Abstract
The cyclic creep and cyclic plastic deformation behavior of two commercial suspension spring steels of high hardness levels, namely, SAE 9259 and SAE 5160, were studied under different testing conditions of cyclic peak stress and cyclic stress ratio. The experimental results indicate that both the cyclic stress ratio and cyclic peak stress have strong, but complicated, effects on the cyclic creep and cyclic plastic deformation behavior of these materials. It has also been found that the addition of silicon can increase the resistance of these steels to cyclic creep and cyclic plastic deformation, although the extent of this increase is also related to other cyclic deformation conditions. A transition in the relationship between the total plastic strain range and the cyclic stress ratio (R) has been detected at approximately R=0.5. The mechanism of such a transition is explained by the operation of cross-slip during the unloading process of cycling. Moreover, a cyclic softening behavior of these spring steels in the quench-tempered condition was also detected and is attributed to the activation and reorganization of obstacle dislocations introduced into the steels during the process of martensitic transformation. More importantly, this study has indicated that parameters such as the cyclic creep strain, the cyclic creep rate in the secondary creep stage, and the total cyclic plastic strain range can better reflect, and should be used to depict and characterize, the sag behavior of spring steels as well as other materials. Finally, the effect of silicon on sag behavior, in comparison with the results from the Bauschinger-effect test, has also been discussed through the influence of Si on carbide formation and distribution.
Similar content being viewed by others
References
M. Assefpour-Dezfuly and A. Brownrigg: Metall. Trans. A, 1989, vol. 20A, pp. 1951–59.
E. Gariboldi, W. Nicodemi, G. Silva, and M. Vedani: Metall. Sci. Technol., 1994, vol. 12, p. 12.
A. Brownrigg and T. Sritharan: Mater. Forum, 1987, vol. 10, p. 58.
Z.A. Yang and Z. Wang: Metall. Trans. A, 1993, vol. 24A, p. 2083–93.
Z.A. Yang and Z. Wang: Mater. Sci. Eng. A, 1996, vol. 210, p. 83.
Z.A. Yang and Z. Wang: Proc. Int. Symp. on Recovery and Recrystallization in Steel, ISS, Warrendale, PA, 1995, vol. 33, p. 355.
Z.A. Yang and Z. Wang: University of Toronto, Toronto, unpublished research, 1998.
T. Wehner and A. Fatemi: Int. J. Fatigue, 1991, vol. 13, p. 241.
H. Chai and C. Laird: Mater. Sci. Eng., 1987, vol. 93, p. 159.
N.H. Polakowski: Iron Steel Inst., London, 1952, vol. 169, p. 237.
J.N. Kenyon: Proc. ASTM, 1950, vol. 50, p. 1073.
F. Lorenzo and C. Laird: Acta Metall., 1984, vol. 32, p. 681.
Z.A. Yang, Z. Wang, X. Hu, and Z.G. Wang: Acta Metall., 1993, vol. 41, p. 933.
A.J. Kennedy: Proc. Int. Ist Conf. on Fatigue of Metals, Institute of Mechanical Engineers, London & New York, 1956, p. 401.
D.H. Shin, I.S. Choi, and S.W. Nam: J. Mater. Sci. Lett., 1983, vol. 2, p. 688.
J. Weertman and W.V. Green: J. Nucl. Mater., 1977, vol. 68, p. 205.
A.H. Meleka and A.V. Evershed: J. Inst. Met., 1959, vol. 88, p. 411.
D.K. Shetty and A. Mishii: Metall. Trans. A, 1975, vol. 6A, p. 34–58.
P.S.G. Benette and J.T. Evans: Mater. Sci. Eng., 1979, vol. 38, p. 111.
F. Lorenzo and C. Laird: Acta Metall., 1984, vol. 32, p. 671.
H.D. Chandley: Acta Metall., 1985, vol. 32, p. 1121.
P. Lukas and L. Kunz: Mater. Sci. Eng. A, 1979, vol. 174, p. 15.
H. Kawakami, Y. Yamada, S. Ashida, and K. Shiwaku: SAE Cong., SAE, Warrendale, PA, 1982, paper no. 820128, p. 1.
J. Gordine and I. Codd: J. Iron Steel Inst., 1969, vol. 207, p. 401.
R.A. Hobbs, G.W. Lorimer, and N. Ridley: J. Iron Steel Inst., 1972, vol. 210, p. 757.
C.E. Feltner and C. Laird: Acta Metall., 1967, vol. 15, p. 1621.
C.E. Feltner and C. Laird: Acta Metall., 1967, vol. 15, p. 1633.
A.M. Asseiro and S.L. Kaye: SAE Congr., SAE, Warrendale, PA, 1993, paper no. 930968, p. 1.
H.J. Tata, E.R. Driscoll, and J.J. Kary: SAE Congr., SAE, Warrendale, PA, 1980, paper no. 800480 p. 1.
S.T. Furr: SAE Congress, SAE, Warrendale, PA, 1980, paper no. 800479, p. 1.
A.S. Kenneford and G.C. Ellis: J. Iron Steel Inst. 1950, vol. 164, p. 265.
H.A. Chang and J.J. Kai: J. Nucl. Mater., 1992, vols. 191–94, p. 836.
D.M. Li, W.J. Nam, and C.S. Lee: Metall. Mater. Trans. A, 1998, vol. 29A, p. 1431–39.
Z. Wang, T.H. Yin, and H. Ni: University of Toronto, Toronto, unpublished experimental results, Dec. 1999.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Yang, Z., Wang, Z. Cyclic creep and cyclic deformation of high-strength spring steels and the evaluation of the sag effect: Part I. Cyclic plastic deformation behavior. Metall Mater Trans A 32, 1687–1698 (2001). https://doi.org/10.1007/s11661-001-0147-1
Received:
Issue Date:
DOI: https://doi.org/10.1007/s11661-001-0147-1