Abstract
The objective of this work was to produce an alloy showing a microstructure similar to Ni-base superalloys, but with Pt as base metal. The Pt-base alloys with various contents of Al, Cr, and Ni were arc melted. Solution heat treatments at 1450 °C followed by water quenching lead to single-phase alloys. Ageing at 1000 °C resulted in the precipitation of Ll2 ordered particles. An alloy with 11 at. pct Al, 3 at. pct Cr, 6 at. pct Ni, and Pt balance shows cuboidal precipitates with edge lengths of 200 to 500 nm along with a volume fraction of 23 pct and a lattice misfit of −0.1 pct. Aging at 1100 °C leads to coarsening of precipitates. Volume fraction and morphology of the precipitates were investigated by scanning electron microscopy and optical microscopy. X-ray diffraction as well as transmission electron microscopy (TEM) were applied to verify the crystal structure.
Similar content being viewed by others
References
D.M. Wee and T. Suzuki: Trans. Jpn. Inst. Met., 1979, vol. 20, pp. 634–46.
B.H. Kear and G.F. Wilsdorf: Trans. TMS-AIME, 1962, vol. 224 (4), pp. 382–86.
S.M. Copley and B.H. Kear: Trans. TMS-AIME, 1967, vol. 239, pp. 984–92.
S. Takeuchi and E. Kuramoto: J. Phys. Soc. Jpn., 1971, vol. 31, p. 1282.
S. Takeuchi and E. Kuramoto: Acta Metall., 1973, vol. 21, pp. 415–25.
C.T. Sims, N.S. Stoloff, and W.C. Hagel: Superalloys II: High Temperature Materials for Aerospace and Industrial Power, Wiley-Interscience, New York, NY, 1987.
Y. Yamabe, Y. Koizumi, Murakami, Y. Ro, T. Maruko, and H. Harada: Scripta Mater., 1996, vol. 35 (2), pp. 211–15.
Y. Yamabe-Mitarai, Y. Koizumi, Murakami, Y. Ro, T. Maruko, and Harada: Scripta Mater., 1997, vol. 36 (4), pp. 393–98.
Y. Yamabe-Mitarai, Y. Ro, T. Maruko, and Harada: Intermetallics, 1999, vol. 7, pp. 49–58.
X.H. Yu, Y. Yamabe-Mitarai, Y. Ro, and Harada: Metall. Mater. Trans. A, 2000, vol. 31A, pp. 173–78.
P. Panfilov, A. Yermarkov, V. Dmitriev, and N. Timofeev: Platinum Met. Rev., 1991, vol. 35, pp. 196–200.
G.B. Fairbank, C.J. Humphreys, A. Kelly, and C.N. Jones: Intermetallics, 2000, vol. 8 (9), pp. 1091–1100.
P.J. Hill, G.B. Fairbank, and L.A. Cornish: JOM, 2001, vol. 53, pp. 19–20.
P.J. Hill, N. Adams, T. Biggs, P. Ellis, T. Hohls, S.S. Taylor, and I.M. Wolff: Mater. Sci. Eng. A, 2002, vol. 329, pp. 295–304.
P.J. Hill, T. Biggs, P. Ellis, J. Hohls, S. Taylor, and I.M. Wolff: Mater. Sci. Eng., 2001, vol. A301, pp. 167–79.
P.J. Hill, L.A. Cornish, and M.J. Witcomb: Proc. Int. Symp. on High Temperature Corrosion and Protection, 2000, pp. 185–90.
P.J. Hill, L.A. Cornish, P. Ellis, and M.J. Witcomb: J. Alloys Compounds, 2001, vol. 322, pp. 166–75.
P.J. Hill, Y. Yamabe-Mitarai, H. Murakami, L.A. Cornish, M.J. Witcomb, I.M. Wolff, and H. Harada: in Structural Intermetallics, 2001, K.J. Hemker, ed., TMS, Warrendale, PA, 2002, pp. 527–33.
L.A. Cornish, J. Hohls, P.J. Hill, S. Prins, R. Süss, and D.N. Compton: J. Mining Metall., 2002, vol. 38B (3–4), pp. 197–204.
R. Süss, D. Freund, R. Völkl, B. Fischer, P.J. Hill, P. Ellis, and I.M. Wolff: Mater. Sci. Eng. A, 2002, vol. 338, pp. 133–41.
L.A. Cornish, B. Fischer, and R. Völkl: MRS Bull., 2003, vol. 28 (9), pp. 632–38.
Y. Yamabe-Mitarai, M.H. Hong, Y. Ro, and H. Harada: Phil. Mag. Lett., 1999, vol. 79 (9), pp. 673–82.
Y. Mishima, Y. Oya, and T. Suzuki: Proc. Int. Conf. on Martensitic Transformations, The Japan Institute of Metals JIM, 1986, pp. 1009–14.
Y. Oya, Y. Mishima, and T. Suzuki: Z. Metallkd., 1987, vol. 78 (7), pp. 485–90.
T.B. Massalski: Binary Alloy Phase Diagrams, ASM INTERNATIONAL, Materials Park, OH, 1990.
Y. Yamabe-Mitarai and H. Aoki: J. Alloys Compounds, 2003, vol. 359, pp. 143–52.
C. Huang, Y. Yamabe-Mitarai, K. Nishida, and H. Harada: Intermetallics, 2003, vol. 11, pp. 917–26.
C. Huang, Y. Yamabe-Mitarai, and H. Harada: J. Alloys Compounds, 2004, vol. 366, pp. 217–21.
H. Meininger and M. Ellner: J. Alloys Compounds, 2003, vol. 353, pp. 207–12.
J.C. Zhao: J. Mater. Res., 2001, vol. 16, pp. 1565–78.
M.V. Whalen: Platinum Met. Rev., 1988, vol. 32 (1), pp. 2–10.
D. Lupton, J. Merker, B. Fischer, and R. Völkl: 6th Int. Conf. Advances in Fusion & Processing of Glass, Ulm, Germany, May 29–31, 2000; Proc.: Glass Science and Technology • Glastechnische Berichte, Helmut A. Schaeffer and James R. Varner, eds., Frankfurt/Main vol. 73C2, 2000, pp. 284–93.
J.L. Kamm and W.W. Milligan: Scripta Metall. Mater., 1994, vol. 31 (11), pp. 1461–64.
Metals Handbook, 9th ed., K. Mills, J.R. Davis, J.D. Destefani, D.A. Dietrich, G.M. Crankovic, J. Frissel, D.M. Jenkins, W.H. Cubberly, and R.L. Stedfeld, eds., ASM, Metals Park, OH, 1985, vol. 9.
M.R. Jackson and J.R. Rairden: Metall. Trans. A, 1977, vol. 8A, pp. 1697–1707.
Y.Y. Qiu: J. Alloys Compounds, 1996, vol. 232, pp. 254–63.
D. Siebörger, H. Brehm, F. Wunderlich, D. Möller, and U. Glatzel: Z. Metallkd., 2001, vol. 92, pp. 58–61.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Hüller, M., Wenderoth, M., Glatzel, U. et al. Optimization of composition and heat treatment of age-hardened Pt-Al-Cr-Ni alloys. Metall Mater Trans A 36, 681–689 (2005). https://doi.org/10.1007/s11661-005-0184-2
Received:
Issue Date:
DOI: https://doi.org/10.1007/s11661-005-0184-2