Abstract
The article describes a novel Al-Zn-Si alloy hot-dip coating on steel, coating characterization and performance evaluation. Cross-sectional SEM micrographs showed that the coating consists of two layers- thick Al-Zn-Si alloy layer on the top and a thin Al-Fe-Si intermetallic layer underneath toward the interface. The outer Al-Zn-Si alloy layer is composed of primary aluminum-rich (α-Al) dendrites along with uniform distribution of Si. EDS and XRD analysis identified Al-Fe-Si intermetallic layer as Al8Fe2Si phase. Potentiodynamic polarization study displayed superior corrosion properties of the coating compared to commercial aluminized steels. Corrosion rate (in mpy) was found to be six times lower compared to galvanized coating with a similar corrosion potential. Furthermore, salt spray test life of coating more than 2000h confirmed superior corrosion properties than GI coating.
Similar content being viewed by others
References
X.G. Zhang, Galvanic Corrosion of Zinc and its Alloys, J. Electrochem. Soc., 1996, 143, p 1472–1484.
X.G. Zhang and E.M. Valeriote, Galvanic Protection of Steel and Galvanic Corrosion of Zinc Under Thin Layer Electrolytes, Corros. Sci., 1993, 34, p 1957–1972.
J.H.O.J. Wijjenberg, J.T. Stevels and J.H.W. de Wit, Galvanic Coupling of Zinc to Steel in Alkaline Solutions, Electrochim. Acta, 1997, 43, p 649–657.
X.G. Zhang, Corrosion and Electrochemistry of Zinc, Plenum Press, New York/London, 1996.
A.P. Yadav, H. Katayama, K. Noda, H. Masuda, A. Nishikata and T. Tsuru, Surface Potential Distribution Over a Zinc/Steel Galvanic Couple Corroding Under Thin Layer of Electrolyte, Electrochim. Acta, 2007, 52, p 3121–3129.
M. Mouanga, M. Puiggalia, B. Tribollet, V. Vivierb, N. Pébèrec and O. Devos, Galvanic Corrosion Between Zinc and Carbon Steel Investigated by Local Electrochemical Impedance Spectroscopy, Electrochim. Acta, 2013, 88, p 6–14.
R.W. Richards, R.D. Jones, P.D. Clements and H. Clarke, Metallurgy of Continuous Hot Dip Aluminizing, Int. Mater. Rev., 1994, 39, p 191–212.
A. Bahadur and O.N. Mohanty, Structural Studies of Hot Dip Aluminized Coatings on Mild Steel, Mater. Trans. JIM, 1991, 32, p 1053–1061.
C.J. Wang and S.M. Chen, The High-Temperature Oxidation Behavior of Hot-Dipping Al–Si Coating on Low Carbon Steel, Surf. Coat. Technol., 2006, 200, p 6601–6605.
C.J. Wang and M. Badaruddin, The Dependence of High Temperature Resistance of Aluminized Steel Exposed to Water-Vapour Oxidation, Surf. Coat. Technol., 2010, 205, p 1200–1205.
W. Warnecke, J. Froeber and R. Bode, Hot Dip Aluminized Steel Sheet - an Excellent Material for Fuel Tank Application, SAE Tech., 1999 https://doi.org/10.4271/1999-01-0022
D.W. Fan and B.C. De Cooman, Formation of an Aluminide Coating on hot Stamped Steel, ISIJ Int., 2010, 50, p 1713–1718.
C. Allély, L. Dosdat, O. Clauzeau, K. Ogle and P. Volovitch, Anticorrosion Mechanisms of Aluminized Steel for Hot Stamping, Surf. Coat. Technol., 2014, 238, p 188–196.
C. Kim, S. Cho, W. Yang, A.I. Karayan and H. Castaneda, Corrosion Behavior of Al-Si-Mg Coated Hot-Press-Forming Steel, Corros. Sci., 2021, 183, 109339. https://doi.org/10.1016/j.corsci.2021.109339
Y. Kyo, A.P. Yadav, A. Nishikata and T. Tsuru, Hydrogen Entry Behaviour of Newly Developed Al–Mg–Si Coating Produced by Physical Vapour Deposition, Corros. Sci., 2011, 53, p 3043–3047.
C. Kruehong, G.A. EL-Mahdy, A. Nishikata and T. Tsuru, Influence of Second Phases on the Electrochemical Behavior of Hot Dipped Al–Mg–Si Coated Steel, Corros. Sci., 2010, 52, p 2379–2386.
T. Tsuru, Hot-Dipped Al-Mg-Si Coating Steel-its Structure, Electrochemical and Mechanical Properties, Corros. Sci. Technol., 2010, 9, p 233–238.
S. Yamaguchi, J. Maki, M. Kurosaki and T. Izaki, Composition and Corrosion Behavior of Hot-Dip Al-Si-Mg Alloy Coated Steel Sheets, Tetsu-to-Hagane, 2013, 99, p 617–624.
N. Takata, M. Nishimoto, S. Kobayashi and M. Takeyama, Morphology and Formation of Fe–Al Intermetallic Layers on Iron Hot-Dipped in Al–Mg–Si Alloy Melt, Intermetallics, 2014, 54, p 136–142.
C. Kruehong and G. A. EL-Mahdy, A. Nishikata, T. Tsuru, , Influence of Second Phases on the Electrochemical Behavior of Hot Dipped Al–Mg–Si Coated Steel, Corros. Sci., 2010, 52, p 2379–2386.
P.P. Dey, P. Modak, P.S. Banerjee, D. Chakrabarti, A.H. Seikh, H.S. Abdo, M. Luqman and M. Ghosh, Studies on the Characterization and Morphological Features of the Coating on Interstitial Free Steel Dipped in Molten Al-Si-Mg Alloy at 800°C, J. Mater. Res. Technol., 2020, 9, p 4788–4805.
D. Pradhan, M. Manna and M. Dutta, Al–Mg–Mn Alloy Coating on Steel with Superior Corrosion Behavior, Surf. Coat. Technol., 2014, 258, p 405–414.
D. Pradhan, A. Mondal, A. Chakraborty, M. Manna and M. Dutta, Microstructural Investigation and Corrosion Behavior of Hot-Dipped Al-Si-Mg-Cu Alloy Coated Steel, Surf. Coat. Technol., 2019, 375, p 427–441.
A.R. Moreira, Z. Panossian, P.L. Camargo, M.F. Moreira and ICd Silva, JER deCarvalho, , Zn/55Al Coating Microstructure and Corrosion Mechanism, Corros. Sci., 2006, 48, p 564–576.
R. Chen and D. Willis, The Behavior of Silicon in the Solidification of Zn–55Al–16Si Coating on Steel, Metall. Mater. Trans. A, 2005, 36, p 117–128.
R. Mathew, P.R. Stoddart, D. Nolan and Y. Durandet, Microstructural Refinement of Aluminium-Zinc-Silicon Coated Steels, Surf. Coat. Technol., 2016, 306, p 490–496.
W. Liua, Q. Lia and M.-C. Li, Corrosion Behaviour of Hot-Dip Al–Zn–Si and Al–Zn–Si–3Mg Coatingsin NaCl Solution, Corros. Sci., 2017, 121, p 72–83.
W.J. Cheng and C.J. Wang, Growth of Intermetallic Layer in the Aluminide Mild Steel During Hot-Dipping, Surf. Coat. Technol., 2009, 204, p 824–828.
G. Eggeler, W. Auer and H. Kaesche, On the Influence of Silicon on the Growth of the Alloy Layer During Hot Dip Aluminizing, J. Mater. Sci., 1986, 21, p 3348–3350.
M.A. Shady, A.R. El-Sissi and A.M. Attia, On the Technological Properties of Steel Strips Aluminized in Al-Si Baths, J. Mater. Sci. Lett., 1996, 15, p 1032–1036.
B. Lemmens, H. Springer, I. De Graeve, J. De Strycker, D. Raabe and K. Verbeken, Phases Formed During Hot-Dip Aluminizing of Ferritic Steel, Surf. Coat. Technol., 2017, 319, p 104–109.
M.V. Akdeniz, A.O. Mekhrabov and T. Yilmaz, The Role of Si Addition on the Interfacial Interaction in Fe-Al Diffusion Layer, Scr. Mater., 1994, 31, p 1723–1728.
H. Azimaee, M. Sarfaraz, M. Mirjalili and K. Aminian, Effect of Silicon and Manganese on the Kinetics and Morphology of the Intermetallic Layer Growth During Hot-Dip Aluminizing, Surf Coat. Technol., 2019, 357, p 483–496.
H. Springer, A. Kostka, E.J. Payton, D. Raabe, A. Kaysser-Pyzalla and G. Eggeler, On the Formation and Growth of Intermetallic Phases During Interdiffusion Between Low-Carbon Steel and Aluminum Alloys, Acta Mater., 2011, 59, p 1586–1600.
M. Windmann, A. Röttger and W. Theisen, Formation of Intermetallic Phases in Al-Coated Hot-Stamped 22MnB5 Sheets in Terms of Coating Thickness and Si Content, Surf. Coat. Technol., 2014, 246, p 17–25.
M. Windmann, A. Röttger and W. Theisen, Phase Formation at the Interface Between a Boron Alloyed Steel Substrate and an Al-rich Coating, Surf. Coat. Technol., 2013, 226, p 130–139.
N. Takata, M. Nishimoto, S. Kobayashi and M. Takeyama, Growth of Fe2Al5 Phase on Pure Iron Hot-Dipped in Al–Mg–Si Alloy Melt with Fe in Solution, ISIJ Int., 2015, 55, p 1454–1459.
F. Yin, M. Zhao, Y. Liu, W. Han and Z. Li, Effect of Si on Growth Kinetics of Intermetallic Compounds During Reaction Between Solid Iron and Molten Aluminum, Trans. Nonferrous Met. Soc. China, 2013, 23, p 556–561.
S.G. Shabestari and K.A. Nazari, Growth Kinetics of Aluminum-Bearing Intermetallic Layer on Tool Steel, Int. J. Mater. Res. (formerly Z. Metallkd.), 2013, 104, p 351–357.
I. De Graeve, I. Schoukens, A. Lanzutti, F. Andreatta, A. Alvarez-Pampliega, J. De Strycker, L. Fedrizzi and H. Terryn, Mechanism of Corrosion Protection of Hot-Dip Aluminium–Silicon Coatings on Steel Studied by Electrochemical Depth Profiling, Corros. Sci., 2013, 76, p 325–336.
Y. Li, Corrosion Behaviour of Hot Dip Zinc And Zinc–Aluminium Coatings on Steel in Seawater, Bull. Mater. Sci., 2001, 24, p 355–360.
P. Choudhury and S. Das, Effect of Microstructure on the Corrosion Behavior of a Zinc–Aluminium Alloy, J. Mater. Sci., 2005, 40, p 805–807.
H.-S. Lee, J.K. Singh, M.A. Ismail, C. Bhattacharya, A.H. Seikh, N. Alharthi and R.R. Hussain, Corrosion Mechanism and Kinetics of Al-Zn Coating Deposited by Arc Thermal Spraying Process in Saline Solution at Prolong Exposure Periods, Sci. Rep., 2019, 9, p 3399. https://doi.org/10.1038/s41598-019-39943-3
H.N. McMurray, Localized Corrosion Behavior in Aluminum-Zinc Alloy Coatings Investigated Using the Scanning Reference Electrode Technique, Corros., 2001, 57, p 313–322.
D.J. Blickwede, 55% Al-Zn-Alloy-Coated Sheet Steel, Tetsu-to-Hagane, 1980, 66, p 821–834.
Acknowledgment
The authors are grateful to Mr. Arup Haldar for conducting hot-dip coating experiments. Authors would like to thank Mr. V. Sharma for SEM/EDS characterization, Ms. Samvedana for grazing anle XRD measurement, Ms. Puja Kumari for GDOES measurement and Ms. Nitu Rani for corrosion tests.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Pradhan, D., Mondal, A. & Chakraborty, A. Microstructural and Corrosion Resistance Evaluation of Hot-Dipped Al-Zn-Si Alloy-Coated Steel. J. of Materi Eng and Perform 31, 2297–2308 (2022). https://doi.org/10.1007/s11665-021-06316-9
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11665-021-06316-9