Skip to main content

Advertisement

SpringerLink
Log in

Energy Storage Performance of a PCM in the Solar Storage Tank

  • Published:
Journal of Thermal Science Aims and scope Submit manuscript

Abstract

High-temperature solar thermal power station with solar energy storage is one of the effective ways to solve energy shortage and environmental pollution. The heat storage characteristics of phase change materials in solar energy storage tanks directly affect the performance of the system and its future promotion and utilization. Based on the knowledge of heat transfer, fluid mechanics and engineering thermodynamics, this paper uses MATLAB software to compile the dynamic heat storage characteristics calculation program of phase change materials in energy storage tanks, and verify the results. This paper analyzes the phase change heat storage process with three PCM initial temperatures and three HTF speeds. The results show that when the initial temperature of the PCM changes from 185°C to 210°C, the latent heat storage heat increases by 21.8%, and the total heat storage decreases. Increasing the HTF speed from 1.8 m/s to 2.2 m/s, the melting time was reduced from 414 minutes to 390 minutes, and the total heat storage and sensible heat storage were also increased. The results also show that changing the initial temperature of the PCM and the flow rate of the HTF will change the thermal storage performance of the system. The research has certain reference significance for mastering the basic principle of high temperature solar thermal power generation system and promoting the application of the system.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Similar content being viewed by others

References

  1. Rajendran D.R., Sundaram E.G., Jawahar P., Experimental studies on the thermal performance of a parabolic dish solar receiver with the heat transfer fluids SiC plus water nano fluid and water. Journal of Thermal Science, 2017, 26(3): 263–272.

    Article  ADS  Google Scholar 

  2. Amina B., Miloud A., Samir L., Abdelylah B., Solano J.P., Heat transfer enhancement in a parabolic trough solar receiver using longitudinal fins and nanofluids. Journal of Thermal Science, 2016, 25(5): 410–417.

    Article  ADS  Google Scholar 

  3. Mao Q.J, Zhang L.Y, Wu H.J., Charge time of the storage material of the tank for a solar power plant. International Journal of Hydrogen Energy, 2016, 41(35): 154646–154650.

    Article  Google Scholar 

  4. Li G.Q, Zhang G., He W., Ji J., Lv S., Chen X., Chen H.B., Performance analysis on a solar concentrating thermoelectric generator using the micro-channel heat pipe array. Energy Conversion and Management, 2016, 112(15): 191–198.

    Article  Google Scholar 

  5. Lv S., He W., Hu D.Y., Zhu J., Li G.Q., Chen H.B., Liu M.H., Study on a high-performance solar thermoelectric system for combined heat and power. Energy Conversion and Management, 2017, 143(1): 459–469.

    Article  Google Scholar 

  6. Li Q., Bai F.W., Yang B., Wang Y., Xu L., Chang Z.S., Wang Z.F., Hefni B.E., Yang Z.Q., Kubo S., Kiriki H., Han M.X., Dynamic simulations of a honeycomb ceramic thermal energy storage in a solar thermal power plant using air as the heat transfer fluid. Applied Thermal Engineering, 2018, 129: 636–645.

    Article  Google Scholar 

  7. Wang F.Q., Cheng Z.M., Tan J.Y., Yuan Y., Yong S., Liu L.H., Progress in concentrated solar power technology with parabolic trough collector system: a comprehensive review. Renewable and Sustainable Energy Reviews, 2017, 79: 1314–1328.

    Article  Google Scholar 

  8. Wang F.Q., Lai Q.Z., Han H.Z., Tan J.Y., Parabolic trough receiver with corrugated tube for improving heat transfer and thermal deformation characteristics. Applied Energy, 2016, 164: 411–424.

    Article  Google Scholar 

  9. Yang J.L., Yang L.J., Xu C., Du X.Z., Experimental study on enhancement of thermal energy storage with phase change material. Applied Energy, 2016, 169(1): 164–176.

    Article  Google Scholar 

  10. Ma Z., Yang W.W., Yuan F., Jin B., He Y.L., Investigation on the thermal performance of a high-temperature latent heat storage system. Applied Thermal Engineering, 2017, 122(25): 579–592.

    Article  Google Scholar 

  11. Diao Y.H., Kang Y.M., Liang L., Zhao Y.H., Zhu T.T., Experimental investigation on the heat transfer performance of a latent thermal energy storage device based on flat miniature heat pipe arrays. Energy, 2017, 138(1): 929–934.

    Article  Google Scholar 

  12. Li M.J., Jin B., Ma Z., Yuan F., Experimental and numerical study on the performance of a new high temperature packed-bed thermal energy storage system with macro encapsulation of molten salt phase change material. Applied Energy, 2018, 221(1): 1–15.

    Article  Google Scholar 

  13. Tiari S., Mahdavi M., Qiu S.G., Experimental study of a latent heat thermal energy storage system assisted by a heat pipe network. Energy Conversion and Management, 2017, 153(1): 362–373.

    Article  Google Scholar 

  14. M. Abdulateef A., Mat S., Sopian K., Abdulateef J., A. Gitan A., Experimental and computational study of melting phase change material in a triplex tube heat exchanger with longitudinal/triangular fins. Solar Energy, 2017, 155: 142–153.

    Article  ADS  Google Scholar 

  15. Amagour M.E.H., Rachek A., Bennajah M., Touhami M.E., Experimental investigation and comparative performance analysis of a compact finned-tube heat exchanger uniformly filled with a phase change material for thermal energy storage. Energy Conversion and Management, 2018, 165(1): 137–151.

    Article  Google Scholar 

  16. Lu S.L., Zhang T.S., Chen Y.F., Study on the performance of heat storage and heat release of waterstorage tank with PCMs. Energy and Buildings, 2018, 150(1): 1770–1780.

    Article  Google Scholar 

  17. Bie Y., Li M., Malekian R., Chen F., Feng Z.K., Li Z.X., Effect of phase transition temperature and thermal conductivity on the performance of Latent Heat Storage System. Applied Thermal Engineering, 2018, 135(5): 218–227.

    Article  Google Scholar 

  18. Niyas H., Muthukumar P., A novel heat transfer enhancement technique for performance improvements in encapsulated latent heat storage system. Solar Energy, 2018, 164: 276–286.

    Article  ADS  Google Scholar 

  19. Riahi S., Y. Saman W., Bruno F., Belusko M., Tay N.H.S., Performance comparison of latent heat storage systems comprising plate fins with different shell and tube configurations. Applied Energy, 2018, 212(15): 1095–1106.

    Article  Google Scholar 

  20. Cheng X.W., Zhai X.Q., Thermal performance analysis and optimization of a cascaded packed bed cool thermal energy storage unit using multiple phase change materials. Applied Energy, 2018, 215(1): 566–576.

    Article  Google Scholar 

  21. Parsazadeh M., Duan X., Numerical study on the effects of fins and nanoparticles in a shell and tube phase change thermal energy storage unit. Applied Energy, 2018, 216(15): 142–156.

    Article  Google Scholar 

  22. Nithyanandam K., Barde A., Lakeh R.B., Wirz R.E., Charge and discharge behavior of elemental sulfur in isochoric high temperature thermal energy storage systems. Applied Energy, 2018, 214(15): 166–177.

    Article  Google Scholar 

  23. Mao Q.J., Chen H.Z., Zhao Y.Z., Wu H.J., A novel heat transfer model of a phase change material using in solar power plant. Applied Thermal Engineering, 2018, 129(25): 557–563.

    Article  Google Scholar 

  24. Mao Q.J., Recent developments in geometrical configurations of thermal energy storage for concentrating solar power plant. Renewable and Sustainable Energy Reviews, 2016, 59: 320–327.

    Article  Google Scholar 

  25. Kuravi S., Trahan J., Goswami D.Y., Muhammad M.R., Stefanakos E.K., Thermal energy storage technologies and systems for concentrating solar power plants. Progress in Energy and Combustion Science, 2013, 39(4): 285–319.

    Article  Google Scholar 

Download references

Acknowledgements

This work was supported by the National Natural Science Foundation of China (Grant Nos. 51876147 and 51406033).

Author information

Authors and Affiliations

  1. School of Urban Construction, Wuhan University of Science and Technology, Wuhan, 430065, China

    Qianjun Mao, Hongzhang Chen & Yizhi Yang

Authors
  1. Qianjun Mao
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Hongzhang Chen
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Yizhi Yang
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Qianjun Mao.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Mao, Q., Chen, H. & Yang, Y. Energy Storage Performance of a PCM in the Solar Storage Tank. J. Therm. Sci. 28, 195–203 (2019). https://doi.org/10.1007/s11630-019-1076-x

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11630-019-1076-x

Keywords

Search

Navigation