Abstract
The kinetics of europium oxide (Eu2O3) chlorination using gaseous chlorine as a chlorination agent was studied between 523 K and 1223 K (250 °C and 950 °C). The relative mass change during the chlorination reaction was continuously monitored using a high resolution thermogravimetric system. The starting temperature for the reaction of Eu2O3(s) with chlorine was determined at about 523 K (250 °C) with the formation of solid europium oxychloride (EuOCl). For temperatures above 1123 K (850 °C), the EuOCl(s) is chlorinated producing EuCl3(l). The influence of gaseous flow rate, sample mass, chlorine partial pressure, and temperature on the reaction rate was analyzed. The results showed that for 673 K (400 °C) and temperatures below, the system is under chemical control. Concerning the influence of chlorine partial pressure, it was determined that pressures greater than 50 kPa do not modify the kinetic regime. For the experiment at 673 K (400 °C), it was found that the chlorination rate was proportional to a potential function of the partial pressure of chlorine whose exponent is 0.54. The conversion curves were analyzed with the Johnson–Mehl–Avrami description. Intrinsic activation energy of 115 kJ mol−1 was obtained for the temperature range of 573 K to 673 K (300 °C to 400 °C). Finally, a global rate equation that includes these parameters was developed.
Similar content being viewed by others
References
K.A. Gschneidner and L. Eyring: Handbook on the Physics and Chemistry of Rare Earths, Elsevier, Amsterdam, 1981.
K. Binnemans, P.T. Jones, B. Blanpain, T.V. Gerven, Y. Yang, A. Walton, and M.J. Buchert: J. Clean. Prod., 2013, vol. 51, pp. 1–22.
O.P. Dimitriev and V.V. Kislyuk: Chem. Phys. Lett., 2003, vol. 377, pp. 149-155.
D.M. Considine: Chemical and Process Technology Encyclopedia, McGraw Hill, New York, 1974, pp. 961-962.
R.C. Weast and M.J. Astle: CRC Handbook of Chemistry and Physics, 63rd edn, CRC Press, Boca Raton, FL, 1983, pp. 16.
K. Kuriki, Y. Koike, Y. Okamoto: Chem. Rev., 2002, vol. 102, pp. 2347–2356.
W. Zhu, Q. Jiang, Z. Lu, X. Wei, M. Xie, D. Zou, T. Tsutsui: Synthetic Metals, 2000, vol. 111–112, pp. 445–447.
G.E. Khalil, K. Lau, G.D. Phelan, B. Carlson, M. Gouterman, J.B. Callis, L.R. Dalton: Review of Scientific Instruments, 2004, vol. 75, pp. 192–206.
F.B. Wu, S.Q. Han, C. Zhang, Y.F. He: Analytical Chemistry, 2002, vol. 74, pp. 5882–5889.
B. Jezowska-Trzebiatowska, S. Kopacz, T. Mikulski: The Rare Elements – Occurrence and Technology; Elsevier, Amsterdam, 1990, pp. 97.
M. Gimenes and H. Oliveira: Metall. Mater. Trans. B, 2001, vol. 32, pp. 1007-1013.
J.P. Gaviría, L.G. Navarro, A.E. Bohé: J. Phys. Chem. A, 2012, vol. 116, pp. 2062-2070.
G. Adachi, K. Shinozaki, Y. Hirashima, K. Machida: J. Less-Common Met., 1991, vol. 169, L1.
G. Adachi, K. Murase, S. Shinozaki, and K. Machida: Chem. Lett., 1992, pp. 511.
Y-H. Sun, Z-C. Wang, L. Wuo: J. Alloys and Comp., 1998, vol. 269, pp. 88-91.
Y-H. Sun, Z-C. Wang, L. Wuo: J. Rare Earths, 1999, vol. 17, pp. 178.
D.R. Lide: Handbook of Chemistry and Physics, 85nd edn., CRC Press Inc., FL, 2005.
HSC 6.12, Chemistry for Windows, Outokumpu Research, Oy, Pori, Finland, 2007.
M.V. Bosco, G.G. Fouga, A.E. Bohé: Thermochim. Acta, 2012, vol. 540, pp. 98-106.
Joint Committee for Powder Diffraction Standards, Powder Diffraction File, International Center for Diffraction Data, Swarthmore, PA, 1996.
S.K. Kim: Ph.D. Thesis, University of Utah, 1981.
J. Szekely, J.W. Evans, H.Y. Sohn: Gas-Solid Reactions; Academic Press, New York, 1976.
A.W. Hills: Metall. Trans. B, 1978, vol. B9, pp. 121-128.
W.E. Ranz, W.R.Jr. Marshall: Chem. Eng. Prog., 1952, vol. 48, pp. 141-146.
G.H. Geiger, D.R. Poirier: Transport Phenomena in Metallurgy, Addison-Wesley, Massachusetts, 1973, pp. 7-13.
G. Hakvoort: Thermochim. Acta, 1994, vol. 233, pp. 63-73.
J.P. Gaviría and A.E. Bohé: Metall. Mater. Trans. B, 2009, vol. 40B, pp. 45-53.
J.P. Gaviría, G.G. Fouga, A.E. Bohé: Thermochim. Acta, 2011, vol. 517, pp. 24-33.
J.H. Flynn: J. Therm. Anal., 1988, vol. 34, pp. 367-381.
S. Vyazovkin: Thermochim. Acta, 2000, vol. 355, pp. 155-163.
M. Avrami: J. Chem. Phys., 1939, vol. 7(12), pp. 1103-1113.
M. Avrami: J. Chem. Phys., 1940, vol. 8(2), pp. 212-224.
M. Avrami: J. Chem. Phys., 1941, vol. 9(2), pp. 177-184.
W.A. Johnson, R.F. Mehl: Trans. Am. Inst. Min. Metall. Engs., 1939, vol. 135, pp. 416-427.
A.T.W. Kempen, F. Sommer, E.J. Mittemeijer: J. Mater. Sci., 2002, vol. 37(2), pp. 1321-1332.
M.R. Esquivel, A.E. Bohé, D.M. Pasquevich: J. Mat. Process. Techn., 2005, vol. 170, pp. 304-309.
Acknowledgments
The authors thank the Consejo Nacional de Investigaciones Científicas y Técnicas (CONICET), Universidad Nacional de Comahue, and Agencia Nacional de Promoción Científica y Tecnológica (ANPCyT) for financial support of this work.
Author information
Authors and Affiliations
Corresponding author
Additional information
Manuscript submitted February 25, 2013.
Rights and permissions
About this article
Cite this article
Pomiro, F.J., Fouga, G.G. & Bohé, A.E. Kinetic Study of Europium Oxide Chlorination. Metall Mater Trans B 44, 1509–1519 (2013). https://doi.org/10.1007/s11663-013-9931-8
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11663-013-9931-8