Skip to main content
Log in

Phase reaction of Au/Sn solder bonding for GaN-based vertical structure light emitting diodes

  • Published:
Science China Technological Sciences Aims and scope Submit manuscript

Abstract

Au/Sn solder bonding on Si substrates was used to fabricate the GaN-based vertical structure light emitting diodes (VSLEDs). The phase reaction of Au/Sn solder under different bonding conditions was investigated by the measurement of electron back scattering diffraction (EBSD), and the characteristics of VSLED were analyzed by scanning acoustic microscope (SAM), Raman scattering, current-voltage (I-V) and light output-current (L-I) curves. After the bonding process, horizontal stripes of Au/Sn phase (δ phase) and Au5Sn phase (ζ phase) were redirected to vertical stripes, and δ phase tended to move to the solder joint. Sn interstitial diffusion led to the distribution of δ phase and voids in Au/Sn solder, which could be seen in SAM and SEM images. Vertical distribution of the δ phase and ζ phase with proper voids in the Au/Sn bonding layer showed the best bonding quality. Good bonding quality led to little shift of the E2-high mode of Raman spectra peak in GaN after laser lift off (LLO). It also caused more light extraction and forward bias reduction to 2.9 V at 20 mA.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. Fu T, Gao Y, Sharma R, et al. Increase in the extraction efficiency of GaN-based light-emitting diodes via surface roughening. Appl Phys Lett, 2004, 84: 855–857

    Article  Google Scholar 

  2. Sun Y, Yu T, Chen Z, et al. Properties of GaN-based light-emitting diode thin film chips fabricated by laser lift-off and transferred to Cu. Semicond Sci Tech, 2008, 23: 125022

    Article  Google Scholar 

  3. Huang S, Horng R, Hsu S, et al. Surface texturing for wafer-bonded vertical-type GaN/mirror/Si light-emitting diodes. Jpn J Appl Phys, 2005, 44: 3028–3031

    Article  Google Scholar 

  4. Wuu D, Hsu S, Huang S, et al. Vertical-conducting p-side-up GaN/mirror/Si light-emitting diodes by laser lift-off and wafer-transfer techniques. Phys Status Solidi (A), 2004, 201: 2699–2703

    Article  Google Scholar 

  5. Daisuke M, Masahiko S, Masashi Y, et al. High output power 365 nm ultraviolet light emitting diode of GaN-free structure. Jpn J Appl Phys, 2002, 41: 1434–1436

    Article  Google Scholar 

  6. Pittroff W, Erbert G, Beister G, et al. Mounting of high power laser diodes on boron nitride heat sinks using an optimized Au/Sn metallurgy. IEEE T Adv Pack, 2001, 24: 434–441

    Article  Google Scholar 

  7. Tew J W R, Shi X Q, Yuan S. Au/Sn solder for face-down bonding of AlGaAs/GaAs ridge waveguide laser diodes. Mater Lett, 2004, 58: 2695–2699

    Article  Google Scholar 

  8. Kim J S, Choi W S, Kim S, et al. Fluxless silicon-to-alumina bonding using electroplated Au-Sn-Au structure at eutectic composition. Mat Sci Eng A, 2007, 458: 101–107

    Article  Google Scholar 

  9. Chromik R R, Wang D N, Shugar A, et al. Mechanical properties of intermetallic compounds in the Au-Sn system. J Mater Res, 2005, 20: 2161–2172

    Article  Google Scholar 

  10. Nichia P. Light-emitting device and manufacturing method of light-emitting devices, as well as lighting fixtures (in Chinese). Japan Patent, 200410062392.0

  11. Shi X Q, Kwan H F, Nai S M L, et al. Kinetics of interface reaction and intermetallics growth of Sn-3.5Ag-0.7Cu/Au/Ni/Cu system under isothermal aging. J Mater Sci, 2004, 39: 1095

    Article  Google Scholar 

  12. Yoon S W, Choi W K, Lee H M. Calculation of surface tension and wetting properties of Sn-based solder alloys. Scripta Mater, 1999, 40: 297

    Article  Google Scholar 

  13. Goran M, Chin C L. Void-free Au-Sn eutectic bonding of GaAs dice and its characterization using scanning acoustic microscopy. J Electron Mater, 1989, 18: 327–337

    Article  Google Scholar 

  14. Lee C C, Wang C Y, Matijasevic G S. A new bonding technology using gold and tin multilayer compositestructures. IEEE T Compo, Hybrid, Man Tech, 1991, 14: 407–412

    Article  Google Scholar 

  15. Matrasevic G S, Wang C Y, Lee C C. Void free bonding of large silicon dice using gold-tin alloys. IEEE T Compo, Hybrid, Man Tech, 1990, 13: 1128–1134

    Article  Google Scholar 

  16. Peng W C, Sermon W Y C. Performance of InGaN-GaN LEDs fabricated using glue bonding on 50-mm Si substrate. IEEE Photonic Tech L, 2006, 18: 613–615

    Article  Google Scholar 

  17. Hsu S C, Pong B J, Li W H, et al. Stress relaxation in GaN by transfer bonding on Si substrates. Appl Phys Lett, 2007, 91: 251114

    Article  Google Scholar 

  18. Zhao D G, Xu S J, Xie M H, et al. Stress and its effect on optical properties of GaN epilayers grown on Si(111), 6H-SiC(0001), and c-plane sapphire. Appl Phys Lett, 2003, 83: 677–679

    Article  Google Scholar 

  19. Kozawa T, Kachi T, Kano H, et al. Thermal stress in GaN epitaxial layers grown on sapphire substrates. J Appl Phys, 1995, 77: 4389–4392

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to ZhiZhong Chen.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Tian, P., Sun, Y., Chen, Z. et al. Phase reaction of Au/Sn solder bonding for GaN-based vertical structure light emitting diodes. Sci. China Technol. Sci. 53, 301–305 (2010). https://doi.org/10.1007/s11431-010-0036-1

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11431-010-0036-1

Keyword

Navigation