Skip to main content
Log in

Critical review of guidelines against a systematic framework with regard to consistency on allocation procedures for recycling in LCA

The International Journal of Life Cycle Assessment Aims and scope Submit manuscript

Abstract

Purpose

Multifunctionality in LCA can be solved by several allocation procedures. Various official guidelines give divergent recommendations in which allocation procedure to apply, and up to now, no consensus has been reached. We aim to identify the obstacles to a consistent allocation approach that can be applied to all product categories and is supported by a broad range of stakeholders.

Methods

Based on a systematic framework for consistent allocation, developed by Schrijvers et al. (Int J Life Cycle Assess, 2016), we identify five review criteria that indicate the degree of consistency in the proposed allocation procedure of official guidelines. Several relevant guidelines, i.e. ISO 14044, ISO/TR 14049, ISO/TS 14067, the ILCD Handbook, BP X30-323-0, PAS 2050, the Greenhouse Gas Protocol, EN15804, PEF Guide and guidance documents for EPDs and PCRs, are reviewed according to these criteria.

Results and discussion

None of the investigated guidelines fully follows the systematic framework for allocation. Often, different approaches are recommended for co-products and recycled materials, although the boundary between these flows is not always clear. Many guidelines do not recognize the existence of different LCA goals; therefore, elements of attributional and consequential LCAs are often mixed. The market situation of the recycled material is not always taken into account, e.g. in the mandatory 50/50 method of the PEF Guide. The ILCD Handbook and the General Programme Instructions for the International EPD® System provide most consistent guidance. We argue that consistency does not require a one-formula-fits-all method, as this would favour some product categories and only responds to a certain LCA goal.

Conclusions and perspectives

A critical review of guidelines against a systematic framework for allocation of co-products and recycled materials shows that few guidelines propose a consistent allocation approach. The main obstacles for consistency are the different approaches for co-production and (different types of open-loop) recycling and disregarding of different LCA goals and recycled material markets. We recommend to include material specific guidance in Product Category Rules on the determination of market prices, quality determining factors and relevant material properties for different applications.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1

References

  • AFNOR (2011) BP X30-323-0—repository of good practices. French agency for the environment and energy management, Paris

    Google Scholar 

  • Allacker K, Mathieux F, Manfredi S et al (2014) Allocation solutions for secondary material production and end of life recovery: proposals for product policy initiatives. Resour Conserv Recycl 88:1–12

    Article  Google Scholar 

  • Ardente F, Mathieux F (2014) Identification and assessment of product’s measures to improve resource efficiency: the case-study of an Energy Using Product. J Clean Prod 83:126–141

    Article  CAS  Google Scholar 

  • Atherton J (2007) Life cycle management declaration by the metals industry on recycling principles. Int J Life Cycle Assess 12:59–60

    Article  Google Scholar 

  • Baumann H, Tillman A-M (2004) The Hitch Hiker’s Guide to LCA—an orientation in life cycle assessment methodology and application. Studentlitteratur, Lund, Sweden

    Google Scholar 

  • BSI (2011a) PAS 2050:2011—specification for the assessment of the life cycle greenhouse gas emissions of goods and services. BSI, London

    Google Scholar 

  • BSI (2011b) The Guide to PAS 2050:2011. London, United Kingdom

  • CEN (2012) Sustainability of construction works - Environmental product declarations - Core rules for the product category of construction products. EN 15804. Comité Européen de Normalisation, Brussels, Belgium

  • Curran M (2007) Co-product and input allocation approaches for creating life cycle inventory data: a literature review. Int J Life Cycle Assess 12:65–78

    Google Scholar 

  • De Camillis C, Brandão M, Zamagni A, Pennington D (2013) Sustainability assessment of future-oriented scenarios: a review of data modelling approaches in Life Cycle Assessment. doi: 10.2788/95227

  • Ekvall T, Finnveden G (2001) Allocation in ISO 14041—a critical review. J Clean Prod 9:197–208

    Article  Google Scholar 

  • Ekvall T, Tillman A-M (1997) Open-loop recycling: criteria for allocation procedures. Int J Life Cycle Assess 2:155–162

    Article  Google Scholar 

  • Ekvall T, Azapagic A, Finnveden G et al (2016) Attributional and consequential LCA in the ILCD handbook. Int J Life Cycle Assess 21:293–296

    Article  Google Scholar 

  • Eurofer, Eurometaux, European Aluminum Association (2013) Ferrous and non-ferrous metals comments on the PEF methodology. Brussels, Belgium. http://www.european-aluminium.eu/wp-content/uploads/2011/08/Final-Metal-position-on-PEF-clean_25042013.pdf

  • European Commission (2010) ILCD Handbook - General guide for Life Cycle Assessment - Detailed Guidance. doi: 10.2788/38479

  • European Commission (2013) Commission Recommendation of 9 April 2013 on the use of common methods to measure and communicate the life cycle environmental performance of products and organisations (2013/179/ EU). Off J Eur Union 56, 4 May 2013

  • European Commission (2014) Environmental Footprint Pilot Guidance document—Guidance for the implementation of the EU Product Environmental Footprint (PEF) during the Environmental Footprint (EF) pilot phase, v. 4.0

  • Finkbeiner M (2013) Product environmental footprint—breakthrough or breakdown for policy implementation of life cycle assessment? Int J Life Cycle Assess 19:266–271

    Article  Google Scholar 

  • Frischknecht R (2010) LCI modelling approaches applied on recycling of materials in view of environmental sustainability, risk perception and eco-efficiency. Int J Life Cycle Assess 15:666–671

    Article  CAS  Google Scholar 

  • Galatola M, Pant R (2014) Reply to the editorial “Product environmental footprint—breakthrough or breakdown for policy implementation of life cycle assessment?” written by Prof. Finkbeiner (Int J Life Cycle Assess 19(2):266–271). Int J Life Cycle Assess 1:1356–1360

    Article  Google Scholar 

  • Global Footprint Network (2009) Ecological Footprint Standards. Available at www.footprintstandards.org

  • Guinée JB (ed) (2002) Handbook on Life Cycle Assessment: Operational Guide to the ISO Standards. Springer Netherlands, Dordrecht

  • Heijungs R (2013) Ten easy lessons for good communication of LCA. Int J Life Cycle Assess 19:473–476

    Article  Google Scholar 

  • Heijungs R, Guinée JB (2007) Allocation and “what-if” scenarios in life cycle assessment of waste management systems. Waste Manag 27:997–1005. doi:10.1016/j.wasman.2007.02.013

  • ISO (2006) ISO 14044—environmental management—life cycle assessment—requirements and guidelines. The International Organization for Standardization (ISO), Geneva

    Google Scholar 

  • ISO (2010) ISO 14025—type III environmental declarations—principles and procedures. The International Organization for Standardization (ISO), Geneva

    Google Scholar 

  • ISO (2012) ISO/TR 14049: Environmental management—life cycle assessment—illustrative examples on how to apply IS0 14044 to goal and scope definition and inventory analysis. The International Organization for Standardization (ISO), Geneva

    Google Scholar 

  • ISO (2013) ISO/TS 14067—Greenhouse gases—carbon footprint of products—requirements and guidelines for quantification and communication. The International Organization for Standardization (ISO), Geneva

    Google Scholar 

  • Ligthart TN, Ansems TAMM (2012) Modelling of recycling in LCA, Post-consumer waste recycling and optimal production, Prof. Enri Damanhuri (Ed.), ISBN: 978-953-51-0632-6, InTech, Available from: http://www.intechopen.com/books/post-consumer-waste-recycling-and-optimal-production/modelling-of-recycling-in-lca

  • Majeau-Bettez G, Wood R, Strømman AH (2014) Unified theory of allocations and constructs in life cycle assessment and input–output analysis. J Ind Ecol 18:747–770

    Article  CAS  Google Scholar 

  • Manfredi S, Allacker K, Pelletier N et al (2015) Comparing the European Commission product environmental footprint method with other environmental accounting methods. Int J Life Cycle Assess 20:389–404

  • National Council for Air and Stream Improvement Inc. (NCASI) (2012) Methods for open-loop recycling allocation in life cycle assessment and carbon footprint studies of paper products. Technical Bulletin No. 1003. Research Triangle Park, N.C.: National Council for Air and Stream Improvement, Inc.

  • Neugebauer S, Finkbeiner M (2012) The Multi-Recycling-Approach as a new option to deal with the end-of-life allocation dilemma. In: LCA-Center. http://lcacenter.org/lcaxii/final-presentations/603.pdf. Accessed 17 Feb 2015

  • Pelletier N, Allacker K, Pant R, Manfredi S (2013) The European Commission Organisation Environmental Footprint method: comparison with other methods, and rationales for key requirements. Int J Life Cycle Assess 19:387–404

    Article  Google Scholar 

  • Plastics Recyclers Europe (2012) How to boost plastics recycling and increase resource efficiency? Brussels, Belgium. http://www.plasticsrecyclers.eu/sites/default/files/EuPR%20Strategy%20Paper%202012_0.pdf

  • Schrijvers DL, Loubet P, Sonnemann G (2016) Developing a systematic framework for consistent allocation in LCA. Int J Life Cycle Assess. doi:10.1007/s11367-016-1063-3

  • Suh S, Yang Y (2014) On the uncanny capabilities of consequential LCA. Int J Life Cycle Assess 19:1179–1184

    Article  Google Scholar 

  • Suh S, Weidema B, Schmidt JH, Heijungs R (2010) Generalized make and use framework for allocation in life cycle assessment. J Ind Ecol 14:335–353

    Article  Google Scholar 

  • The International EPD® System (2013) General programme instructions for the International EPD® system 2.01.

  • The Product Category Rule Guidance Development Initiative (2013) Guidance for Product Category Rule Development, Version 1. http://www.pcrguidance.org

  • Tillman A-M (2000) Significance of decision-making for LCA methodology. Environ Impact Assess Rev 20:113–123

    Article  Google Scholar 

  • UNEP/SETAC Life Cycle Initiative (2011) Global Guidance Principles for Life Cycle Assessment Databases—a basis for greener processes and products. UNEP/ SETAC Life Cycle Initiative, United Nations Environment Programme, Paris. http://www.unep.org/pdf/Global-Guidance-Principles-for-LCA.pdf

  • Weidema BP (2001) Avoiding Co-Product Allocation in Life-Cycle Assessment. J Ind Ecol 4:11–33

  • Weidema BP (2003) Market information in life cycle assessment. Copenhagen: Danish Environmental Protection Agency. (Environmental Project no. 863). http://www2.mst.dk/Udgiv/publications/2003/87-7972-991-6/pdf/87-7972-992-4.pdf

  • Weidema BP (2013) Guide to interpret the EU Product Environmental Footprint (PEF) Guide. 2.-0 LCA consultants, Aalborg

  • Weidema B (2014a) ISO system expansion = substitution. In: 2.0 LCA Consult. http://lca-net.com/blog/2014/09/. Accessed 10 Oct 2015

  • Weidema B (2014b) Has ISO 14040/44 Failed its role as a standard for life cycle assessment? J Ind Ecol 18:324–326

    Article  Google Scholar 

  • WRI, WBCSD (2011) Greenhouse Gas Protocol Product Life Cycle Accounting and Reporting Standard. World Resources Institute (WRI) and World Business Council for Sustainable Development (WBCSD), USA

    Google Scholar 

  • Zamagni A, Buttol P, Porta PL et al (2008) Critical review of the current research needs and limitations related to ISO-LCA practice—Deliverable D7 of work package 5 of the CALCAS project. ENEA, Italy

    Google Scholar 

Download references

Acknowledgments

We thank Solvay and the French National Association for Technical Research (CIFRE Convention No. 2013/1146) for the funding of the Ph.D. study of the first author and for their contributions to this paper. Furthermore, we thank Bo Weidema and the two anonymous reviewers for their useful and important feedback, which has greatly improved the quality of the paper.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Guido Sonnemann.

Ethics declarations

Conflict of interest

The authors declare that they have no conflict of interest.

Additional information

Responsible editor: Mary Ann Curran

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Schrijvers, D.L., Loubet, P. & Sonnemann, G. Critical review of guidelines against a systematic framework with regard to consistency on allocation procedures for recycling in LCA. Int J Life Cycle Assess 21, 994–1008 (2016). https://doi.org/10.1007/s11367-016-1069-x

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11367-016-1069-x

Keywords

Navigation