Energy Efficiency

, Volume 11, Issue 4, pp 955–974 | Cite as

Assessing the energy saving potential of anidolic system in the tropics

  • Floriberta Binarti
  • Prasasto Satwiko
Original Article


Employing the edge-ray principle, the anidolic system (AS) has been proven as a promising daylighting solution for various climates. However, studies on the thermal performance of an AS are still rare. Because of the dominant contribution of the space-cooling load to building energy consumption at the operational stage in hot climates, knowledge of the impact of AS application on the space-cooling load is important. This study assessed the energy-saving potential of AS in the tropics by measuring the daylight level and distribution, as well as the solar heat gain, based on Radiance and EnergyPlus simulations using weather files of two locations in the tropics—Yogyakarta and Singapore. Monitoring data of a full-scale, unoccupied test building was acquired to validate the Radiance simulations and EnergyPlus models. A comparison between the energy-saving potential for lighting and cooling of AS and conventional aperture models showed that the application of AS in the tropics benefits the daylighting performance (DF ≥ 3% and horizontal distribution 51–70%), but still produces higher solar heat gains (44–437% higher than those of clerestory only). Narrow anidolic collectors with medium angular spread (45°–52°) and maximum clerestory height equipped with internal shelves can be applied to produce lower solar heat gain or indoor air temperature (2%) with sufficient daylight levels (≥ 2%) and an increased in horizontal illuminance distribution (> 57%).


Anidolic system Daylight factor Indoor illuminance distribution Solar heat gain Tropics 



anidolic system


window area




y-m-wide, z-degree-angular spread anidolic collector installed on a x-m-height clerestory


daylight factor


temperature difference


external convective heat transfer coefficient


Adaptive Algorithm for external convective heat transfer coefficient


DOE-2 for external convective heat transfer coefficient


TARP for external convective heat transfer coefficient


MoWiTT for external convective heat transfer coefficient


indoor illuminance


outdoor illuminance


indoor surface emissivity


interior window surface emissivity


view factor from the window to the other surfaces of the room


horizontal shading


internal convective heat transfer coefficient


Adaptive Algorithm for internal convective heat transfer coefficient


TARP for internal convective heat transfer coefficient


intermediate sky with the sun


net heat transfer from the window to the room surfaces


indoor air temperature


outdoor (ambient) air temperature


window to floor area ratio


anidolic system installed on x-m-wide room


x-m-wide anidolic system installed on y-m-wide room



Authors gratefully acknowledge the Directorate of Higher Education Republic Indonesia, Ministry of Research, Technology and Higher Education in the scheme of Hibah Bersaing (the second year) under the contract number 005/HB-LIT/III/2015 (Government to University) for supporting this study.

Compliance with ethical standards

Conflict of interest

The authors declare that they have no conflict of interest.


  1. Aizlewood, M. E. (1993). Innovative daylighting systems: an experimental evaluation. Lighting Research and Technology, 25(4), 141–152.CrossRefGoogle Scholar
  2. Al-Obaidi, K. M., Ismail, M., & Abdul Rahman, A. M. (2014). A study of the impacts of environmental loads that penetrate a passive skylight roofing system in Malaysian buildings. Frontiers Architectural Research, 3, 178–191.CrossRefGoogle Scholar
  3. ASHRAE. (2013). ASHRAE Handbook: Fundamental. Atlanta: ASHRAE.Google Scholar
  4. Binarti, F. (2009). Energy-Efficient Window for Classroom in Warm Tropical Area. 11th International IBPSA Conference, Glasgow, Scotland, UK, July 27–30, 2009, pp.1655–1662.Google Scholar
  5. Binarti, F., & Dewi, S. (2016). The effectiveness of light shelf in tropical urban context. Environmental and Climate Technologies December, 18, 42–53. Scholar
  6. Binarti, F., & Satwiko, P. (2015). Long-term monitoring and simulations of the daylighting and thermal performance of an anidolic daylighting system on a tropical urban house. Energy Procedia, 78, 1787–1792. Scholar
  7. Binarti, F., & Satwiko, P. (2016). An east-facing anidolic daylighting system on a tropical urban house. Indoor and Built Environment, 25(4), 691–702. Scholar
  8. Chirarattananon, S., & Chaiwiwatworakul, P. (2007). Distribution of sky luminance and radiance of North Bangkok under standard distributions. Renewable Energy, 26, 1328–1345.CrossRefGoogle Scholar
  9. Crawley, D.B., Lawrie, L.K., Winkelmann, F.C., Buhl, W.F., Pedersen, C.O., Strand, R.K., Liesen, R.J., Fisher, D.E., Witte, M.J., Henninger, R.H., Glazer, J., & Shirey, D. (2013). EnergyPlus v.8.1. Atlanta, Georgia.Google Scholar
  10. Ellis, P. G. (2003). Development and validation of the unvented Trombe Wall model in EnergyPlus. USA: Master Thesis. University of Illinois at Urbana-Champaign.Google Scholar
  11. Erell, E., Kaftan, E., & Garb, Y. (2014). Daylighting for Visual Comfort and Energy Conservation in Offices in Sunny Regions. Proc. of 30th International PLEA Conference - Sustainable Habitat for Developing Societies, Ahmedabad, India, 16–18 December 2014.Google Scholar
  12. Goia, F. (2016). Search for the optimal window-to-wall ratio in office buildings in different European climates and the implication on total energy saving potential. Applied Energy, 132, 467–492.Google Scholar
  13. Hachem, C., Athienitis, A., & Fazio, P. (2011). Parametric investigation form effects on solar potential of housing units. Solar Energy, 85, 1864–1877.CrossRefGoogle Scholar
  14. Huang, Y., Niu, J.-L., & Chung, T.-M. (2014). Comprehensive analysis on thermal and daylighting performance of glazing and shading designs on office building envelope in cooling-dominant climates. Applied Energy, 134, 215–228.CrossRefGoogle Scholar
  15. Kleindienst, S.A. (2006). Improving the daylighting conditions of existing buildings: the benefits and limitations of integrating anidolic daylighting systems using the American classroom as a model. Master thesis, Massachusetts Institute of Technology, USA, 2006.Google Scholar
  16. Leadership in Energy and Environmental Design (LEED). (2009). Reference Guide for Green Building Design and Construction, for the Design, Construction and Major Renovations of Commercial and Institutional Building Including Core and Shell K-12 School Projects, Accessed 6 November 2010.
  17. Linhart, F., Wittkopf, S. K., & Scartezzini, J.-L. (2010). Performance of anidolic daylighting systems in tropical climates, parametric studies for identification of main influencing factors. Solar Energy, 84, 1085–1094.CrossRefGoogle Scholar
  18. Loutsenhiser, P. G., Manz, H., Felsmann, C., Strachan, P. A., Frank, T., & Maxwell, G. M. (2007). Empirical validation of models to compute solar irradiance on inclined surfaces for building energy simulation. Solar Energy, 81, 254–267.CrossRefGoogle Scholar
  19. Loutsenhiser, P. G., Manz, H., Carl, S., Simmler, H., & Maxwell, G. M. (2008). Empirical validations of solar gain models for a glazing unit with exterior and interior blind assemblies. Energy and Buildings, 40, 330–340.CrossRefGoogle Scholar
  20. Marsch, A.(2005). Ecotect Software v.5.5. Square One, Cardiff.Google Scholar
  21. McNeil, A. & Lee, E. (2012). A validation of the Radiance three phase simulation method for modeling annual daylight performance of optically complex fenestration systems. Building Performance Simulation 1–14. DOI:
  22. Michael, A., & Heracleous, C. (2016). Assessment of natural lighting performance and visual comfort of educational architecture in southern Europe: the case of typical educational school premises in Cyprus. Energy and Buildings, 140, 443–457.CrossRefGoogle Scholar
  23. Michael, A., Gregoriou, S., & Kalogirou, S. A. (2017). Environmental assessment of an integrated adaptive system for the improvement of indoor visual comfort of existing buildings. Renewable Energy, 2017.
  24. Mirsadeghi, M., Costola, D., Blocken, B., & Hensen, J. L. M. (2013). Review of external convective heat transfer coefficient models in building energy simulation programs: implementation and uncertainty. Applied Thermal Engineering, 56(1–2), 134–151.CrossRefGoogle Scholar
  25. Praditwattanakit, R., Chaiwiwatworakul, P., & Chirarattananon, S. (2013). Anidolic concentrator to enhance the daylight use in tropical buildings. In: International Conference on Alternative Energy in Developing Countries and Emerging Economies. Bangkok, Thailand, 30–31 May 2013, 139_Rut%20Praditwattanakit.docx. Accessed 7 August 2014.
  26. Prasetyo, S. S., & Kusumarini, Y. (2016). Studi Efisiensi dan Konservasi Energi pada Interior Gedung P Universitas Kristen Petra. Jurnal INTRA, 4(1), 36–45.Google Scholar
  27. Pritchard, D.C. (ed). (1986). Interior lighting design, 6th ed., London: The Lighting Industry Federation Ltd. And The Electricity Council.Google Scholar
  28. Rahim, R. & Mulyadi, R. (2004). Preliminary study of horizontal illuminance in Indonesia. In: 5th SENVAR, Universiti Teknologi Malaysia, Skudai, Johor, Malaysia, 10–12 December 2004, pp.1–10.Google Scholar
  29. Reinhart, C. F., & Andersen, M. (2006). Development and validation of a radiance model for a translucent panel. Energy and Buildings, 38(7), 890–904.CrossRefGoogle Scholar
  30. Roshan, M., Kandar, M. Z. B., Nikpur, M., Mohammadi, M. P., & Ghasemi, M. (2013). Investigating the performance of anidolic daylighting system with respect to building orientation in tropical area. IRACST-ESTIJ, 3, 74–79.Google Scholar
  31. Scartezzini, J.-L., & Courret, G. (2002). Anidolic daylighting systems. Solar Energy, 73, 123–135.CrossRefGoogle Scholar
  32. Singh, R., Lazarus, I. J., & Kishore, V. V. N. (2015). Effect of internal woven roller shade and glazing on the energy and daylighting performances of an office building in the cold climate of Shillong. Applied Energy, 159, 317–333.CrossRefGoogle Scholar
  33. Standar Nasional Indonesia (SNI). (2011). SNI-6390: Konservasi energi sistem tata udara bangunan gedung. Jakarta: Badan Standardisasi Nasional.Google Scholar
  34. Sunaga, N., Soebarto, V., Hyde, R., Ribeiro, M. A. Junghans, L., Binarti, F., & Calderaro, V. (2008). Chapter 9: design, elements, and strategies. In R. Hyde (Ed.), Bioclimatic housing: innovative designs for warm climates. London: Earthscan.Google Scholar
  35. Tindale, A. & Potter, S. (2014). DesignBuilder v.4.0. Gloucestershire.Google Scholar
  36. University of Illinois and Lawrence Berkeley National Laboratory. (2015). EnergyPlus Documentation: Engineering Reference.Google Scholar
  37. Ward, G. (2002). Desktop radiance software. California: Lawrence Berkeley Laboratory.Google Scholar
  38. Wittkopf, S. K. (2006). Daylight performance of anidolic ceiling under different sky conditions. Solar Energy, 81, 151–161.CrossRefGoogle Scholar
  39. Wittkopf, S. K., Grobe, L. O., Compagnon, R., Kampf, J., Linhart, F., & Scartezzini, J.-L. (2010). Ray tracing study for non-imaging daylight collectors. Solar Energy, 84, 986–996.CrossRefGoogle Scholar
  40. Zhu, D., Hong, T., Yan, D., & Wang, C. (2012). Comparison of building energy modeling programs: building loads. Ernest Orlando Lawrence Berkeley National Laboratory (LBNL) – 6034E. LA.Google Scholar

Copyright information

© Springer Science+Business Media B.V., part of Springer Nature 2018

Authors and Affiliations

  1. 1.Department of ArchitectureAtma Jaya Yogyakarta UniversityYogyakartaIndonesia

Personalised recommendations