Skip to main content
Log in

Preparation and study of a new type of Fe–C microelectrolysis filler in oil-bearing ballast water treatment

  • Research Article
  • Published:
Environmental Science and Pollution Research Aims and scope Submit manuscript

Abstract

In the transportation of petroleum, large amount of oil polluted water will be produced, and the oil polluted water pumping into ocean will destroy ocean environment. To address oil-bearing ballast water, we fabricated a novel type of Fe–C microelectrolysis filler by using magnet powder, coconut shell biochar powder, bentonite, ammonium oxalate, and nickel powder. The COD and oil content removal efficiencies of 100 g/L oily wastewater were approximately 79.82% and 91.68%, respectively, after 100 min treatment at the following conditions: Fe–C mass ratio, 5:1; bentonite content, 20%; calcination temperature, 900 °C; calcination time, 2 h; ammonium oxalate content, 1.5%; and amount of nickel addition, 6.78%. The characteristics of the Fe–C microelectrolysis filler were analyzed. The surface structure of the filler was loose and porous, and its pores were developed. The Brunauer–Emmett–Teller (BET) surface area reached 49.4667 m2 g−1. A microelectrolysis filler is mainly mesoporous and contains large pores. Its average pore size is 2.6942 nm. Meanwhile, the results of our XRD analysis showed that some fillers were metal oxides, and most of them were simple metal substances.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9

Similar content being viewed by others

References

Download references

Funding

This research was founded by the National Natural Science Foundation of China (41506126, U1809214), Zhejiang public welfare Technology Application Research Project (2016C33054), and Science and Technology Plan Project of Zhou Shan City (2018C21012).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Qingguo Chen.

Additional information

Responsible editor: Philippe Garrigues

Publisher’s note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Kang, M., Chen, Q., Li, J. et al. Preparation and study of a new type of Fe–C microelectrolysis filler in oil-bearing ballast water treatment. Environ Sci Pollut Res 26, 10673–10684 (2019). https://doi.org/10.1007/s11356-019-04480-z

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11356-019-04480-z

Keywords

Navigation