Abstract
FVS1212/FVS0812 material was prepared by adding FVS1212 powder into FVS0812 powder. The structure and mechanical properties of materials were studied by means of X-Ray, tensile measurement, OM and SEM. The results show that adding proper content FVS1212 powders can improve the tensile strength of FVS0812 aluminum at room temperature and elevated temperature, and that the elongation of FVS1212/FVS0812 material is better than that of FVS1212 aluminum.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Skinner D J, Flanders N J, Chipko P A. Aluminum-transition metal alloys having high strength at elevated temperatures[P]. US5000781, 1991-03-19.
Skinner D J, Zedalis M S. Aluminum iron silicon based elevated-temperature aluminum alloy[P]. US 5,073,215, 1991-02-17.
Skinner D J, Bye R L, Raybould D, et al. Dispersion strengthened Al-Fe-V-Si alloys[J]. Scripta Metallurgical, 1986, 20: 867–872.
Skinner D J, Zedalis M S, Gilman P. Effect of strain rate on tensile ductility for a series of dispersion strengthened aluminum-based alloys[J]. Materials Science and Engineering, 1989, A119: 81–86.
Kim I S, Kim N J, Nam S W. Temperature dependence of the optimum particle size for the dislocation detachment controlled creep of Al-Fe-V-Si/SiCp composite[J]. Scripta Metallurgical et Materials, 1995, 32(11): 1813–1814.
Tong X C, Ghosh A K. Fabrication of in situ TiC reinforced aluminum matrix composites[J]. J Materials Sci, 2001, 36: 4059–4069.
Hyang J K, Woo J P, Nack J K. Identification of metastable phases in strip-cast and spray-cast Al-Fe-V-Si alloys[J]. Materials Transactions JIM, 1998, 39(9): 982–988.
Peng L M, Zhu S J, Ma Z Y, et al. High temperature creep deformation of Al18B4O33 whisker-reinforced 8009 Al composite [J]. Materials Science and Engineering, 1999, A256: 63–70.
SUN Yu-feng, REN Chen-xing, SHEN Ning-fu. Study on the microstructure evolution of spray deposited Al-Fe-V-Si Alloy[J]. Journal of Zhengzhou University of Technology, 2001, 22(4): 17–21.
Srivastava A K, Ranganathan S. Microstructural characterization of rapidly solidified Al-Fe-Si, Al-V-Si, and Al-Fe-V-Si alloys[J]. J Mater Res, 2001, 7: 2103–2116.
TAN Dun-qiang, LI Wen-xian, XIAO Yu-de, et al. Precipitation phase and thermaldynamic analysis during solidification of AlFeSi system[J]. Trans Nonferrous Soc China, 2003, 13(5): 1133–1136.
TAN Dun-qiang, LI Wen-xian, XIAO Yu-de et al. Phase transition of AlFeVSi heat resistant alloy by spray deposition[J]. Trans Nonferrous Soc China, 2003, 13(3): 568–573.
Author information
Authors and Affiliations
Corresponding author
Additional information
Foundation item: Project(G1999064900) supported by the National Key Fundamental Research and Development Program of China
Rights and permissions
About this article
Cite this article
Tan, Dq., Li, Wx., Xiao, Yd. et al. Preparation of FVS1212/FVS0812 materials and its mechanical properties. J Cent. South Univ. Technol. 12, 503–506 (2005). https://doi.org/10.1007/s11771-005-0111-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11771-005-0111-0