Advertisement

Journal of Failure Analysis and Prevention

, Volume 9, Issue 3, pp 197–207 | Cite as

An Engineering Failure Analysis of a Biological Treatment Plant in Nigeria

  • I. A. Oke
  • K. T. Oladepo
  • J. O. Babatola
Feature---Peer-Reviewed
  • 87 Downloads

Abstract

Waste stabilization ponds (WSP) have been found useful and applicable in most parts of the world. Their application has been found in the treatment of industrial, commercial, institutional, and domestic wastewaters. Failures of WSP have not been reported until recently. This then calls for engineering analysis of failed ponds to prevent the recurrence of these ugly events. This paper presents results of an engineering failure analysis conducted on a waste stabilization pond at Obafemi Awolowo University, Ile-Ife, Nigeria. The ponds receive wastewater from selected student halls and academic buildings by gravity as a result of the topography of the campus. The ponds were visited, and influent and effluent qualities of the ponds were determined. Adequacy of the design parameters and structural behavior were studied and compared with the standard code. The study revealed that some of the engineering parameters were higher than the upper limit recommended by the standard code. Solids had accumulated in the ponds, resulting in anaerobic conditions in the ponds, generating hydrogen sulfide and acids as end products. Production of these acids corroded the sewers, cracked some manholes, and dislocated pipes (sewers). Accumulation of solid also led to sludge formation and thus reduced effective depth, length, and breadth of the ponds and made detention time below the specified range in the standard environmental pollution control code. It was concluded that the failure of the ponds can be attributed to partial adherence to the standard code in terms of vegetation, flood control mechanism, high biochemical oxygen demand and suspended loadings, and flow rate, as well as to low detention; all originated from improper maintenance.

Keywords

Waste stabilization ponds Anaerobic condition Sewers BOD loadings Flow rate Suspended solid Hydraulic loading 

Abbreviations

BOD

Biochemical oxygen demand

DO

Dissolved oxygen

mg/L

Milligrams per liter

SS

Suspended solids

D1 and D2

Initial and final dissolved oxygen of the sample respectively (mg/L)

f

Ratio of seed in the sample to seed in the control

p

Decimal volumetric fraction of sample used

B1 and B2

Initial and final dissolved oxygen of the seeded control respectively (mg/L)

APHA

American Public Health Association

Notes

Acknowledgments

The authors acknowledge Mr. O. Oginn Ekundayo (CVE/2001/053) and A. Musa Olayinka (CVE/2002/051) both of Civil Department, Obafemi Awolowo University, Ile-Ife (Nigeria) for taking part in the study. Also they acknowledge Mr. S. A. Owolade of Civil Engineering Department for reproducing Fig. 2 again.

References

  1. 1.
    Adewumi, I., Oke, I.A., Bamgboye, P.A.: Determination of the deoxygenation rates of a residential institution’s wastewater. J. Appl. Sci. 5(1), 108–112 (2005)CrossRefADSGoogle Scholar
  2. 2.
    Eiroa, M., Vilar, A., Kennes, C., Veiga, M.C.: Biological treatment of industrial wastewater containing formaldehyde and formic acid. Water SA 32(1), 115–118 (2006)Google Scholar
  3. 3.
    Cheng, S., Lin, Y., Chen, S.: Enhanced biodegradation of organic nitrogenous compounds in resin manufacturing wastewater by anoxic denitrification. Water Sci. Technol. 34, 35–41 (1996)Google Scholar
  4. 4.
    Steel, E.W., McGhee, J.T.: Water Supply and Sewerage, 1st edn. McGraw Hill Book Co., Tokyo (1979)Google Scholar
  5. 5.
    Hammer, M.J., Hammer, M.J. Jr.: Water and Wastewater Technology, 3rd edn. Prentice Hall of India Private Limited, New Delhi (2000)Google Scholar
  6. 6.
    Viessman, W. Jr., Hammer, M.J.: Water Supply and Pollution Control, 5th edn. Harper Collins College Publishers, New York (1993)Google Scholar
  7. 7.
    Tebbutt, T.H.Y.: Principles of Water Quality Control, 3rd edn. Pergamon Press, Oxford (1991)Google Scholar
  8. 8.
    Kobayashi, H.A., Stenstom, M.K., Mah, R.A.: Treatment of low strength domestic wastewater using the anaerobic filter. Water Res. 17(8), 903–909 (1983)CrossRefGoogle Scholar
  9. 9.
    Garrido, J.M., Méndez, R., Lema, J.M.: Treatment of wastewaters from a formaldehyde-urea adhesives factory. Water Sci. Technol. 42, 293–300 (2000)Google Scholar
  10. 10.
    Hodgson, O.A.: Treatment of domestic sewage at Akuse (Ghana). Water SA 26(3), 413–416 (2000)Google Scholar
  11. 11.
    Ogunfowokan, A.O., Okoh, E.K., Adenuga, A.A., Asubiojo, O.I.: An assessment of the impact of point source pollution from a university sewage treatment oxidation pond on a receiving stream—a preliminary study. J. Appl. Sci. 5(1), 36–43 (2005)CrossRefADSGoogle Scholar
  12. 12.
    Otun, J.A., Adie, D.B., Oke, I.A., Ismail, A., Ajibike, M.A.: Status of conventional wastewater treatment plants in Northern Nigeria. Paper presented at the third annual national conference of society for occupational safety and environmental health (SOSEH), Awka, Nnamdi Azikiwe University, 8–11 Nov 2006Google Scholar
  13. 13.
    Ajani, A.M.: A life-cycle assessment of a Mini Urban water system—a campus case study. Unpublished Masters of Science Thesis, at UNESCO-IHE Institute for Water Education. Delft, The Netherlands (2007)Google Scholar
  14. 14.
    Adewumi, I.K.: Determination and analysis of design parameters for stabilization pond system at the Obafemi Awolowo University, Ile-Ife. Unpublished Master of Science Thesis, Department of Environmental Health and Epidemial Faculty of Health Sciences, Obafemi Awolowo University, Ile-Ife (1989)Google Scholar
  15. 15.
    APHA: Standard Method for the Examination of Water and Wastewater, 20th edn. America Water Works Association and Water Pollution Control Federation, Washington, DC (1998)Google Scholar
  16. 16.
    Metcalf and Eddy Inc.: Wastewater Engineering Treatment Disposal and Reuse, 3rd ed. McGraw-Hill Book Co., New York (1991)Google Scholar
  17. 17.
    Mara, D.D.: Sewage Treatment in Hot Climate, 3rd edn. Wiley, Interscience, London (1986)Google Scholar
  18. 18.
    Horan, N.J.: Biological Wastewater Treatment System, Theory and Operation, 1st edn. Wiley, New York (1993)Google Scholar
  19. 19.
    Chin, D.A.: Water Resources Engineering, 1st edn. Prentice Hall, Upper Saddle River, NJ (2000)Google Scholar
  20. 20.
    Dake, N.B.: Essentials of Engineering Hydraulics. Macmillan Press, Hong Kong (1983)Google Scholar
  21. 21.
    Featherstone, R.E., Nalluri, C.: Civil Engineering Hydraulics. Essential Theory with Worked Examples. ELBS, 1st edn. Granada Publishing, Billing and Sons Limited, Worcester (1982)Google Scholar
  22. 22.
    Chow, V.T.: Open Channel Hydraulic, International Edition. McGraw-Hill, Singapore (1959)Google Scholar
  23. 23.
    MOP8 Sewage Treatment Plant Design, Water Pollution Control Federation and the America Society of Civil Engineers, Washington, D.C. (1967)Google Scholar
  24. 24.
    GLUMRBSSE: Recommended Standards for Sewage Work. Health Education Service, New York (1968)Google Scholar
  25. 25.
    Oke, I.A., Oladepo, K.T., Olajumoke, A.M.: Settlement and compressive properties of suspended solids in a domestic-institutional wastewater. J. Food Agric. Environ. (JFAE) 7(1), 224–228 (2009)Google Scholar
  26. 26.
    FEPA: Guidelines to Standards for Environmental Pollution Control in Nigeria. Federal Environmental Protection Agency (FEPA), Lagos (1991)Google Scholar

Copyright information

© ASM International 2009

Authors and Affiliations

  1. 1.Department of Civil EngineeringObafemi Awolowo UniversityIle-IfeNigeria
  2. 2.Department of Civil EngineeringFederal University of TechnologyAkureNigeria

Personalised recommendations