Skip to main content

Advertisement

Log in

Emission profiling of CI engine fueled with neem and wintergreen oil blend with hexanol and octanol manifold injection

  • Resource Recovery from Wastewater, Solid Waste and Waste Gas: Engineering and Management Aspects
  • Published:
Environmental Science and Pollution Research Aims and scope Submit manuscript

Abstract

The present work details the effects of injection of higher order alcohols, namely hexanol (Hex) and octanol (Oct) as secondary fuels in a CI engine. The last decade has seen an exponential increase in the carbon emission chief of which have been contributed by fossil fuels. Vegetable oils provide a viable alternative to the current scenario as they can be synthesized easily from nature and can be readily adapted for use in CI engines. Neem oil (NO) is non-edible and widely available and hence taken as a base fuel for this research. The poor properties of neem oil were improved by the addition of novel low viscous biofuel, namely wintergreen oil (WGO). During the course of this research work, a blend containing a mixture of 50% of neat neem oil and 50% of wintergreen oil (NO50-WGO50) was optimized based on trial tests and taken as pilot fuel while Hex and Oct were injected along with intake air as secondary fuels. The alcohols were injected into the engine successively in the 10%, 20%, and 30% (by mass) ratios. Experiments were conducted in a single-cylinder CI engine fabricating 5.2-kW power at a constant speed of 1500 rpm at varying load conditions. It is observed that inferior performance of NO led to more smoke, HC, and CO in comparison to diesel at all the loads and these are improved with NO50-WGO50 blend. Nevertheless, a minor increase in NOx emission was perceived with the blend. Addition of higher order alcohol promoted reduction of both NOx and smoke emission without affecting performance. Among the various combinations, NO50-WGO50 + Hex30 and Oct30 reduced NOx emission by 12% and 9.5% and smoke emission by 13% and 19% respectively. These results are on par with the diesel performance and emission characteristics.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10

Similar content being viewed by others

References

  • Agarwal AK, Agarwal D (2009) Novel methodology to utilise neem (Azadirachta Indica) oil in a direct injection compression ignition engine: performance and emissions characterization (No. 2009-28-0039). SAE Technical Paper

  • Ashok B, Raj RTK, Nanthagopal K, Krishnan R, Subbarao R (2017) Lemon peel oil–a novel renewable alternative energy source for diesel engine. Energy Convers Manag 139:110–121

    Article  CAS  Google Scholar 

  • Bicer Y, Dincer I (2018) Life cycle environmental impact assessments and comparisons of alternative fuels for clean vehicles. Resour Conserv Recycl 132:141–157

    Article  Google Scholar 

  • Damodharan D, Gopal K, Sathiyagnanam AP, Rajesh Kumar B, Depoures MV, Mukilarasan N (2019) Performance and emission study of a single cylinder diesel engine fuelled with n-octanol/WPO with some modifications. Int J Ambient Energy 1–10

  • Damodharan D, Sathiyagnanam AP, Rana D, Saravanan S, Kumar BR, Sethuramasamyraja B (2018) Effective utilization of waste plastic oil in a direct injection diesel engine using high carbon alcohols as oxygenated additives for cleaner emissions. Energy Convers Manag 166:81–97

    Article  CAS  Google Scholar 

  • Damodharan D, Sathiyagnanam AP, Rana D, Kumar BR, Saravanan S (2017) Extraction and characterization of waste plastic oil (WPO) with the effect of n-butanol addition on the performance and emissions of a DI diesel engine fueled with WPO/diesel blends. Energy Convers Manag 131:117–126

    Article  CAS  Google Scholar 

  • De Poures MV, Sathiyagnanam AP, Rana D, Kumar BR, Saravanan S (2017) 1-Hexanol as a sustainable biofuel in DI diesel engines and its effect on combustion and emissions under the influence of injection timing and exhaust gas recirculation (EGR). Appl Therm Eng 113:1505–1513

    Article  Google Scholar 

  • Devan PK, Mahalakshmi NV (2009) A study of the performance, emission and combustion characteristics of a compression ignition engine using methyl ester of paradise oil–eucalyptus oil blends. Appl Energy 86(5):675–680

    Article  CAS  Google Scholar 

  • Devarajan Y, Munuswamy DB, Nagappan B, Pandian AK (2018) Performance, combustion and emission analysis of mustard oil biodiesel and octanol blends in diesel engine. Heat Mass Transf 54(6):1803–1811

    Article  CAS  Google Scholar 

  • Dhanasekaran R, Krishnamoorthy V, Rana D, Saravanan S, Nagendran A, Kumar BR (2017) A sustainable and eco-friendly fueling approach for direct-injection diesel engines using restaurant yellow grease and n-pentanol in blends with diesel fuel. Fuel 193:419–431

    Article  CAS  Google Scholar 

  • Dillikannan D, De Poures MV, Kaliyaperumal G, Babu RK (2019) Effective utilization of waste plastic oil/n-hexanol in an off-road, unmodified DI diesel engine and evaluating its performance, emission, and combustion characteristics. ENERG SOURCE PART A: Recovery, Utilization, and Environmental Effects, 1-16

  • Edrisi SA, Abhilash PC (2016) Exploring marginal and degraded lands for biomass and bioenergy production: an Indian scenario. Renew Sust Energ Rev 54:1537–1551

    Article  Google Scholar 

  • Gopal K, Sathiyagnanam AP, Kumar BR, Saravanan S, Rana D, Sethuramasamyraja B (2018) Prediction of emissions and performance of a diesel engine fueled with n-octanol/diesel blends using response surface methodology. J Clean Prod 184:423–439

    Article  CAS  Google Scholar 

  • Jayaprabakar J, Anish M, Beemkumar N, Mathew A, Alex George A (2019) Effect of diethyl ether blended with neem oil methyl esters in CI engine. Int J Ambient Energy 40(2):116–118

    Article  CAS  Google Scholar 

  • Kasiraman G, Geo VE, Nagalingam B (2016) Assessment of cashew nut shell oil as an alternate fuel for CI (Compression ignition) engines. Energy 101:402–410

    Article  CAS  Google Scholar 

  • Krishnamoorthy V, Dhanasekaran R, Rana D, Saravanan S, Kumar BR (2018) A comparative assessment of ternary blends of three bio-alcohols with waste cooking oil and diesel for optimum emissions and performance in a CI engine using response surface methodology. Energy Convers Manag 156:337–357

    Article  CAS  Google Scholar 

  • Kumar BR, Saravanan S, Rana D, Anish V, Nagendran A (2016a) Effect of a sustainable biofuel–n-octanol–on the combustion, performance and emissions of a DI diesel engine under naturally aspirated and exhaust gas recirculation (EGR) modes. Energy Convers Manag 118:275–286

    Article  Google Scholar 

  • Kumar BR, Saravanan S (2016) Use of higher alcohol biofuels in diesel engines: a review. Renew Sust Energ Rev 60:84–115

    Article  Google Scholar 

  • Kumar BR, Saravanan S, Rana D, Nagendran A (2016b) A comparative analysis on combustion and emissions of some next generation higher-alcohol/diesel blends in a direct-injection diesel engine. Energy Convers Manag 119:246–256

    Article  Google Scholar 

  • Maneerung T, Kawi S, Dai Y, Wang CH (2016) Sustainable biodiesel production via transesterification of waste cooking oil by using CaO catalysts prepared from chicken manure. Energy Convers Manag 123:487–497

    Article  CAS  Google Scholar 

  • Pandey RK, Rehman A, Sarviya RM (2012) Impact of alternative fuel properties on fuel spray behavior and atomization. Renew Sust Energ Rev 16(3):1762–1778

    Article  CAS  Google Scholar 

  • Pandian AK, Munuswamy DB, Radhakrishanan S, Devarajan Y, Ramakrishnan RBB, Nagappan B (2018) Emission and performance analysis of a diesel engine burning cashew nut shell oil bio diesel mixed with hexanol. Pet Sci 15(1):176–184

    Article  CAS  Google Scholar 

  • Patel A, Arora N, Mehtani J, Pruthi V, Pruthi PA (2017) Assessment of fuel properties on the basis of fatty acid profiles of oleaginous yeast for potential biodiesel production. Renew Sust Energ Rev 77:604–616

    Article  CAS  Google Scholar 

  • Raj VM, Subramanian LG, Thiyagarajan S, Geo VE (2018) Effects of minor addition of aliphatic (1-pentanol) and aromatic (benzyl alcohol) alcohols in Simarouba Glauca-diesel blend fuelled CI engine. Fuel 234:934–943

    Article  Google Scholar 

  • Senthil R, Sivakumar E, Silambarasan R (2015) Effect of di ethyl ether on the performance and emission characteristics of a diesel engine using biodiesel–eucalyptus oil blends. RSC Adv 5(67):54019–54027

    Article  CAS  Google Scholar 

  • Subramanian T, Varuvel EG, Ganapathy S, Vedharaj S, Vallinayagam R (2018) Role of fuel additives on reduction of NO X emission from a diesel engine powered by camphor oil biofuel. Environ Sci Pollut Res 25(16):15368–15377

    Article  CAS  Google Scholar 

  • Subramanian T, Varuvel EG, Martin LJ, Beddhannan N (2017) Effect of lower and higher alcohol fuel synergies in biofuel blends and exhaust treatment system on emissions from CI engine. Environ Sci Pollut Res 24(32):25103–25113

    Article  CAS  Google Scholar 

  • Suhaimi H, Adam A, Mrwan AG, Abdullah Z, Othman MF, Kamaruzzaman MK, Hagos FY (2018) Analysis of combustion characteristics, engine performances and emissions of long-chain alcohol-diesel fuel blends. Fuel 220:682–691

    Article  CAS  Google Scholar 

  • Thiyagarajan S, Varuvel EG, Martin LJ, Beddhannan N (2019) Mitigation of carbon footprints through a blend of biofuels and oxygenates, combined with post-combustion capture system in a single cylinder CI engine. Renew Energy 130:1067–1081

    Article  CAS  Google Scholar 

  • Thiyagarajan S, Geo VE, Martin LJ, Nagalingam B (2017) Selective non-catalytic reduction (SNCR) of CO 2 and NO emissions from a single-cylinder CI engine using chemical absorbents. Emission Control Science and Technology 3(3):233–242

    Article  CAS  Google Scholar 

  • Vallinayagam R, Vedharaj S, Yang WM, Roberts WL, Dibble RW (2015) Feasibility of using less viscous and lower cetane (LVLC) fuels in a diesel engine: a review. Renew Sust Energ Rev 51:1166–1190

    Article  CAS  Google Scholar 

  • Vallinayagam R, Vedharaj S, Yang WM, Lee PS, Chua KJE, Chou SK (2014) Pine oil–biodiesel blends: a double biofuel strategy to completely eliminate the use of diesel in a diesel engine. Appl Energy 130:466–473

    Article  CAS  Google Scholar 

  • Varuvel EG, Subramanian T, Khatri P (2017) Effect of diglyme addition on performance and emission characteristics of hybrid minor vegetable oil blends (rubber seed and babassu oil) in a tractor engine–an experimental study. Biofuels, 1-9

  • Yasin MM, Yusaf T, Mamat R, Yusop AF (2014) Characterization of a diesel engine operating with a small proportion of methanol as a fuel additive in biodiesel blend. Appl Energy 114:865–873

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Thiyagarajan Subramanian.

Additional information

Responsible editor: Philippe Garrigues

Publisher’s note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Swaminathan, S., Subramanian, T., Martin, L.J. et al. Emission profiling of CI engine fueled with neem and wintergreen oil blend with hexanol and octanol manifold injection. Environ Sci Pollut Res 27, 17505–17515 (2020). https://doi.org/10.1007/s11356-019-05690-1

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11356-019-05690-1

Keywords

Navigation