Abstract
In this work, scanning vibrating electrode technique and local electrochemical impedance spectroscopy measurements were used to investigate the effects of stress and hydrogen on electrochemical corrosion behavior of a X100 pipeline steel in a near-neutral pH solution. The stress distribution on the test specimen was calculated using the finite element method. Results demonstrated that the hydrogen-charging enhances the local anodic dissolution of the steel, contributing to the formation of a layer of corrosion product. However, there is little difference of the charge-transfer resistance between the regions with and without hydrogen-charging due to rapid diffusion of hydrogen atoms throughout the specimen with time. When the local stress concentration is not significant enough to approach the yielding strength of the steel, the steel is still in a relatively stable state, and there is a uniform distribution of dissolution rate over the whole surface of the steel specimen. Although the stress-enhanced activation is not sufficient to result in an apparent difference of current density of the steel, the activation of the steel would activate dislocations, which serve as effective traps to the charged hydrogen atoms. With the increase of hydrogen concentration, the hydrogen-enhanced anodic dissolution becomes dominant.
Similar content being viewed by others
References
K.T. Corbett, R.R. Bowen, and C.W. Petersen, High Strength Steel Pipeline Economics, Int. J. Offshore Polar Eng., 2004, 14, p 75–79
F.J. Sánchez, B. Mishra, and D.L. Olson, Magnetization Effect on Hydrogen Absorption in High-strength Steels and its Implications, Scripta Mater., 2005, 53, p 1443–1448
C. Kalwa, H.G. Hillenbrand, and M. Gräf, High-strength Steel Pipes: New Developments and Applications, Onshore Pipeline Conference, Houston, Texas, June 10-11, 2002
D. Porter, A. Laukkanen, P. Nevasmaa, K. Rahka, and K. Wallin, Performance of TMCP Steel with Respect to Mechanical Properties After Cold Forming and Post-forming Heat Treatment, Int. J. Pressure Vessels Piping, 2004, 81, p 867–877
H.E. Minor, A. Kifani, M. Louah, Z. Azari, and G. Pluvinage, Fracture Toughness of High Strength Steel—Using the Notch Stress Intensity Factor and Volumetric Approach, Struct. Saf., 2003, 25, p 35–45
Y.Z. Wang, R.W. Revie, M.T. Shehata, R.N. Parkins, and K. Krist, Initiation of Environment Induced Cracking in Pipeline Steel: Micro-structural Correlation, International Pipeline Conference, ASME, Calgary, 1998.
W. Zheng, Stress Corrosion Cracking of High (or Low) Strength Steels: Preliminary Results and Relevance to New Pipeline Systems, Presentations in the TransCanada Pipelines SCC Workshop, Calgary, Sept 22, 2006
W. Zheng, D. Billy, J. Li, J.T. Bowker, J.A. Gianetto, R.W. Revie, and G. Williams, Studies of Stress Corrosion Cracking of X100 Steel by a Full Scale Test Apparatus, Proceedings of the 2006 International Pipeline Conference, IPC2006-10084, Calgary, Canada, Sept 25-29, 2006
M.A. Almonsour, “Sulfide Stress Corrosion Resistance of X100 Steel in H2S Environments,” MSc thesis, University of British Columbia, Vancouver, 2007
R.N. Parkins, A Review of Stress Corrosion Cracking of High Pressure Gas Pipelines, Corrosion 2000, NACE, Houston, 2000, Paper No. 363
B.Y. Fang, A. Atrens, J.Q. Wang, E.H. Han, Z.Y. Zhu, and W. Ke, Review of Stress Corrosion Cracking of Pipeline Steels in “Low” and “High” pH Solutions, J. Mater. Sci., 2003, 38, p 127–132
M. Baker Jr., Stress Corrosion Cracking Studies, Integrity Management Program DTRS56-02-D-70036, Department of Transportation, Office and Pipeline Safety, 2004
National Energy Board, Report of Public Inquiry Concerning Stress Corrosion Cracking on Canadian Oil and Gas Pipelines, MH-2-95, November 1996
Y.F. Cheng, Thermodynamically Modeling the Interactions of Hydrogen, Stress and Anodic Dissolution at Crack-tip During Near-neutral pH SCC in Pipelines, J. Mater. Sci., 2007, 42, p 2701–2705
C.W. Du, X.G. Li, P. Liang, Z.Y. Liu, G.F. Jia, and Y.F. Cheng, Effects of Microstructure on Corrosion of X70 Pipe Steel in an Alkaline Soil, J. Mater. Eng. Perform., 2009, 18, p 216–220
R.N. Parkins, W.K. Blanchards, Jr., and B.S. Delanty, Transgranular Stress Corrosion Cracking of High-pressure Pipelines in Contact with Solutions of Near Neutral pH, Corrosion, 1994, 50, p 394–408
L. Niu and Y.F. Cheng, Corrosion Behaviour of X-70 Pipe Steel in Near-neutral pH Solution, Appl. Surf. Sci., 2007, 253, p 8626–8631
W. Bouaeshi, S. Ironside, and R. Eadie, Research and Cracking Implications from an Assessment of Two Variants of Near-neutral pH Crack Colonies in Liquid Pipelines, Corrosion, 2007, 63, p 648–660
Y.F. Cheng and L. Niu, Mechanism for Hydrogen Evolution Reaction on Pipeline Steel in Near-neutral pH Solution, Electrochem. Commun., 2007, 9, p 558–562
B. Gu, J. Luo, and X. Mao, Hydrogen-facilitated Anodic Dissolution-type Stress Corrosion Cracking of Pipeline Steels in Near-neutral pH Solution, Corrosion, 1999, 55, p 96–108
L.J. Qiao, J.L. Luo, and X. Mao, Hydrogen Evolution and Enrichment Around Stress Corrosion Crack Tips of Pipeline Steels in Dilute Bicarbonate Solution, Corrosion, 1998, 54, p 115–120
L. Zhang, X.G. Li, C.W. Du, and Y.F. Cheng, Corrosion and Stress Corrosion Cracking Behavior of X70 Pipeline Steel in a CO2-containing Solution, J. Mater. Eng. Perform., 2009, 18, p 319–323
T.M. Ahmed, S.B. Lambert, R. Sutherby, and A. Plumtrel, Cyclic Crack Growth of X-60 Pipeline Steel in a Neutral Dilute Solution, Corrosion, 1997, 53, p 581–590
T.R. Jack, B. Erno, and K. Krist, Generation of Near-neutral pH and High pH SC Environments on Buried Pipelines, Corrosion/2000, NACE, Houston, TX, 2000, Paper No. 362
J.A. Beavers, C.L. Durr, B.S. Delanty, D.M. Owen, and R.L. Sutherby, Near-neutral pH SCC: Crack Propagation in Susceptible Soil Environments, Corrosion/2001, NACE, Houston, TX, 2001, Paper No. 217
R.R. Fessler and K. Krist, Research Challenges Regarding Stress Corrosion Cracking of Pipelines, Corrosion/2000, NACE, Houston, TX, 2000, Paper No. 370
X. Tang and Y.F. Cheng, Micro-electrochemical Characterization of the Effect of Applied Stress on Local Anodic Dissolution Behavior of Pipeline Steel Under Near-neutral pH Condition, Electrochim. Acta, 2009, 54, p 1499–1505
G.Z. Meng, C. Zhang, and Y.F. Cheng, Effects of Corrosion Product Deposit on the Subsequent Cathodic and Anodic Reactions of X-70 Steel in Near-neutral pH Solution, Corros. Sci., 2008, 50, p 3116–3122
C.F. Dong, A.Q. Fu, X.G. Li, and Y.F. Cheng, Localized EIS Characterization of Corrosion of Steel at Coating Defect Under Cathodic Protection, Electrochim. Acta, 2008, 54, p 628–633
X. Tang and Y.F. Cheng, Localized Dissolution Electrochemistry at Surface Irregularities of Pipeline Steel, Appl. Surf. Sci., 2008, 254, p 5199–5205
M.C. Li and Y.F. Cheng, Mechanistic Investigation of Hydrogen-enhanced Anodic Dissolution of X-70 Pipe Steel and its Implication on Near-neutral pH SCC of Pipelines, Electrochim. Acta, 2007, 52, p 8111–8117
Y.F. Cheng and X. Tang, Micro-electrochemical Characterization of the Synergism of Hydrogen and Stress in Anodic Dissolution of Steel and its Implications on Pipeline Stress Corrosion Cracking, Proceeding of the 6th International Pipeline Conference, IPC2008-64142, Calgary, Canada, Sept 29 to Oct 3, 2008
M.Z. Yang, J.L. Luo, Q. Yang, L.J. Qiao, Z.Q. Qin, and P.R. Norton, Effects of Hydrogen on Semiconductivity of Passive Film and Corrosion Behavior of 310 Stainless Steel, J. Electrochem. Soc., 1999, 146, p 2107–2112
E. Sanjuan, “Studies of Corrosion and Stress Corrosion Cracking Behavior of High-strength Pipeline Steels in Carbonate/Bicarbonate Solutions,” MSc thesis, University of Calgary, Canada, March 2008
Acknowledgments
This work was supported by Canada Research Chairs Program, Natural Science Foundation of China (Project Nos. 50671007 and 50731003), and Chinese Scholarship Council.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Zhang, C., Cheng, Y.F. Synergistic Effects of Hydrogen and Stress on Corrosion of X100 Pipeline Steel in a Near-Neutral pH Solution. J. of Materi Eng and Perform 19, 1284–1289 (2010). https://doi.org/10.1007/s11665-009-9579-3
Received:
Revised:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11665-009-9579-3