural Science), Vol. 33, No. 5, pp. 582–589.
Fu, H. X. (1984). “Application of concrete filled steel arch in tunnel with unfavorable geology.” Railway standard design, Vol. 1984, No. 3, pp. 11–15.
Gao, Y. F., Wang, B., Wang, J., Li, B., Xing, F., Wang, Z. G., and Jin, T. L. (2010). “Test on structural property and application of concretefilled steel tube support of deep mine and soft rock roadway.” Chinese journal of rock mechanics and engineering, Vol. 29, No. S1, pp. 2604–2609.
Gao, Y. F., Wang, J., Huang, W. P., Chen, B. F., Wang, L., and Wang, C. (2014). “Experiment on mechanical property of straight-wall semicirclearch concrete-filled steel tube support and its application.” Tunnel Construction, Vol. 34, No. 1, pp. 6–12, DOI: 10.3973/j.issn.1672-741X.2014.01.002.
GB 50936-2014 (2014). Technical code for concrete filled steel tubular structures, National standards of P.R. China, China Construction Industry Press, Beijing, China.
Gu, S. C. and Liu, H. D. (2009). “Applied research on concrete filled steel tube support of subway tunnel.” Railway Engineering, No. 12, pp. 56–60.
Han, L. H. and Yang, Y. F. (2007). Modern steel tube confined concrete structures technology, China Architecture & Building Press, Beijing, China.
He, M. C. (2014). “Progress and challenges of soft rock engineering in depth.” Journal of China Coal Society, Vol. 39, No. 8, pp. 1409–1407, DOI: 10.13225/j.cnki.jccs.2014.9044.
He, M. C., Gong, W. L., Wang, J., Qi, P., Tao, Z.G., Du, S., and Peng, Y. Y. (2014). “Development of a novel energy-absorbing bolt with extraordinarily large elongation and constant resistance.” International Journal of Rock Mechanics and Mining Sciences, Vol. 67, pp. 29–42, DOI: 10.1016/j.ijrmms.2014.01.007.
Huang, W. P., Gao, Y. F., and Wang, J. (2014). “Deep rock tunnel’s long large deformation mechanism and control technology under disturbance effects.” Journal of China Coal Society, Vol. 39, No. 5, pp. 822–828, DOI: 10.13225/j.cnki.jccs.2013.0752.
Jiao, Y. Y., Song, L., Wang, X. Z., and CoffiAdoko, A. C. (2013). “Improvement of the U-shaped steel sets for supporting the roadways in loose thick coal seam.” International Journal of Rock Mechanics and Mining Sciences, Vol. 60, No. 2, pp. 19–25, DOI: 10.1016/j.ijrmms.2012.12.038.
Kang, H. P. (2014). “Support technologies for deep and complex roadways in underground coal mines: A review.” International Journal of Coal Science and Technology, Vol. 1, No. 3, pp. 261–277, DOI: 10.1007/s40789-014-0043-0.
Khan, U. H., Mitri, H. S., and Jones, D. (1996). “Full scale testing of steel arch tunnel supports.” International Journal of Rock Mechanics and Mining Sciences, Vol. 33, No. 3, pp. 219–232, DOI: 10.1016/0148-9062(95)00065-8.
Li, C. C. (2010). “A new energy–absorbing bolt for rock support in high stress rock masses.” International Journal of Rock Mechanics and Mining Sciences, Vol. 47, No. 3, pp. 396–404, DOI: 10.1016/j.ijrmms.2010.01.005.
Li, W. T. (2014). Failure mechanism of deep soft roadway bearing structure and quantitative yieldabal confined concrete arch support system, Shandong University, Jinan, China.
Li, W. T., Li, S. C., Xuan, C., Wang, Q., Wang, X., and Shao, X. (2015a). “Mechanism and control of failure of rock roadway support in highly stressed soft rock.” Chinese Journal of Rock Mechanics and Engineering, Vol. 34, No. 9, pp. 1836–1848, DOI: 10.13722/j.cnki.jrme.2014.1594.
Li, W. T., Wang, Q., Li, S. C., Yang, N., Wang, X., and Shao, X. (2015b). “Test study on bending properties of casing joint of square confined concrete arch support.” Journal of China University of Mining & Technology, Vol. 44, No. 6, pp. 1073–1083, DOI: 10.13247/j.cnki. jcumt.000425.
Li, X. B., Yang, R. S., Gao, Y. F., He, X. S., and Wang, C. (2013). “Highstrength steel tubular confined concrete supports support technology for large section soft rock inclined shaft.” Journal of China Coal Society, Vol. 38, No. 10, pp. 1742–1748, DOI: 10.13225/j.cnki.jccs.2013.10.018.
Li, Y. Q., Li, G. W., Shen, Z. Y., Ma, Y. F., and Zhu, S. W. (2015c). “Modification method for yield strength of cold-formed thickwalled steel sections considering cold-forming effect.” Journal of Building Structures, Vol. 36, No. 5, pp. 1–7, DOI: 10.14006/j.jzjgxb.2015.05.001.
Liu, G. L. (2013). Research on Steel tube confined concrete supports capability and soft rock roadway compression ring strengthening supporting theory, China University of Mining & Technology, Beijing, China.
Shanmugan, N. E. and Lakshmi, B. (2001). “State of the art report onsteel-concrete composite columns.” Journal of Constructional Steel Research, Vol. 57, No. 10, pp. 1041–1080, DOI: 10.1016/S0143-974X(01)00021-9.
Sun, J. and Wang, S. J. (2000). “Rock mechanics and rock engineering in China: Developments and current state-of-the-art.” International Journal of Rock Mechanics and Mining Science, Vol. 37, No. 3, pp. 447–465, DOI: 10.1016/S1365-1609(99)00072-6.
Wang, Q., Jiang, B., Li, Y., Shao, X., Wang, F. Q., Li, S. C., Zhang, S. G., and Ruan, G. Q. (2015). “Mechanical behaviors analysis on a square-steel-confined-concrete arch centering and its engineering application in a mining project.” European Journal of Environmental and Civil Engineering, DOI: 10.1080/19648189.2015.1124809.
Wang, Q. (2015). Study on square-steel confined-concrete support system and its application in deep and complex roadways, Proc., 4th Sino-Russian Joint Scientific-Technical Forum on Deep-level Mining Rock Dynamics, Chinese Society for Rock Mechanics and Engineering, Weihai, China.
Wang, Q., Jiang, B., Li, S. C., Wang, D. C., Wang, F. Q., Li, W. T., Ren, Y. X., Guo, N. B., and Shao, X. (2016). “Experimental studies on the mechanical properties and deformation & failure mechanism of Utype confined concrete arch centering.” Tunnelling and Underground Space Technology, Vol. 51, pp. 20–29, DOI: 10.1016/j.tust.2015.10.010.
Wei, J. J. and Jiang, B. S. (2013). “Experimental study on structural property of contractible concrete-filled steel tube support.” Journal of Mining and Safety Engineering, Vol. 30, No. 6, pp. 805–811.
Wu, Y. X. and Yu, Q. (2005). “Test on pure bending mechanical performance of steel tube confined high–prerformance concrete.” Journal of Harbin institute of technology, Vol. 37, No. S, pp. 276–279.
Yang, X. J., Pang, J. W., Liu, D. M., Yang, L., Tian, Y. H., Ma, J., and Li, S. H. (2013). “Deformation mechanism of roadways in deep soft rock at Hegang Xing’an Coal Mine.” International Journal of Mining Science and Technology, Vol. 23, No. 2, pp. 307–312, DOI: 10.1016/j.ijmst.2013.04.002.
Zang, D. S. and Li, A. Q. (2001). “Study on concrete-filled steel tube supports.” Chinese Journal of Geotechnical Engineering, Vol. 23, No. 5, pp. 342–344.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Zhang, W., Li, W., Yang, N. et al. Determination of the bearing capacity of a Concrete-filled Steel Tubular arch support for tunnel engineering: Experimental and theoretical studies. KSCE J Civ Eng 21, 2932–2945 (2017). https://doi.org/10.1007/s12205-017-1418-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12205-017-1418-8