Abstract
The leaching behavior of gold from an oxide gold ore using copper–tartrate–thiosulfate solutions has been investigated. Experimental parameters, including temperature, initial pH, and concentrations of copper tartrate and thiosulfate, were systematically studied. The capability of gold leaching using copper–tartrate–thiosulfate solutions is comparable to that of cyanidation, as well as the traditional copper–ammonia–thiosulfate leaching system at elevated temperatures. The kinetics are much faster than that of gold cyanidation, and thiosulfate consumption was greatly reduced in the presence of the tartrate. A considerable gold extraction of 90.42% was obtained under the optimized conditions of 0.1 mol/L CuSO4, 0.2 mol/L Na2L, 0.3 mol/L Na2S2O3, pH 11.0, and 75°C after 16 h of leaching. The process of gold dissolution in copper–tartrate–thiosulfate solutions may be controlled by product layer diffusion under the experimental conditions with an apparent activation energy of 35.474 kJ/mol. Increasing the temperature and the concentration of copper and thiosulfate while decreasing the content of tartrate can accelerate the rate of gold leaching. The system is quite unstable when the solution pH is less than 7.0, causing a noticeably lower content of the thiosulfate and copper–tartrate complex. At an initial pH of 9.0 or higher, however, faster kinetics can be achieved.
Similar content being viewed by others
References
F. Habashi, CIM Bull. 80, 108 (1987).
G. Hilson, and A.J. Monhemius, J. Clean. Prod. 14, 1158 https://doi.org/10.1016/j.jclepro.2004.09.005 (2006).
F. Korte, and F. Coulston, Ecotoxicol. Environ. Saf. 32, 96 https://doi.org/10.1006/eesa.1995.1091 (1995).
M.G. Aylmore, Dev. Miner. Process. https://doi.org/10.1016/S0167-4528(05)15021-2 (2005).
S. Ilyas, R.R. Srivastava, and H. Kim, J. Clean. Prod. 295, 126389 https://doi.org/10.1016/j.jhazmat.2021.125769 (2021).
S. Ilyas, R.R. Srivastava, and H. Kim, J. Clean. Prod. 416, 125769 https://doi.org/10.1016/j.jclepro.2021.126389 (2021).
G. Senanayake, Miner. Eng. 17, 785 https://doi.org/10.1016/j.mineng.2004.01.008 (2004).
Z.W. Liu, X.Y. Guo, Q.H. Tian, and L. Zhang, J. Hazard Mater. 440, 129778 https://doi.org/10.1016/j.jhazmat.2022.129778 (2022).
G. Senanayake, Miner. Eng. 18, 995 https://doi.org/10.1016/j.mineng.2005.01.006 (2005).
X.M. Zhang, and G. Senanayake, Miner. Process. Extr. Metall. Rev. 37, 385 https://doi.org/10.1080/08827508.2016.1218872 (2016).
M.G. Aylmore, and D.M. Muir, Miner. Eng. 14, 135 https://doi.org/10.1016/S0892-6875(00)00172-2 (2001).
H.A. White, and S. Afr, J. Sci. 1, 211 (1905).
R.M.G.S. Berezowsky and V.B. Sefton, in 108th AIME Annual Meeting, New Orleans (108th AIME Annual Meeting, New Orleans: New Orleans, 1979), pp. 17–34.
G. Senanayake, Hydrometallurgy 75, 55 https://doi.org/10.1016/j.hydromet.2004.06.004 (2004).
X. Liu, B. Xu, Y. Yang, Q. Li, T. Jiang, and Y. He, Hydrometallurgy 178, 240 https://doi.org/10.1016/j.hydromet.2018.05.014 (2018).
B. Xu, K. Li, Q. Li, Y. Yang, X. Liu, and T. Jiang, Sep. Purif. Technol. 213, 368 https://doi.org/10.1016/j.seppur.2018.12.064 (2019).
Y. Zhang, B. Xu, M. Cui, Q. Li, X. Liu, T. Jiang, and X. Lyu, Electrochim. Acta 399, 139393 https://doi.org/10.1016/j.electacta.2021.139393 (2021).
Y. Zhang, B. Xu, Y. Zheng, Q. Li, Y. Yang, X. Liu, T. Jiang, and X. Lyu, Miner. Eng. 171, 107079 https://doi.org/10.1016/j.mineng.2021.107079 (2021).
H. Arima, T. Fujita, and W.T. Yen, Mater. Trans. 45, 516 https://doi.org/10.2320/matertrans.45.516 (2003).
B. Xu, K. Li, Z. Dong, Y. Yang, Q. Li, X. Liu, and T. Jiang, J. Clean. Prod. 233, 1475 https://doi.org/10.1016/j.jclepro.2019.06.182 (2019).
I. Chandra, and M.I. Jeffrey, Hydrometallurgy 77, 191 https://doi.org/10.1016/j.hydromet.2004.12.002 (2005).
J.A. Heath, M.I. Jeffrey, H.G. Zhang, and J.A. Rumball, Miner. Eng. 21, 424 https://doi.org/10.1016/j.mineng.2007.12.006 (2008).
J.L. Deutsch, and D.B. Dreisinger, Hydrometallurgy 137, 165 https://doi.org/10.1016/j.hydromet.2013.03.013 (2013).
J.J. Eksteen, and E.A. Oraby, Miner. Eng. 70, 36 https://doi.org/10.1016/j.mineng.2014.08.020 (2015).
D.M. Muir, and M.G. Aylmore, Miner. Process. Extr. Metall. 113, 2 https://doi.org/10.1179/037195504225004661 (2004).
D.H. Brown, W.E. Smith, P. Fox, and R.D. Sturrock, Inorg. Chim. Acta 67, 27 https://doi.org/10.1016/S0020-1693(00)85035-5 (1982).
D. Feng, and J.S.J. van Deventer, Miner. Eng. 24, 1022 https://doi.org/10.1016/j.mineng.2011.04.017 (2011).
J. Wang, F. Xie, W. Wang, Y. Bai, Y. Fu, and Y. Chang, Miner. Eng. 155, 106476 https://doi.org/10.1016/j.mineng.2020.106476 (2020).
J. Wang, F. Xie, W. Wang, Y. Bai, Y. Fu, and D. Dreisinger, Hydrometallurgy 191, 105204 https://doi.org/10.1016/j.hydromet.2019.105204 (2020).
J. Chen, F. Xie, W. Wang, Y. Fu, and J. Wang, Miner. Eng. 183, 107605 https://doi.org/10.1016/j.mineng.2022.107605 (2022).
J. Chen, F. Xie, W. Wang, Y. Fu, and J. Wang, Metals 12, 1152 https://doi.org/10.3390/met12071152 (2022).
J. Wang, W. Wang, K. Dong, Y. Fu, and F. Xie, Miner. Eng. 137, 232–240 https://doi.org/10.1016/j.mineng.2019.04.013 (2019).
S.R. La Brooy, H.G. Linge, and G.S. Walker, Miner. Eng. 7, 1213 https://doi.org/10.1016/0892-6875(94)90114-7 (1994).
D. Feng, and J.S.J. van Deventer, Int. J. Miner. Process. 82, 138 https://doi.org/10.1016/j.minpro.2006.09.003 (2007).
S. Zhang, and M.J. Nicol, Hydrometallurgy 103, 196 https://doi.org/10.1016/j.hydromet.2010.03.019 (2010).
D. Dreisinger, and N. Abed, Hydrometallurgy 66, 37 https://doi.org/10.1016/S0304-386X(02)00079-8 (2002).
T.G. Hörner, and P. Klüfers, Eur. J. Inorg. Chem. 12, 1798 https://doi.org/10.1002/ejic.201600168 (2016).
D. Feng, and J.S.J. van Deventer, Miner. Eng. 23, 399 https://doi.org/10.1016/j.mineng.2009.11.016 (2010).
Acknowledgements
The work was supported by the Fundamental Research Funds for Central Universities of China (N182502044). Special thanks are due to the instrumental or data analysis from the Analytical and Testing Center, Northeastern University.
Funding
Project (N182502044) supported by Fundamental Research Funds for Central Universities of China.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Chen, J., Xie, F., Wang, W. et al. Leaching of Gold from an Oxide Gold Ore with Copper–Tartrate–Thiosulfate Solutions at Elevated Temperatures. JOM 75, 4308–4319 (2023). https://doi.org/10.1007/s11837-023-06020-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11837-023-06020-0