Abstract
The cold test stands accommodate different bearing-supported areas, wherever needed to ensure the structural durability of the design. These bearings vary in type and functionality. Some bearings are located along the driveline; others are embedded in the variable frequency drive driving the rotating machinery of the cold test stand, up to the support of the engine crankshaft bearing. The presence of several bearings along the power line makes it a challenge to determine the defect source when it occurs. If the cause of the malfunction is due to the failure of one of the supporting bearings, then a downtime is needed for the engine maintenance and diagnostics. This paper proposes an effective approach for the prediction of premature bearing failure through the analysis of the torque signals and the accelerometers feedback imported from the suspected regions.
Similar content being viewed by others
References
P. Gupta, M. Pradhan, Fault detection analysis in rolling element bearing: a review. Today Proc. 4, 2085–2094 (2017)
R. Desavale, V. Salunkhi, Damage detection of roller bearing system using experimental data. Proc. Eng. 144, 202–207 (2016)
V. Nistane, S. Harsha, Failure evaluation of ball bearing for prognostics. Proc. Technol. 23, 179–186 (2016)
A. Prudhom, J. Antonino-Daviu, Time–frequency vibration analysis for the detection of motor damages caused by bearing currents. Mech. Syst. Signal Proc. 84, 747–762 (2017)
X. Xu, M. Zhao, Envelope harmonic-to-noise ratio for periodic impulses detection and its application to bearing diagnosis. Measurement 91, 385–397 (2016)
B. Liu, S. Ling, Bearing failure detection using matching pursuit. NDT &E Int. 35, 255–262 (2002)
R. Tailony, E. Nikolaidis, Driveline backlash identification and torsional defects detection using torque signatures analysis for an IC engine cold test stand. J. Fail. Anal. Prevent. 17, 1–8 (2017)
M. Haneef, R. Randall, Wear profile prediction of IC engine bearings by dynamic simulation. Wear 364–365, 84–102 (2016)
R. Rzadkowski, E. Rokicki, Analysis of middle bearing failure in rotor jet engine using tip-timing and tip-clearance techniques. Mech. Syst. Signal Process. 76–77, 213–227 (2016)
C. Sobie, C. Freitas, Simulation-driven machine learning: bearing fault classification. Mech. Syst. Signal Process. 99, 403–419 (2018)
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Tailony, R. Predicting Premature Bearing Failure in the Driveline and the Variable Frequency Drive of Cold Test Stands. J Fail. Anal. and Preven. 19, 682–687 (2019). https://doi.org/10.1007/s11668-019-00648-4
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11668-019-00648-4