Avoid common mistakes on your manuscript.
Correction to : JMEPEG https://doi.org/10.1007/s11665-023-08238-0
In this article as originally published, Sithiprumnea Dul was omitted from the author list. The following is the correct author list:
G. Barera1,2, S. Dul3, A. Pegoretti1
1Department of Industrial Engineering, University of Trento, Via Sommarive 9, 38123, Trento, Italy
2CMS S.p.A., Via A. Locatelli 123, 24019, Zogno, BG, Italy
3Empa, Swiss Federal Laboratories for Materials Science and Technology, Lerchenfeldstrasse 5, 9014 St. Gallen, Switzerland
The article has been updated to correct the error.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
About this article
Cite this article
Barera, G., Dul, S. & Pegoretti, A. Correction to: Screw Extrusion Additive Manufacturing of Carbon Fiber Reinforced PA6 Tools. J. of Materi Eng and Perform 32, 9598 (2023). https://doi.org/10.1007/s11665-023-08342-1
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11665-023-08342-1