JOM

, Volume 68, Issue 3, pp 765–771

Evaluating the Effect of Processing Parameters on Porosity in Electron Beam Melted Ti-6Al-4V via Synchrotron X-ray Microtomography

  • Ross Cunningham
  • Sneha P. Narra
  • Tugce Ozturk
  • Jack Beuth
  • A. D. Rollett
Article

DOI: 10.1007/s11837-015-1802-0

Cite this article as:
Cunningham, R., Narra, S.P., Ozturk, T. et al. JOM (2016) 68: 765. doi:10.1007/s11837-015-1802-0

Abstract

Electron beam melting (EBM) is one of the subsets of direct metal additive manufacturing (AM), an emerging manufacturing method that fabricates metallic parts directly from a three-dimensional (3D) computer model by the successive melting of powder layers. This family of technologies has seen significant growth in recent years due to its potential to manufacture complex components with shorter lead times, reduced material waste and minimal post-processing as a “near-net-shape” process, making it of particular interest to the biomedical and aerospace industries. The popular titanium alloy Ti-6Al-4V has been the focus of multiple studies due to its importance to these two industries, which can be attributed to its high strength to weight ratio and corrosion resistance. While previous research has found that most tensile properties of EBM Ti-6Al-4V meet or exceed conventional manufacturing standards, fatigue properties have been consistently inferior due to a significant presence of porosity. Studies have shown that adjusting processing parameters can reduce overall porosity; however, they frequently utilize methods that give insufficient information to properly characterize the porosity (e.g., Archimedes’ method). A more detailed examination of the result of process parameter adjustments on the size and spatial distribution of gas porosity was performed utilizing synchrotron-based x-ray microtomography with a minimum feature resolution of 1.5 µm. Cross-sectional melt pool area was varied systematically via process mapping. Increasing melt pool area through the speed function variable was observed to significantly reduce porosity in the part.

Funding information

Funder NameGrant NumberFunding Note
America Makes
  • FA8650-12-2-7230
National Science Foundation
  • CMMI-1335298

Copyright information

© The Minerals, Metals & Materials Society 2016

Authors and Affiliations

  • Ross Cunningham
    • 1
  • Sneha P. Narra
    • 2
  • Tugce Ozturk
    • 1
  • Jack Beuth
    • 2
  • A. D. Rollett
    • 1
  1. 1.Department of Materials Science and EngineeringCarnegie Mellon UniversityPittsburghUSA
  2. 2.Department of Mechanical EngineeringCarnegie Mellon UniversityPittsburghUSA

Personalised recommendations