Failure Analysis of a Cracked Gasoline Engine Cylinder Head
- 341 Downloads
This article presents a failure analysis on a gasoline engine cylinder head made of aluminum alloy, which has been used in passenger cars. During an endurance test, a crack initiated from the interior wall of a hole in the center of the cylinder head and then propagated through the thickness of the cylinder head. The metallurgical examinations are conducted in the crack origin zone. The results show that there are many casting pores due to poor quality of casting in the failed cylinder head which has certainly played a crucial role in initiating the crack. Finite element analysis of the cylinder head is performed to identify the stress components. Modeling of a bolt for the hole shows that the plastic stresses are occurred. Moreover, the lower strength of the material due to high assembly stress caused the failure in the cylinder head.
KeywordsCylinder head Crack Failure analysis FEM Fatigue SEM Fractography
The authors thank the IPCo., including the laboratory, the CAE, and the design departments for the financial supports in experiments, especially Mr. Sharghi, Mr. Hosseini, Mr. Abaszadeh, Mr. Salimi, and Mr. Asadi.
- 1.Aluminium and Aluminium Alloys - Castings - Chemical Composition and Mechanical Properties, Standard No. DIN-EN-1706 (1998)Google Scholar
- 2.AlSi9Cu3 Aluminum Alloy Permanent Mold Casting Alloy Material Specification, Standard No. IK-150-11-1-0014 (2007)Google Scholar
- 3.Test Method for Brinell Hardness Test of Metallic Materials, Standard No. ASTM E10-06 (2006)Google Scholar
- 4.Properties and Selection: Nonferrous Alloys and Special-Purpose Materials, vol. 2. ASM Metals Handbook (1990)Google Scholar
- 5.Failure Analysis and Prevention, vol. 11. ASM Metals Handbook (1990)Google Scholar
- 6.Porosity Classification and Requirements for Casting Parts, Standard No. IK-150-11-1-0010 (2006)Google Scholar
- 7.Volume Defects of Castings made from Non-ferrous Metal, Standard No. IK-150-11-1-0011 (2006)Google Scholar