Abstract
Numerical simulations of granular flows in rotating drums operated at medium to high rates (Fr=0.1–0.2) have been carried out by using a Molecular Dynamics (MD) algorithm that incorporates inelastic particle interactions, sliding friction and rolling friction. The results indicate that the behavior of granular flow in rotating drums can be classified into two distinct zones: a shear active layer at the bed surface and a quasi-static plug flow region adjacent to the wall. The residence time of a tracer particle in the active layer is approximately a third or a half of that in the plug flow region. The thickness of the active layer at mid-chord is about 0.57–0.61 times that of the plug flow region. It is found that all cases simulated in this work are in the rolling-cascading intermediate regime instead of the pure rolling regime. The simulated tangential velocity at the mid-chord is also compared with experimental results reported in the literature and good agreement has been obtained. Based on the MD simulations and experimental results, a continuum approach has also been developed. It is shown that the behavior of granular solids in the plug flow region experiences plastic deformation along the radial direction from the wall with the velocity profiles well described by an exponential function, whereas the active layer velocity follows a simple expression for the Couette shear flow. Discussion has also been made on the granular temperature and concentration profiles.
This is a preview of subscription content, access via your institution.
References
Jaeger H M, Nagel S R, Behringer R P. Physics of the granular state. Science, 1992, 255: 1523–1531
Duran J, Reisinger A, Sands, et al. An Introduction to the Physics of Granular Materials. New York: Springer-Verlag, 2000
Hostler S R. Wave propagation in granular materials. Dissertation for the Doctoral Degree. California Institute of Technology at Blvd Pasadena, 2005, 1–15
Zhou Y C, Xu B H, Yu A B. Numerical investigation of the angle of repose of monosized spheres. Phys Rev E, 2001, 64: 021301
Johnson P C, Nott P, Jackson R. Frictional-collisional equations of motion for particulate flows and their application to chutes. J Fluid Mech, 1990, 210: 501–535
Hunt M L, Weathers R C, Lee A T, et al. Effects of horizontal vibration on hopper flows of granular materials. Phys Fluids, 1999, 11: 68–75
Li S Q, Yan J H, Li R D, et al. Axial transport and residence time of MSW in rotary kilns: Part I. Experimental. Powder Tech, 2002, 126: 217–227
Metcalfe G, Shinbrot T, McCarthy J J, et al. Avalanche mixing of granular solids. Nature, 1995, 374: 39–41
Shinbrot T, Alexander A, Muzzio F J. Spontaneous chaotic granular mixing. Nature, 1997, 397: 675–678
Rapaport D C. The Art of Molecular Dynamics Simulation. 2nd ed. London: Cambridge University Press, 2004
Ge W, Ma J S, Zhang J Y, et al. Particle methods for multiscale simulation of complex flows. Chin Sci Bull, 2005, 50: 1057–1069
Dury C M, Ristow G H. Competition of mixing and segregation in rotating cylinders. Phys Fluids, 1999, 11: 1387–1394
Dziugys A, Peters B. An approach to simulate the motion of spherical and non-spherical fuel particles in combustion chambers. Granular Matter, 2001, 3: 231–265
Brilliantov N V, Pöeschel T. Rolling friction of a viscous on a hard plane. Europhys Lett, 1998, 42: 511–516
Goldenberg C, Goldhirsch I. Friction enhances elasticity in granular solids. Nature, 2005, 435: 188–191
Weber M W. Simulation of cohesive particle flows in granular and gas-solid system. Dissertation for the Doctoral Degree. University of Colorado at Boulder, 2004, 73–108
Stevens A B, Hrenya C M. Comparison of soft-sphere models to measurements of collision properties during normal impacts. Powder Tech, 2005, 154: 99–109
Parker D J, Dijkstra A E, Martin T W, et al. Positro emission particle tracking studies of spherical particle motion in rotating drums. Chem Eng Sci, 1997, 52: 2011–2022
Ding Y L, Seville J P K, Forster R, et al. Solid motion in rolling mode rotating drums operated at low to medium rotational speeds. Chem Eng Sci, 2001, 56: 1769–1780
Xu B H, Yu A B. Numerical simulation of gas-solid flow in a fluidized bed by combining discrete particle method with computational fluid dynamics. Chem Eng Sci, 1997, 52: 2785–2809
Khakhar D V, McCarthy J J, Shinbrot T, et al. Transverse flow and mixing of granular materials in a rotating cylinder. Phys Fluids, 1997, 9: 31–43
Boateng A A. Boundary layer modeling of granular flow in the transverse plane of a partially filled rotating cylinder. Int J Multiph Flow, 1998, 24: 499–521
Mellmann J. The transverse motion of solids in rotating cylinders — forms of motion and transition behavior. Powder Tech, 2001, 118: 251–270
Orpe A, Kharkar D V. Scaling relations for granular flow in quasi-two-dimensional rotating cylinders. Phys Rev E, 2001, 64, 031302
Yang R Y, Zou R P, Yu A B. Microdynamics analysis of particle flow in a horizontal rotating drum. Powder Tech, 2003, 130: 138–146
Maneval J E, Hill K M, Smith B E, et al. Effects of end wall friction in rotating cylinder granular flow experiments. Granul Matt, 2005, 7: 199–202
Wightman C, Moakher M, Muzzio F J, et al. Simulation of flow and mixing of particles in a rotating and rocking cylinder. AIChE, 1998, 44: 1266–1276
Author information
Authors and Affiliations
Corresponding author
Additional information
Supported by the National Natural Science Foundation of China (Grant No. 50306012) and National Key Fundamental Research Project (Grant No.2002CB211600)
About this article
Cite this article
Li, S., Yao, Q., Chen, B. et al. Molecular dynamics simulation and continuum modelling of granular surface flow in rotating drums. CHINESE SCI BULL 52, 692–700 (2007). https://doi.org/10.1007/s11434-007-0069-4
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/s11434-007-0069-4