Skip to main content
Log in

Development of a versatile experimental setup for the evaluation of the photocatalytic properties of construction materials under realistic outdoor conditions

  • Photocatalysis: new highlights from JEP 2013
  • Published:
Environmental Science and Pollution Research Aims and scope Submit manuscript


The interest on outdoor photocatalytic materials is growing in the last years. Nevertheless, most of the experimental devices designed for the assessment of their performance operate at controlled laboratory conditions, i.e., pollutant concentration, temperature, UV irradiation, and water vapor contents, far from those of real outdoor environments. The aim of the present study was the design and development of an experimental device for the continuous test of photocatalytic outdoor materials under sun irradiation using real outdoor air as feed, with the concomitant fluctuation of pollutant concentration, temperature, and water vapor content. A three-port measurement system based on two UV-transparent chambers was designed and built. A test chamber contained the photoactive element and a reference chamber to place the substrate without the photoactive element were employed. The third sampling point, placed outdoors, allowed the characterization of the surrounding air, which feeds the test chambers. Temperature, relative humidity (RH), and UV-A irradiance were monitored at each sampling point with specific sensors. NO x concentration was measured by a chemiluminescence NO x analyzer. Three automatic valves allowed the consecutive analysis of the concentration at the three points at fixed time intervals. The reliability of the analytical system was demonstrated by comparing the NO x concentration data with those obtained at the nearest weather station to the experimental device location. The use of a chamber-based reaction system leads to an attenuation of NO x and atmospheric parameter profiles, but maintaining the general trends. The air characterization results showed the wide operating window under which the photoactive materials should work outdoors, depending on the traffic intensity and the season, which are reproduced inside the test chambers. The designed system allows the measurement of the photoactivity of outdoor materials or the comparison of several samples at the same time. The suitability of the system for the evaluation of the DeNO x properties of construction elements at realistic outdoor conditions was demonstrated. The designed experimental device can be used 24/7 for testing materials under real fluctuations of NO x concentration, temperature, UV irradiation, and relative humidity and the presence of other outdoor air pollutants such as VOCs, SO x , or NH3. The chamber-based design allows comparing a photocatalytic material with respect to a reference substrate without the photoactive phase, or even the comparison of several outdoor elements at the same time.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7

Similar content being viewed by others


  • Ballari MM, Hunger M, Husken G, Brouwers HJH (2010) Modelling and experimental study of the NOx photocatalytic degradation employing concrete pavement with titanium dioxide. Catal Today 151(1–2):71–76

    Article  CAS  Google Scholar 

  • Ballari MM, Brouwers HJH (2013) Full scale demonstration of air-purifying pavement. J Hazard Mater 254–255:406–414

    Article  Google Scholar 

  • Cámara R (2012) Immobilization of TiO2 on transparent organic polymers in the UV-a for the photocatalytic elimination trichloroethylene in air. PhD Thesis, Universidad Politécnica de Madrid.

  • Cámara R, Crespo L, Portela R, Suárez S, Bautista L, Gutiérrez-Martin F, Sánchez B (2013) Enhanced photocatalytic activity of TiO2 thin films on plasma-pretreated organic polymers. Catal Today doi:10.1016/j.cattod.2013.10.049

  • Changgeng C (2008) Double-chamber type nano photocatalytic air purifier: CN2809481

  • Chen J, Poon CS (2009) Photocatalytic construction and building materials: from fundamentals to applications. Build Environ 44(9):1899–1906

    Article  Google Scholar 

  • Chen M, Chu JW (2011) NOx photocatalytic degradation on active concrete road surface—from experiment to real-scale application. J Clean Prod 19(11):1266–1272

    Article  CAS  Google Scholar 

  • Dalton JS, Janes PA, Jones NG, Nicholson JA, Hallam KR, Allen GC (2002) Photocatalytic oxidation of NOx gases using TiO2: a surface spectroscopic approach. Environ Pollut 120(2):415–422

    Article  CAS  Google Scholar 

  • de Melo JVS, Trichês G, Gleize PJP, Villena J (2012) Development and evaluation of the efficiency of photocatalytic pavement blocks in the laboratory and after one year in the field. Constr Build Mater 37:310–319

    Article  Google Scholar 

  • Dillert R, Stötzner J, Engel A, Bahnemann DW (2012) Influence of inlet concentration and light intensity on the photocatalytic oxidation of nitrogen(II) oxide at the surface of Aeroxide® TiO2 P25. J Hazard Mater 211–212:240–246

    Article  Google Scholar 

  • EC Directive (2008) Directive 2008/50/EC of the European Parliament and of the Council of 21 May 2008 on ambient air quality and cleaner air for Europe

  • Fresno F, Portela P, Suárez S, Coronado JM (2014) Photocatalytic materials: recent achievements and near future trends. J Mater Chem A 2:2863–2884

    Article  CAS  Google Scholar 

  • Fujishima A, Zhang X, Tryk DA (2008) TiO2 photocatalysis and related surface phenomena. Surf Sci Rep 63(12):515–582

    Article  CAS  Google Scholar 

  • Guerrini GL (2012) Photocatalytic performances in a city tunnel in Rome: NOx monitoring results. Constr Build Mater 27(1):165–175

    Article  Google Scholar 

  • Hossain MM, Raupp GB, Tempe A, Hay SO, Obee TN (1999) Three-dimensional developing flow model for photocatalytic monolith reactors. AIChE J 45(6):1309–1321

    Article  CAS  Google Scholar 

  • Hüsken G, Hunger M, Brouwers HJH (2009) Experimental study of photocatalytic concrete products for air purification. Build Environ 44:2463–2474.

    Google Scholar 

  • ISO22197-1 (2007) Fine ceramics (advanced ceramics, advanced technical ceramics)—test method for air purification performance of semiconducting photocatalytic materials—part 1: removal of nitric oxide. First edition

  • Kartheuser B, Costarramone N, Pigot T, Lacombe S (2012) NORMACAT project: normalized closed chamber tests for evaluation of photocatalytic VOC treatment in indoor air and formaldehyde determination. Environ Sci Pollut R 19(9):3763–3771

    Article  CAS  Google Scholar 

  • Lasek J, Yu Y-H, Wu JCS (2013) Removal of NOx by photocatalytic processes. J Photoch Photobio C 14:29–52

    Article  CAS  Google Scholar 

  • Lee J, Mahendra S, Alvarez PJJ (2010) Nanomaterials in the construction industry: a review of their applications and environmental health and safety considerations. ACS Nano 4(7):3580–3590

    Article  CAS  Google Scholar 

  • Maggos T, Bartzis JG, Liakou M, Gobin C (2007) Photocatalytic degradation of NOx gases using TiO2-containing paint: a real scale study. J Hazard Mater 146(3):668–673

    Article  CAS  Google Scholar 

  • Pacheco-Torgal F, Jalali S (2011) Nanotechnology: advantages and drawbacks in the field of construction and building materials. Constr Build Mater 25(2):582–590

    Article  Google Scholar 

  • Ming F, Jiawei F (2010) High-efficient photocatalytic air reactor: CN201423037

  • Hui YY, Chi Sheng WJ, Ping TD, Ji HH, Chi CT, Wei LT (2008) Optical fiber photocatalytic reactor and process for the decomposition of nitric oxide using said reactor: US2008308405A1

  • Paz Y (2010) Application of TiO2 photocatalysis for air treatment: patents’ overview. Appl Catal B 99(3–4):448–460

    Article  CAS  Google Scholar 

  • Ruot B, Plassais A, Olive F, Guillot L, Bonafous L (2009) TiO2-containing cement pastes and mortars: measurements of the photocatalytic efficiency using a rhodamine B-based colourimetric test. Sol Energy 83(10):1794–1801

    Article  CAS  Google Scholar 

  • Sánchez B, Cardona AI, Romero M, Avila P, Bahamonde A (1999) Influence of temperature on gas-phase photo-assisted mineralization of TCE using tubular and monolithic catalysts. Catal Today 54:369–377

    Article  Google Scholar 

  • Sánchez B, Suárez S, Hernández-Alonso MD, Portela R (2013) Sistema de ensayo de eficiencia fotocatalítica: ES1087480 U

  • Strini A, Cassese S, Schiavi L (2005) Measurement of benzene, toluene, ethylbenzene and o-xylene gas phase photodegradation by titanium dioxide dispersed in cementitious materials using a mixed flow reactor. Appl Catal B 61:90–97

    Article  CAS  Google Scholar 

  • Shunichi A (2007) Photocatalyst activity evaluation device: JP2007298328

  • Suárez S, Hernandez-Alonso, MD, Peset J, Sánchez B. Conference (2012) Evaluation of the photocatalytic performance of construction materials for atmospheric depollution at laboratory scale. SPEA7 P64, p. 68

  • Suárez S (2013) Immobilized photocatalysts. In: Coronado JM, Fresno F, Hernández-Alonso MD, Portela R (eds) Design of advanced photocatalytic materials for energy conversion and environmental applications. Springer, London, pp 245–267

    Chapter  Google Scholar 

  • Velayos M, Pozo García JL, Pozo García FJ (2009) Autonomous air quality controller device using a multifunctional chemisorbent-photocatalytic material: ES2289850

Download references


The authors would like to acknowledge the Centre for Industrial Technological Development (CDTI) and the Spanish Ministry of Science and Technology (CMT 2011-25093, Ramón y Cajal and Juan de la Cierva Program) for the financial support. The authors would like to thank Mr. Raul Matesanz for his help with the experimental setup.

Author information

Authors and Affiliations


Corresponding author

Correspondence to B. Sánchez.

Additional information

Responsible editor: Philippe Garrigues

Rights and permissions

Reprints and permissions

About this article

Cite this article

Suárez, S., Portela, R., Hernández-Alonso, M.D. et al. Development of a versatile experimental setup for the evaluation of the photocatalytic properties of construction materials under realistic outdoor conditions. Environ Sci Pollut Res 21, 11208–11217 (2014).

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: