Skip to main content
Log in

Effects of calcination temperature of boron-containing magnesium oxide raw materials on properties of magnesium phosphate cement as a biomaterial

  • Biomaterials
  • Published:
Journal of Wuhan University of Technology-Mater. Sci. Ed. Aims and scope Submit manuscript

Abstract

A new magnesium phosphate bone cement (MPBC) was prepared as a byproduct of boroncontaining magnesium oxide (B-MgO) after extracting Li2CO3 from salt lakes. We analyzed the elementary composition of the B-MgO raw materials and the effects of calcination temperature on the performance of MPBC. The phase composition and microstructure of the B-MgO raw materials and the hydration products (KMgPO4·6H2O) of MPBC were analyzed by X-ray diffraction and scanning electron microscopy. The results showed that ionic impurities and the levels of toxic elements were sufficiently low in B-MgO raw materials to meet the medical requirements for MgO (Chinese Pharmacopeia, 2010 Edition) and for hydroxyapatite surgical implants (GB23101.1-2008). The temperature of B-MgO calcination had a marked influence on the hydration and hardening of MPBC pastes. Increasing calcination temperature prolonged the time required for the MPBC slurry to set, significantly decreased the hydration temperature, and prolonged the time required to reach the highest hydration temperature. However, the compressive strength of hardened MPBC did not increase with higher calcination temperatures. In the 900-1 000 °C temperature range, the hardened MPBC had a higher compressive strength. Imaging analysis suggested that the setting time and the highest hydration temperature of MPBC pastes were dependent on the size and crystal morphology of the B-MgO materials. The production and microstructure compactness of KMgPO4·6H2O, the main hydration product, determined the compressive strength.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. Yang Q B, Wu X. Factors Influencing Properties of Phosphate Cement-Based Binder for Rapid Repair of Concrete[J]. Cement and Concrete Research, 1999,29 (3): 389–396

    Article  Google Scholar 

  2. Yang Q B, Zhu B, Wu X. Characteristics and Durability Test of Magnesium Phosphate Cement-Based Material for Rapid Repair of Concrete[J]. Materials and Structures, 2000, 33(4): 229–234

    Article  Google Scholar 

  3. Yang Q B, Zhang S, Wu X. Deicer-Scaling Resistance of Phosphate Cement-Based Binder for Rapid Repair of Concrete[J]. Cement and Concrete Research, 2002,32(1):165–168

    Article  Google Scholar 

  4. Arun S Wagh, Seung Y Jeong. Chemically Bonded Phosphate Ceramics: I, A Dissolution Modle of Formation[J]. J. Am. Ceram. Soc., 2003, 86 (11): 1838–1844

    Article  Google Scholar 

  5. Jiang Q Y, Zhang L M. Research of Magnesium Phosphate Cement[J]. Journal of Wuhan University of Technology -Materials Science Edition, 2011, 23 (1):32–34

    Google Scholar 

  6. Moseke C, Saratsis V, Gbureck U. Injectability and Mechanical Properties of Magnesium Phosphate Cements[J]. J. Mater. Sci. Mater. Med., 2011, 22: 2591–2598

    Article  Google Scholar 

  7. Wang A, Yuan Z, Zhang J, et al. Effect of Raw Material Ratios on the Compressive Strength of Magnesium Potassium Phosphate Chemically Bonded Ceramics[J]. Mater. Sci. Eng. C, 2013, 33:5058–5063

    Article  Google Scholar 

  8. Mestres G, Ginebra MP. Novel Magnesium Phosphate Cements with High Early Strength and Antibacterial Properties[J]. Acta Biomater., 2011, 7:1853–1861

    Article  Google Scholar 

  9. Gulotta LV, Kovacevic D, Ying L, et al. Augmentation of Tendon-to-Bone Healing with a Magnesium-Based Bone Adhesive[J]. Am. J. Sports Med. 2008, 36: 1290–1297

    Article  Google Scholar 

  10. Waselau M, Samii VE, Weisbrode SE, et al. Effects of a Magnesium Adhesive Cement on Bone Stability and Healing Following a Metatarsal Osteotomy in Horses[J]. Am. J. Vet. Res., 2007, 68: 370–378

    Article  Google Scholar 

  11. Wu F, Wei J, Guo H, et al. Self-Setting Bioactive Calcium-Magnesium Phosphate Cement with High Strength and Degradability for Bone Regeneration[J]. Acta Biomater., 2008, 4: 1873–1884

    Article  Google Scholar 

  12. Eubank WR. Calcination Studies of Magnesium Oxides[J]. J. Am. Ceram. Soc., 1951, 34: 225–229

    Article  Google Scholar 

  13. Soudée E, Péra J. Influence of Magnesia Surface on the Setting Time of Magnesia-Phosphate Cement[J]. Cement Concrete Res., 2002, 32: 153–157

    Article  Google Scholar 

  14. Fang H S, Zhao H C, Zhang X D. Implants for Surgery-Hydroxyapatite-Part 1: Ceramic Hydroxyapatite[S]. GB23101.1-2008/ISO, 13779-1:2000, 2009 (in Chinese)

    Google Scholar 

  15. Bruker. Bruker AXS (2006)[M]. Karlsruhe: TOPAS Bruker AXS Inc, 2006

    Google Scholar 

  16. State Pharmacopoeia Commission. Pharmacopoeia of the People’s Republic of China-Part 2: Magnesium Oxide[M]. Beijing: Chinese Medical Science and Technology Press, 2010 (in Chinese)

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Hongfa Yu  (余红发).

Additional information

Funded by the National Natural Science Foundation of China (No.21276264) and the Qinghai Province Science and Technology Department(No.2013-G-208)

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Dong, J., Yu, H., Xiao, X. et al. Effects of calcination temperature of boron-containing magnesium oxide raw materials on properties of magnesium phosphate cement as a biomaterial. J. Wuhan Univ. Technol.-Mat. Sci. Edit. 31, 671–676 (2016). https://doi.org/10.1007/s11595-016-1427-3

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11595-016-1427-3

Key words

Navigation