Abstract
In order to overcome the limitation of hydro-rim deep drawing, a new process of hydrodynamic deep drawing (HDD) with independent radial hydraulic pressure was proposed. By employing the dynamic explicit analytical software ETA/Dynaform5.5 which is based on LS-DYNA3D, the effects of independent radial hydraulic pressure on the stress, strain and the sheet-thickness of aluminum-magnesium cylindrical cup with a hemispherical bottom were analyzed by numerical simulation. The feature of stress distribution is that there exists a stress-dividing circle in the flange, and the radius of dividing circle was determined by theoretical analysis and stimulation. The experimental results indicate that the reasonable match of independent radial hydraulic pressure and liquid chamber pressure can effectively reduce the thinning at the bottom of hemisphere, decrease the radial stress-strain, and improve the drawing limit of aluminum-magnesium alloy cylindrical cup.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Zhang S H, Wang Z R, Xu Y. Recent Developments in Sheet Hydroforming Technology [J]. Journal of Materials Processing Technology, 2004, 151: 237–2414
Dipl.-ing, Rosen H, Schwarz S, Schneider S. Hydroforming for the Automobile Industry [C]. In: International Conference on Hydroforming, 2001, 2: 135–158
XU Y C, KANG D C. Hydromechanical Deep Drawing of Alumite LF6[J]. The Chinese Journal of Nonferrous Metals, 2003, 13(1): 60–64 (in Chinese)
Nakamura K. Sheet Metal Forming with Hydraulic Counter Pressure in Japan[C]. In: Annuals of the CIRP, 1987, 36(1):191–194
Amino H, Nakamura K, Nakagawa T. Counter Pressure Deep Drawing and its Application in the Forming of Automobile Parts[J]. Journal of Materials Processing Technology, 1990, 23: 243–265
Nakamura K, Nakagawa T, Amino H. Various Application of Hydraulic Counter Pressure Deep Drawing[J]. Journal of Materials Processing Technology, 1997, 71: 160–167
ZHANG S H, Danckert J. Development of Hydromechanical Deep Drawing[J]. Journal of Materials Processing Technology, 1998, 83: 14–25
KANG D C, LANG L H, MENG X F, et al. A Study on Hydrodynamic Deep Drawing Equipment[J]. Journal of Materials Processing Technology, 2000, 101: 21–24
Yossif S, Tirosh J. The Maximum Drawing Ratio in Hydroforming Process[J]. Journal of Engineering for Industr, Transaction of the ASME, 190, 112: 47–62
WANG Z R, YUAN S J, HU L X. Mechanical Base of Elastane and Plasticity[M]. Harbin: Harbin Institute and Technology Press, 1997: 112–113 (in Chinese)
Author information
Authors and Affiliations
Corresponding author
Additional information
Funded by the National Natural Science Foundation of China (Nos.50525516, 50875062)
Rights and permissions
About this article
Cite this article
Liu, X., Xu, Y. & Yuan, S. Formation of aluminum-magnesium alloy cup by hydrodynamic deep drawing with twin-loading paths. J. Wuhan Univ. Technol.-Mat. Sci. Edit. 24, 193–197 (2009). https://doi.org/10.1007/s11595-009-2193-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11595-009-2193-2