Abstract
This study compares the strength characteristics of rocks anchored by NPR bolts and ordinary bolts with varied preloads, based on the mechanical properties of NPR bolts (with a negative Poisson’s ratio). The results show that the uniaxial compressive stress-strain curve of ordinary anchored rocks exhibits noticeable abrupt changes. After reaching peak strength, the bolt breaks, whereas the stress-strain curve of NPR-anchored rocks is smoother. The NPR bolt enters the stage of continuous resistance after reaching maximal strength and does not break. As the preload increases, the strength of the anchored rock grows linearly. A calculation equation for the strength of the anchored rock is proposed based on the preload. The theoretical equation fits the test results well, and the fitted parameters show that NPR bolts can better increase the strength of the rock. The concept of dynamic toughness U C of anchored rock is proposed to reflect the comprehensive mechanical properties of anchored rock, including strength and plasticity. As the preload increases, the U C of ordinary anchored rock first decreases and then increases, while the U C of the NPR anchored rock does not change significantly with the preload when the strain is small, and the U C increases with the increase of the preload when the strain is large.
Similar content being viewed by others
References
Bobet A, Einstein HH (2011) Tunnel reinforcement with rockbolts. Tunn Undergr Space Technol 26(1): 100–123. https://doi.org/10.1016/j.tust.2010.06.006
He MC, Gong WL, Wang J, et al. (2014) Development of a novel energy-absorbing bolt with extraordinarily large elongation and constant resistance. Int J Rock Mech Min Sci 67: 29–42. https://doi.org/10.1016/j.ijrmms.2014.01.007
Li CC (2012) Performance of D-bolts under static loading. Rock Mech Rock Eng 45(2): 183–192. https://doi.org/10.1007/s00603-011-0198-6
Shreedharan S, Kulatilake PH (2016) Discontinuum-equivalent continuum analysis of the stability of tunnels in a deep coal mine using the distinct element method. Rock Mech Rock Eng 49(5): 1903–1922. https://doi.org/10.1007/s00603-015-0885-9
Qian Y, Wu JY, Jiang Z, et al. (2022) Investigating the effect of water quenching cycles on mechanical behaviors for granites after conventional triaxial compression. Geomech Geophys Geo-Energy Geo-Resour 8: 77. https://doi.org/10.1007/s40948-022-00388-0
Wang Y, Zhu C, He MC, et al. (2022) Macro-meso dynamic fracture behaviors of Xinjiang marble exposed to freeze thaw and frequent impact disturbance loads: a lab-scale testing. Geomech Geophys Geo-Energy Geo-Resour 8(5):154. https://doi.org/10.1007/s40948-022-00472-5
Boon CW, Houlsby GT, Utili S (2015) Designing tunnel support in jointed rock masses via the DEM. Rock Mech Rock Eng 48(2): 603–632. https://doi.org/10.1007/s00603-014-0579-8
He MC, Li C, Gong WL, et al. (2017) Dynamic tests for a Constant-Resistance-Large-Deformation bolt using a modified SHTB system. Tunn Undergr Space Technol 64: 103–116. https://doi.org/10.1016/j.tust.2016.12.007
Raju GD, Mitri H, Thibodeau D, et al. (2015) Numerical modelling and in situ monitoring of drift support performance with respect to mining sequence. Int J Min Reclam Environ 29(2): 83–95. https://doi.org/10.1080/17480930.2013.815400
Kurre R, Walton G (2020) A case study on the efficacy of different roof bolting schemes in Lhoist North America’s Crab Orchard Mine. Int J Min Sci Technol 30(1): 99–104. https://doi.org/10.1016/j.ijmst.2019.12.014
Sharifzadeh M, Lou J, Crompton B (2020) Dynamic performance of energy-absorbing rockbolts based on laboratory test results. Part I: Evolution, deformation mechanisms, dynamic performance and classification. Tunn Undergr Space Technol 105: 103510. https://doi.org/10.1016/j.tust.2020.103510
Ansell A (2005) Laboratory testing of a new type of energy absorbing rock bolt. Tunn Undergr Space Technol 20(4): 291–300. https://doi.org/10.1016/j.tust.2004.12.001
Li CC (2010) A new energy-absorbing bolt for rock support in high stress rock masses. Int J Rock Mech Min Sci 47(3): 396–404. https://doi.org/10.1016/j.ijrmms.2010.01.005
Yokota Y, Zhao Z, Nie W, et al. (2020) Development of a new deformation-controlled rock bolt: Numerical modelling and laboratory verification. Tunn Undergr Space Technol 98: 103305. https://doi.org/10.1016/j.tust.2020.103305
Feser T, Hassan J, Waimer M, et al. (2020) Effects of transient dynamic loading on the energy absorption capability of composite bolted joints undergoing extended bearing failure. Compos Struct 247: 112476.https://doi.org/10.1016/j.compstruct.2020.112476
Ghorbani M, Shahriar K, Sharifzadeh M, et al. (2020) A critical review on the developments of rock support systems in high stress ground conditions. Int J Min Sci Technol 30(5): 555–572. https://doi.org/10.1016/j.ijmst.2020.06.002
Skrzypkowski K (2021) An experimental investigation into the stress-strain characteristic under static and quasi-static loading for partially embedded rock bolts. Energies 14(5): 1483. https://doi.org/10.3390/en14051483
Skrzypkowski K, Korzeniowski W, Zagórski K, et al. (2020) Adjustment of the yielding system of mechanical rock bolts for room and pillar mining method in stratified rock mass. Energies 13(8): 2082. https://doi.org/10.3390/en13082082
Tang SB, Li JM, Ding S, et al. (2022) The influence of water-stress loading sequences on the creep behavior of granite. Bull Eng Geol Environ 81:482. https://doi.org/10.1007/s10064-022-02987-3
Wang H, Li H, Tang L, et al. (2022) Fracture of two three-dimensional parallel internal cracks in brittle solid under ultrasonic fracturing. J Rock Mech Geotech Eng 14(3): 757–769. https://doi.org/10.1016/j.jrmge.2021.11.002
Liang X, Tang SB, Tang CA, et al. (2022) Influence of water on the mechanical properties and failure behaviors of sandstone under triaxial compression. Rock Mech Rock Eng https://doi.org/10.1007/s00603-022-03121-1
Ren DZ, Wang XZ, Kou ZH, et al. (2023) Feasibility evaluation of CO2 EOR and storage in tight oil reservoirs: A demonstration project in the Ordos Basin. Fuel 331: 125652. https://doi.org/10.1016/j.fuel.2022.125652
Zheng L, Wang L, Zhu L (2021) Analytical model of shear mechanical behaviour of bolted rock joints considering influence of normal stress on bolt guide rail effect. J Cent South Univ Technol 28(5): 1505–1518. https://doi.org/10.1007/s11771-021-4700-3
Li X, Aziz N, Mirzaghorbanali A, et al. (2016) Behavior of fiber glass bolts, rock bolts and cable bolts in shear. Rock Mech Rock Eng 49(7): 2723–2735. https://doi.org/10.1007/s00603-015-0907-7
He MC, Ren SL, Xu HT, et al. (2022) Experimental study on the shear performance of quasi-NPR steel bolted rock joints. J Rock Mech Geotech Eng. https://doi.org/10.1016/j.jrmge.2022.03.011
Zhang Z, Liu Y, Teng J, et al. (2020) An investigation into bolt anchoring performance during tunnel construction in bedded rock mass. Appl Sci-Basel 10(7): 23–29. https://doi.org/10.3390/app10072329
Chen Y, Teng J, Sadiq R, et al. (2020) Experimental study of bolt-anchoring mechanism for bedded rock mass. Int J Geomech 20(4): 04020019. https://doi.org/10.1061/(ASCE)GM.1943-5622.0001561
Li Y, Zhou H, Zhang L, et al. (2016) Experimental and numerical investigations on mechanical property and reinforcement effect of bolted jointed rock mass. Constr Build Mater 126: 843–856. https://doi.org/10.1016/j.conbuildmat.2016.09.100
Kılıç A, Yasar E, Celik AG (2020) Effect of grout properties on the pull-out load capacity of fully grouted rock bolt. Tunn Undergr Space Technol 17(4): 355–362. https://doi.org/10.1016/S0886-7798(02)00038-X
Ivanović A, Neilson RD (2013) Non-destructive testing of rock bolts for estimating total bolt length. International Int J Rock Mech Min Sci 64: 36–43. https://doi.org/10.1016/j.ijrmms.2013.08.017
Zhang JP, Liu LM, Liu CX, et al. (2022) Mechanism and application of new prestressed yield bolt for controlling deep high-stress rock mass. Tunn Undergr Space Technol 119: 104254. https://doi.org/10.1016/j.tust.2021.104254
Song Y, Li Y (2021) Study on the constitutive model of the whole process of macroscale and mesoscale shear damage of prestressed anchored jointed rock. Bull Eng Geol Environ 80(8): 6093–6106. https://doi.org/10.1007/s10064-021-02332-0
Wang B, Yu W, Chen Z (2022) Effect of anchor plate on the mechanical behavior of prestressed rock bolt used in squeezing large deformation tunnel. Acta Geotech 1–21. https://doi.org/10.1007/s11440-022-01460-5
Jiang SH, Li DQ, Zhang LM, et al. (2014) Time-dependent system reliability of anchored rock slopes considering rock bolt corrosion effect. Eng Geol 175: 1–8. https://doi.org/10.1016/j.enggeo.2014.03.011
He MC, Sui QR, Li MN, et al. (2022) Compensation Excavation Method Control for Large Deformation Disaster of Mountain Soft Rock Tunnel. Int J Min Sci Technol 5: 951–963. https://doi.org/10.1016/j.ijmst.2022.08.004
Nie W, Wang WQ, Tao ZG, et al. (2022) Numerical modeling of the NPR-cable and its applications for analysis of a slide-toe-toppling failure. Comput Geotech 149: 104852. https://doi.org/10.1016/j.compgeo.2022.104852
Tao ZG, Zhang HJ, Chen YF, et al. (2016) Support principles of NPR bolt/cable and control techniques of large-deformation disasters. Int J Min Sci Technol 26(6): 967–973. https://doi.org/10.1016/j.ijmst.2016.09.002
Tao ZG, Luo SL, Qiao YF, et al. (2021) Key factors analysis and constitutive equation modification of a macro-NPR bolt for achieving high constant resistance and large deformation characteristics. Int J Rock Mech Min Sci 147: 104911. https://doi.org/10.1016/j.ijrmms.2021.104911
Yang J, Zhao RD, Bian WH, et al. (2022) Application and research of NPR bolt for shallow-buried large-span metro tunnel. Arab J Geosci 15(9): 1–19. https://doi.org/10.1007/s12517-022-10013-9
Hao Y, Wu Y, Ranjith PG, et al. (2020) A novel energy-absorbing rock bolt with high constant working resistance and long elongation: principle and static pull-out test. Constr Build Mater 243: 118231. https://doi.org/10.1016/j.conbuildmat.2020.118231
Wang FN, Guo ZB, Qiao XB, et al. (2021) Large deformation mechanism of thin-layered carbonaceous slate and energy coupling support technology of NPR anchor cable in Minxian Tunnel: A case study. Tunn Undergr Space Technol 117: 104151. https://doi.org/10.1016/j.tust.2021.104151
Xia FL, Zhu SP, Liao D, et al. (2020) Isodamage curve-based fatigue damage accumulation model considering the exhaustion of static toughness. Eng Fail Anal 115: 104575. https://doi.org/10.1016/j.engfailanal.2020.104575
Zhang Z, Zhang X, Wang Q, et al. (2021) Research on lightweight design of heavy vehicle transmission and action components. Chin J Mech Eng 48(18): 67–71. (In Chinese) https://doi.org/10.3901/JME.2012.18.067
Ye DY, Wang ZL (2021) A new approach to low-cycle fatigue damage based on exhaustion of static toughness and dissipation of cyclic plastic strain energy during fatigue. Int J Fatigue 23(8): 679–687. https://doi.org/10.1016/S0142-1123(01)00027-5
Acknowledgements
The research presented in this paper was supported by the National Natural Science Foundation of China (Grant Nos. 52174096 and 51874311).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sun, Xm., Cui, L., Zhang, Y. et al. Strength characteristics of rock anchored by NPR bolt with different preloads. J. Mt. Sci. 20, 834–844 (2023). https://doi.org/10.1007/s11629-022-7798-3
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11629-022-7798-3