Journal of Failure Analysis and Prevention

, Volume 11, Issue 5, pp 473–477 | Cite as

Hot Cracking in Inductively Bent Austenitic Stainless Steel Pipes

Case History---Peer-Reviewed

Abstract

Surface cracks found on austenitic stainless steel piping after inductive bending into manifolds were shown to be caused by liquation cracking due to over heating. The cracked manifolds were dicarded and a new vendor was selected.

Keywords

Inductive bending Stainless steel cracking Fractography 

References

  1. 1.
    Cross, C.E.: Private Communication. Federal Institute for Materials Research and Testing, Berlin, May 19, 2010Google Scholar
  2. 2.
    Cottrell, A.H., Swann, P.R.: Technical lessons of Flixborough. A metallurgical examination of the eight-inch line. Chem. Eng. 308, 266–274 (1976)Google Scholar
  3. 3.
    Hough, R.R., Rolls, R.: Creep fracture phenomena in iron embrittled by liquid copper. J. Mater. Sci. 6, 1493–1498 (1971)CrossRefGoogle Scholar
  4. 4.
    Pohl, M.: Private Communication. Ruhr-Universität Bochum, Bochum, February 16, 2010Google Scholar

Copyright information

© ASM International 2011

Authors and Affiliations

  1. 1.Siemens AG, Energy Sector—E F PR GT BLN QM2BerlinGermany

Personalised recommendations