Abstract
The morphology and the formation of Y2BaCuO5 phase in powder melting processed YBa2Cu3O7−x superconductors were investigated. The experimental results show the heat treatment can not change the shape of Y2BaCuO5 particles in powder melting processed samples. The formation of round Y2BaCuO5 phase is due to relative content of each constitution of precursor powders in powder melting process. For powder melting process, the excessive liquid phase is eliminated, which restrains the preferred growth of Y2BaCuO5 particles.
Similar content being viewed by others
References
Oka T. Processing and Applications of Bulk HTSC[J]. Physica C, 2007, 463–465: 7–13
Floegel-Delor U, Rothfeld R, Wippich D, Werfel F N. Fabrication of HTS Bearings with Ton Load Performance[J]. IEEE Trans. Appl. Supercond., 2007, 17: 2 142–2 145
Oka T, Kanayama H, Fukui S, et al. Application of HTS Bulk Magnet System to the Magnetic Separation Techniques for Water Purification[J]. Physica C, 2008, 468: 2 128–2 132
Nagashima K, Seino H, Sakai N, et al. Superconducting Magnetic Bearing for a Flywheel Energy Storage System Using Superconducting Coils and Bulk Superconductors[J]. Physica C, 2009, 469: 1 244–1 249
Jin S, Tiefel T, Sherwood R, et al. Melt-textured Growth of Polycrystalline YBa2Cu3O7−δ with High Transport Jc at 77 K[J]. Phys. Rev. B, 1988, 37: 7 850–7 853
Murakami M, Morita M, Doi K, et al. A New Process with the Promise of High Jc in Oxide Superconductors[J]. Jpn. J. Appl. Phys., 1989, 28: 1 189–1 194
Lian Z, Xiang Z Ping, Ping J, et al. The properties of YBCO Superconductors Prepared by a New Approach: the ‘Powder Melting Process’[J]. Supercond. Sci. Technol., 1990, 3: 490–492
Chan-Joong Kim, Ki-Baik Kim, Young A Jee, et al. Effects of the Heating Rate on Conversion of the Precursor Powders Used for Melt Processes Into YBa2Cu3O7−y[J]. J. Mater. Res., 1999, 14:1 212–1 220
Mathieu J P, Cano I G, Koutzarova T, et al. The Contribution of 211 Particles to the Mechanical Reinforcement Mechanism of 123 Superconducting Single Domains[J]. Supercond. Sci. Technol., 2004, 17: 169–174
Griffith M L, Huffman R T, Halloran J W. Formation and Coarsening Behavior of Y2BaCuO5 from Peritectic Decomposition of YBa2Cu3O7−x [J]. J. Mater. Res., 1994, 9: 1 633–1 643
Sakai N, Yoo S I, Murakami M. Control of Y2BaCuO5 Size and Morphology in Melt-processed YBa2Cu3O7−d Superconductor[J]. J. Mater. Res., 1995, 10: 1 611–1 621
Mele P, Ubaldini A, Carnasciali M M, et al. Growth and Structural Characterization of Needlelike Crystals in the Y-Ba-Cu-O System[J]. Crystal Growth & Design, 2006, 6: 1 761–1 765
Langhorn J, McGinn P J. Improved Microstructural Characteristics in YBa2Cu3O7−x Thick Films Prepared by a Modified Powder Melt Process Route[J]. Physica C, 1999, 312: 169–178
Author information
Authors and Affiliations
Corresponding author
Additional information
Funded by the National Natural Science Foundation of China (50432050) and the National High Technology Research and Development Program of China (2007AA03Z241)
Rights and permissions
About this article
Cite this article
Feng, J., Lu, Y., Xu, X. et al. Transition of Y2BaCuO5 phase in powder melting processed YBa2Cu3O7−x superconductors. J. Wuhan Univ. Technol.-Mat. Sci. Edit. 26, 620–623 (2011). https://doi.org/10.1007/s11595-011-0279-0
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11595-011-0279-0