Skip to main content
SpringerLink
Log in

Effect of Material Hardness on Water Lubrication Performance of Thermoplastic Polyurethane under Sediment Environment

  • Published:
Journal of Materials Engineering and Performance Aims and scope Submit manuscript

Abstract

Water-lubricated stern tube bearings are widely used in marine shaft systems, where their lubrication performance determines the efficiency and navigation safety of ships. The hardness of materials is an important factor affecting the tribological performance of water-lubricated bearings under sediment conditions. This study investigated the wear behavior of thermoplastic polyurethane (TPU) materials with different shore hardnesses under sediment conditions. Four kinds of TPU with different shore hardness were selected. The test results showed that the shore hardness of TPU depended on the content of the TPU hard segment. With increasing hardness, the absorption peak strength of the functional groups increased, and the increase in hardness could enhance the tensile strength of the TPU materials. In all test groups, the friction coefficient of TPU with 60 and 70 A hardness was relatively stable. The total wear volume of TPU with 70 A hardness was 45.9% lower than that of TPU with 60 A hardness. TPU with 70 A hardness had better ductility and embedded possession. The wear modes of TPU with 70 A hardness were crimping and micro-plowing. Only mild wear occurred on the wear surface of TPU with 70 A hardness. The main wear mechanisms of the TPU with 70 A hardness were abrasive wear and fatigue wear under sediment conditions. In summary, TPU with 70 A hardness was the most suitable for water-lubricated stern bearings under sediment conditions. The data from this study provide deep insight into the wear process of TPU materials with different hardness under sediment conditions and may be useful for selecting the proper TPU material hardness for water-lubricated stern bearings.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7

Similar content being viewed by others

References

  1. Z.L. Xie, N. Ta and Z.S. Rao, The Lubrication Performance of Water Lubricated Bearing with Consideration of Wall Ship and Inertial Force, J. Hydrodyn., 2017, 29, p 52–60.

    Article  Google Scholar 

  2. W. Litwin, Experimental Research on Water Lubricated Three Layer Sliding Bearing with Lubrication Grooves in the Upper Part of the Bush and Its Comparison with a Rubber Bearing, Tribol. Int., 2015, 82, p 153–161.

    Article  CAS  Google Scholar 

  3. F. Andritsos, H. Cozijn. An Innovative Oil Pollution Containment Method for Ship Wrecks Proposed for Offshore Well Blow-Outs. In: ASME 2011 30th International Conference on Ocean, Offshore Arctic Engineering, 2011, 73–81.

  4. Y.W. Sun, X.P. Yan, C.Q. Yuan and X.Q. Bai, Insight into Tribological Problems of Green Ship and Corresponding Research Progresses, Friction, 2018, 4, p 1–12.

    Google Scholar 

  5. W.H. Briscoe, S. Titmuss, F. Tibeng, R.K. Thomas, D.J. McGillivray and J. Klein, Boundary Lubrication Under Water, Nature, 2006, 444, p 191–194.

    Article  CAS  Google Scholar 

  6. X.P. Yan, C.Q. Yuan, X.Q. Bai and L. Xu, Research Status and Advances of Tribology of Green Ship, Tribology, 2012, 32(4), p 410–420.

    Google Scholar 

  7. T.D. Ta, A.K. Tieu, H. Zhu et al., Tribological Behavior of Aqueous Copolymer Lubricant in Mixed Lubrication Regime, ACS Appl. Mater. Inter., 2016, 8, p 5641–5652.

    Article  CAS  Google Scholar 

  8. D. Savio, K. Falk and M. Moseler, Slipping Domains in Water-Lubricated Microsystems For Improved Load Support, Tribol. Int., 2018, 120, p 269–279.

    Article  Google Scholar 

  9. C.Q. Yuan, Z.X. Peng, X.C. Zhou and X.P. Yan, The Surface Roughness Evolutions of Wear Particles and Wear Components Under Lubricated Rolling Wear Condition, Wear, 2005, 259, p 512–518.

    Article  CAS  Google Scholar 

  10. Z.W. Guo, C.Q. Yuan, A.X. Liu et al., Study on Tribological Properties of Novol Biomimetic Material for Water-Lubricated Stern Tube Bearing, Wear, 2017, 376–377, p 911–919.

    Article  Google Scholar 

  11. Changjiang Water Resources Commission of the Ministry of Water Resources. Changjiang Sediment Bulletin 2018, China, 2019.

  12. Q.X. Xu, G. Shi and Z.F. Chen, Analysis of Recent Changing Characteristics and Tendency Runoff and Sediment Transport in the Upper Reach of Yangtze River, Adv. Water Sci., 2004, 15(14), p 420–426.

    Google Scholar 

  13. S.M. Nahvi, P.H. Shipway and D.G. McGartney, Effects of Particle Crushing in Abrasion Testing of Steels with Ash from Biomass-Fired Powerplants, Wear, 2009, 267(1–4), p 34–42.

    Article  CAS  Google Scholar 

  14. C.Q. Yuan, Z.W. Guo, W. Tao, C.L. Dong and X.Q. Bai, Effects of Different Grain Sized Sands on Wear Behaviours of NBR/Casting Copper Alloys, Wear, 2017, 384–385, p 185–191.

    Article  Google Scholar 

  15. C.L. Dong, C.Q. Yuan, X.Q. Bai, Y. Yang and X.P. Yan, Study on Wear Behaviours for NBR/Stainless Steel Under Sand Water-Lubricated Conditions, Wear, 2015, 332–333, p 1012–1020.

    Article  Google Scholar 

  16. S. Xiao and H. Sue, Effect of Molecular Weight on Scratch and Abrasive Wear Behaviors of Thermoplastic Polyurethane Elastomers, Polymer, 2019, 169, p 124–130.

    Article  CAS  Google Scholar 

  17. M. Avalle and R. Elisa, Tribological Characterization of Modified Polymeric Blends, Procedia Struct. Integr., 2018, 8, p 239–255.

    Article  Google Scholar 

  18. M. Zahid, A.E.D.R. Castillo, S.B. Thorat et al., Graphene Morphology Effect on the Gas Barrier, Mechanical and Thermal Properties of Thermoplastic Polyurethane, Compos. Sci. Technol., 2020, 200, p 108461.

    Article  CAS  Google Scholar 

  19. X.Y. Li, G.L. Wang, C.X. Yang et al., Mechanical and EMI Shielding Properties of Solid and Microcellular TPU/Nanographite Composite Membranes, Polym. Test., 2021, 93, p 106891.

    Article  CAS  Google Scholar 

  20. J.L. Xuan, I.T. Hong and E.C. Fitch, Hardness Effect on Three-Body Abrasive Wear Under Fluid Lubrication, J. Tribol-T ASME, 1989, 111, p 35–40.

    Article  Google Scholar 

  21. A.A. SemenetsEmail and V.N. Anisimov, Development of Triboengineering Composite Materials Based on Thermoplastic Polyurethanes, J. Frict. Wear, 2010, 31, p 208–213.

    Article  Google Scholar 

  22. Ministry of Water Resources of the People’s Republic of China. China River Sediment Bulletin 2018, China, 2019.

  23. H. Wang, X.B. Ran, J. Liu, W.T. Wu, M.L. Li and J.Y. Zang, Response of the Sediment Geochemistry of the Changjiang River (Yangtze River) to the Impoundment of the Three Gorges Dam, J. Environ. Sci-China, 2019, 83, p 161–173.

    Article  Google Scholar 

  24. Department of Defense, MIL-DTL-17901C (SH). Bearing Components, Bonded Synthetic Rubber, Water Lubricated, 2005, p. 8.

  25. R. Gheisari and A.A. Polycarpou, Three-Body Abrasive Wear of Hard Coatings: Effects of Hardness and Roughness, Thin Solid Films, 2018, 666, p 66–75.

    Article  CAS  Google Scholar 

  26. G.M. Krolczyk, R.W. Maruda, J.B. Krolczyk, P. Nieslony, S. Wojciechowski and S. Legutko, Parametric and Nonparametric Description of the Surface Topography in the Dry and MQCL Cutting Conditions, Measurement, 2018, 121, p 225–239.

    Article  Google Scholar 

  27. G.M. Krolczyk, J.B. Krolczyk, R.W. Maruda, S. Legutko and M. Tomaszewski, Metrological Changes in Surface Morphology of High-Strength Steels in Manufacturing Processes, Measurement, 2016, 88, p 176–185.

    Article  Google Scholar 

  28. J.J. Han, W. Zheng and G.C. Wang, Investigation of Influence Factors on Surface Roughness of Micro-Scale Features, Precis. Eng., 2019, 56, p 524–529.

    Article  Google Scholar 

  29. I. Saravanan, A.E. Perumal and V. Balasubramanian, A Study of Frictional Wear Behavior of Ti6Al4V and UHMWPE Hybrid Composite on TiN Surface for Bio-Medical Applications, Tribol. Int., 2016, 98, p 179–189.

    Article  CAS  Google Scholar 

  30. S.F. Weng and Y.Z. Xu, Fourier Transform Infrared Spectroscopy, 3rd ed. Chemical Industry Press, China, 2016.

    Google Scholar 

  31. P. Siddaramaiah, B. Suresha and J. Lee, Mechanical and Three-Body Abrasive Wear Behaviour of PMMA/TPU Blends, Mater. Sci. Eng. A, 2008, 492(1–2), p 486–490.

    Google Scholar 

  32. P. Nieslony, G.M. Krolczyk, S. Wojciechowski, R. Chudy, K. Zak and R.W. Maruda, Surface Quality and Topographic Inspection of Variable Compliance Part After Precise Turning, Appl. Surf. Sci., 2018, 434, p 91–101.

    Article  CAS  Google Scholar 

  33. V.L. Popov, Contact Mechanics and Friction: Physical Principles and Applications, 2nd ed. Springer, Germany, 2016.

    Google Scholar 

  34. S.Z. Wen and P. Huang, Principles of Tribology, 4th ed. Tsinghua University Press, China, 2012.

    Google Scholar 

  35. W. Litwin and C. Dymarski, Experimental Research on Water-Lubricated Marine Stern Tube Bearings in Conditions of Improper Lubrication and Cooling Causing Rapid Bush Wear, Tribol. Int., 2016, 95, p 449–455.

    Article  Google Scholar 

  36. J.Y. Gong, Y. Jin, Z.L. Liu, H. Jiang and M.H. Xiao, Study on Influencing Factors of Lubrication Performance of Water-Lubricated Micro-Groove Bearing, Tribol. Int., 2019, 129, p 390–397.

    Article  Google Scholar 

  37. W. Litwin, Influence of Local Bush Wear on Water Lubricated Sliding Bearing Load Carrying Capacity, Tribol. Int., 2016, 103, p 352–358.

    Article  Google Scholar 

Download references

Acknowledgments

This work was supported by the National Natural Science Foundation of China (51509195).

Author information

Authors and Affiliations

  1. Key Laboratory of Marine Power Engineering and Technology (Ministry of Transport), Wuhan University of Technology, Wuhan, 430063, China

    Zhengming Jia, Zhiwei Guo & Chengqing Yuan

  2. Reliability Engineering Institute, National Engineering Research Center for Water Transportation Safety, Wuhan, 430063, China

    Zhengming Jia, Zhiwei Guo & Chengqing Yuan

Authors
  1. Zhengming Jia
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Zhiwei Guo
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Chengqing Yuan
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Chengqing Yuan.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Jia, Z., Guo, Z. & Yuan, C. Effect of Material Hardness on Water Lubrication Performance of Thermoplastic Polyurethane under Sediment Environment. J. of Materi Eng and Perform 30, 7532–7541 (2021). https://doi.org/10.1007/s11665-021-05912-z

Download citation

  • Received:

  • Revised:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11665-021-05912-z

Keywords

Search

Navigation