Abstract
Time-resolved FTIR, WAXD/SAXS and DSC have been used to investigate the structural variation of non-isothermally crystallized poly(trimethylene terephthalate) (PTT) during the heating process. The three-phase model: the lamellar phase, the mobile amorphous phase (MAP) and the rigid amorphous phase (RAP) between lamellae is suggested to describe the structure of melt-crystallized PTT. According to FTIR results, the conformation of RAP in the constrained state is different from that of MAP. The increased content of amorphous phase in the temperature range from 120 to 192°C is ascribed to the relaxation of RAP, rather than the melting of defective crystals. When the PTT is heated to a temperature above 192°C, the recrystallization/crystal perfection of original defective lamellae occurs without a pre-melting process, which leads to an increase in lamellar thickness and probably connects two adjacent lamellar stacks. This is responsible for an increase in crystallinity as well as a higher major melting temperature.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Jakeways R, Ward I M, Wilding M A, et al. Crystal deformation in aromatic polyesters. J Polym Sci Polym Phys, 1975, 13: 799–813
Ward I M, Wilding M A, Brody H. The mechanical properties and structure of poly(m-methylene terephthalate) fibers. J Polym Sci Polym Phys, 1976, 14: 263–274
Wu G, Li H W, Wu Y Q, et al. Structure and property studies of poly(trimethylene terephthalate) high-speed melt spun fibers. Polymer, 2002, 43: 4915–4922
Desborough I J, Hall I H, Neisser J Z. The structure of poly(trimethylene terephthalate). Polymer, 1979, 20: 545–552
Poulin-Dandurand S, Pérez S, Revol J F, et al. The crystal structure of poly(trimethylene terephthalate) by X-ray and electron diffraction. Polymer, 1979, 20: 419–426
Chung W T, Yeh W J, Hong P D. Melting behavior of poly(trimethylene terephthalate). J Appl Polym Sci, 2002, 83: 2426–2433
Wu P L, Woo E M. Correlation between melting behavior and ringed spherulites in poly(trimethylene terephthalate). J Polym Sci Polym Phys, 2003, 41: 80–93
Srimoaon P, Dangseeyun N, Supaphol P. Multiple melting behavior in isothermally crystallized poly(trimethylene terephthalate). Eur Polym J, 2004, 40: 599–608
Zeng W, Li H H, Liu T X, et al. A study on the double melting behavior of poly(trimethylene terephthalate). Chin Sci Bull, 2008, 53: 2145–2155
Pyda M, Boller A, Grebowicz J, et al. Heat capacity of poly(trimethylene terephthalate). J Polym Sci Polym Phys, 1998, 36: 2499–2511
Song M. Rigid amorphous phase and low temperature melting endotherm of poly(ethylene terephthalate) studied by modulated differential scanning calorimetry. J Appl Polym Sci, 2001, 81: 2779–2785
Alvarez C, Šics I, Nogales A, et al. Structure-dynamics relationship in crystallizing poly(ethylene terephthalate) as revealed by time-resolved X-ray and dielectric methods. Polymer, 2004, 45: 3953–3959
Di Lorenzo M L, Righetti M C, Cocca M, et al. Coupling between crystal melting and rigid amorphous fraction mobilization in poly (ethylene terephthalate). Macromolecules, 2010, 43: 7689–7694
Righetti M C, Di Lorenzo M L, Tombari E, et al. The low-temperature endotherm in poly(ethylene terephthalate): Partial melting and rigid amorphous fraction mobilization. J Phys Chem B, 2008, 112: 4233–4241
Chen H P, Cebe P. Vitrification and devitrification of rigid amorphous fraction of PET during quasi-isothermal cooling and heating. Macromolecules, 2008, 42: 288–292
Cheng S Z D, Pan R, Wunderlich B. Thermal analysis of poly(butylene terephthalate) for heat capacity, rigid-amorphous content, and transition behavior. Die Makromolekulare Chemie, 1988, 189: 2443–2458
Righetti M C, Di Lorenzo M L. Melting process of poly(butylene terephthalate) analyzed by temperature-modulated differential scanning calorimetry. J Polym Sci Polym Phys, 2004, 42: 2191–2201
Righetti M C, Di Lorenzo M L, Angiuli M, et al. Structural reorganization in poly(butylene terephthalate) during fusion. Macromolecules, 2004, 37: 9027–9033
Pyda M, Nowak-Pyda E, Mays J, et al. Heat capacity of poly(butylene terephthalate). J Polym Sci Polym Phys, 2004, 42: 4401–4411
Hong P D, Chuang W T, Yeh W J, et al. Effect of rigid amorphous phase on glass transition behavior of poly(trimethylene terephthalate). Polymer, 2002, 43: 6879–6886
Shafee E E. Effect of aging on the mechanical properties of cold-crystallized poly(trimethylene terephthalate). Polymer, 2003, 44: 3727–3732
Kalakkunnath S, Kalika D S. Dynamic mechanical and dielectric relaxation characteristics of poly(trimethylene terephthalate). Polymer, 2006, 47: 7085–7094
Sanz A, Nogales A, Ezquerra T A, et al. Cold crystallization of poly(trimethylene terephthalate) as revealed by simultaneous WAXS, SAXS, and dielectric spectroscopy. Macromolecules, 2009, 43: 671–679
Ma Q, Georgiev G, Cebe P. Constraints in semicrystalline polymers: Using quasi-isothermal analysis to investigate the mechanisms of formation and loss of the rigid amorphous fraction. Polymer, 2011, 52: 4562–4570
Zhang J M, Duan Y X, Sato H, et al. Crystal modifications and thermal behavior of poly(l-lactic acid) revealed by Infrared spectroscopy. Macromolecules, 2005, 38: 8012–8021
Hu Y, Zhang J M, Sato H, et al. Multiple melting behavior of poly(3-hydroxybutyrate-co-3-hydroxyhexanoate) investigated by differential scanning calorimetry and infrared spectroscopy. Polymer, 2007, 48: 4777–4785
Duan Y X, Zhang J M, Shen D Y, et al. In situ FTIR studies on the cold-crystallization process and multiple melting behavior of isotactic polystyrene. Macromolecules, 2003, 36: 4874–4879
Yu L L, Gao B, Chen Z, et al. In situ FTIR investigation on phase transformations in BN nanoparticles. Chin Sci Bull, 2005, 50: 2827–2831
Ward I M, Wilding M A. Infra-red and Raman spectra of poly(m-methylene terephthalate) polymers. Polymer, 1977, 18: 327–335
Bulkin B J, Lewin M, Kim J. Crystallization kinetics of poly(propylene terephthalate) studied by rapid-scanning Raman spectroscopy and FT-IR spectroscopy. Macromolecules, 1987, 20: 830–835
Kim K J, Bae J H, Kim Y H. Infrared spectroscopic analysis of poly(trimethylene terephthalate). Polymer, 2001, 42: 1023–1033
Schmidtke J, Strobl G, Thurn-Albrecht T. A four-state scheme for treating polymer crystallization and melting suggested by calorimetric and small angle X-ray scattering experiments on syndiotactic olypropylene. Macromolecules, 1997, 30: 5804–5821
Hsiao B, Wang Z G, Yeh F, et al. Time-resolved X-ray studies of structure development in poly(butylene terephthalate) during isothermal crystallization. Polymer, 1999, 40: 3515–3523
Iijima M, Strobl G. Isothermal crystallization and melting of isotactic polypropylene analyzed by time- and temperature-dependent small-angle X-ray scattering experiments. Macromolecules, 2000, 33: 5204–5214
Sato H, Nakamura M, Padermshoke A, et al. Thermal behavior and molecular interaction of poly(3-hydroxybutyrate-co-3-hydroxyhexanoate) studied by wide-angle X-ray diffraction. Macromolecules, 2004, 37: 3763–3769
Zhang J M, Tashiro K, Tsuji H, et al. Disorder-to-order phase transition and multiple melting behavior of poly(l-lactide) investigated by simultaneous measurements of WAXD and DSC. Macromolecules, 2008, 41: 1352–1357
Fai Lau S, Suzuki H, Wunderlich B. The thermodynamic properties of polytetrafluoroethylene. J Polym Sci Polym Phys, 1984, 22: 379–405
Author information
Authors and Affiliations
Corresponding author
Additional information
This article is published with open access at Springerlink.com
Rights and permissions
This article is published under an open access license. Please check the 'Copyright Information' section either on this page or in the PDF for details of this license and what re-use is permitted. If your intended use exceeds what is permitted by the license or if you are unable to locate the licence and re-use information, please contact the Rights and Permissions team.
About this article
Cite this article
Chen, Z., Yan, S. Structural variation of melt-crystallized PTT during the heating process revealed by FTIR and SAXS. Chin. Sci. Bull. 58, 328–335 (2013). https://doi.org/10.1007/s11434-012-5589-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11434-012-5589-x