Abstract
Gears in a strip mining dragline failed in service. The material was identified as a low-alloy (NiCrMoV) steel. SEM analysis indicated that the initial fracture and subsequent fractures resulted from impact or a suddenly applied load. Mechanical testing indicated that the gears had low impact strength. Failure was attributed to low toughness caused by the absence of, or improper, heat treatment. Casting defects identified during metallographic examination were determined to be the fracture initiation site, but were considered less significant than the low as-received impact strength of the material. It was recommended that the equipment manufacturer implement an appropriate heat treatment to meet the impact requirements of the application.
Similar content being viewed by others
Author information
Authors and Affiliations
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
This article is adapted from Handbook of Case Histories in Failure Analysis, Vol 2, Khlefa A. Esaklul, Ed., ASM International, 1993, p 45–52,https://doi.org/10.31399/asm.fach.v02.c9001301
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Goodrich, G.M. Failure of Four Cast Steel Gear Segments. J Fail. Anal. and Preven. 22, 2041–2050 (2022). https://doi.org/10.1007/s11668-022-01510-w
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11668-022-01510-w